Setting up and connecting the appliance MaCave
16
7 Setting up and connecting the
appliance
7.1 Notes on setting up the appliance
All appliances can be installed on a free-standing basis.
When selecting the location, observe the following instructions:
•
The ambient temperature should be in the range specified for your country in the
supplementary “Country versions” booklet. Otherwise, it could mean that the
inner temperature you set cannot be reached or maintained. This could also be
the case if there are extreme fluctuations in the ambient temperature
•
The appliance should stand in the coldest part of the room, away from heat
sources (ovens, heating devices or radiators).
•
The location must not be damp or wet.
•
The appliance must not be exposed to direct sunlight. This can damage the
acrylic coating and lead to higher power consumption.
•
The ground must be level and sufficiently stable to bear the appliance at full
capacity.
•
The appliance must be sufficiently ventilated. The ventilation slots on the front of
the appliance must not be obstructed.
•
Note the information on the electrical connection, see chapter “Information on
electrical connection” on page 18.
•
Remove all the inner and outer packaging materials before setting up.
•
Make sure the appliance is level by adjusting the feet.
7.2 Notes on installing the appliance
A
NOTICE!
•
Ensure that the ventilation slots remain clear during the installation.
Obstructed ventilation slots lead to increased power consumption
and can damage the appliance.
•
Waste heat produced by the appliance must be extracted via a ven-
tilation shaft on the rear.
•
The ventilation shaft must have cross-section of at least 200 cm
2
.
•
Ensure that the power cable is not jammed when pushing the appli-
ance into place.
MaCave-S16F-S40FGD-S117FG-O-EN-ZH.book Seite 16 Donnerstag, 28. März 2019 8:30 08