MST-F304B Remote Control

MOSITOECO MST-F304B Remote Control ユーザーマニュアル

  • MST-F304Bリモコン付きシーリングファンの取扱説明書の内容を読み込みました。このデバイスの機能、使用方法、トラブルシューティングなど、ご質問にお答えできます。例えば、ファンの速度調整方法、タイマー設定方法、ナイトライトモードの使い方などについてご質問ください。
  • ファンのオン/オフはどうすればいいですか?
    ナイトライトモードとは何ですか?
    防犯モードの機能は?
    色温度はどうやって変えますか?
    タイマー機能はどうやって使いますか?
MST-F304B Remote control operation instruction
As shown in the figure:
1button: Press this key to turn on or off the fan
21 -3Number button: Gear 1-3 is the fan/motor speed button, gear 1 is the lowest speed,
gear 3 is the highest speed
3Night lamp button: Press this key for the night light mode, and the lamp power is
directly reduced to the minimum
4anti-theft model button: Press this key for anti-theft mode, turn off the fan, turn on
the light, and turn on the light for 5 minutes every 2 hours
5Natural wind button: Press this key for natural wind, and the fan rotates from the
current gear to the first gear
6CCT button: Short press this key to change the color temperature from
2700/3000/4500/5700/6500K, long press this key to change the color temperature from
6500->2700K or 2700K->6500K
7LED ON/OFF button: Press this key to turn the light on and off
8DIM button: Long press this key to adjust the brightness, long press the brightness
downward or upward adjustment, until adjusted to the highest or lowest brightness, to the target
brightness release will stop adjusting the brightness
91H2H4HIs the timed shutdown key, press this key, 1H/2H/4H later turn off the motor
10Blue lightPress any key of the remote control, the indicator light will light up, and the
remote control will issue instructions
Restore electrical power.Within 30 seconds of restoring electrical power, press and hold
the “ ”button on the remote controtransmitterfor 5seconds or until ight on the fan
blinkstwiceUsethe remote control transmitter to test the liaht and fan functions to confirm
the learning process is complete.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment
The devices has been evaluated to meet general RF exposure requirement the device can be used in portable exposure
condition without restriction
/