English
20
CORDLESS DRIVER DRILL SAFETY WARNINGS
1. Hold power tool by insulated gripping surfaces, when performing an operation
where the cutting accessory or fastener may contact hidden wiring.
Cutting accessory and fasteners contacting a “live” wire may make exposed metal parts of
the power tool “live” and could give the operator an electric shock.
ADDITIONAL SAFETY WARNINGS
1. Make sure that the area to be drilled is absolutely free of any hidden obstructions
including electrical wiring, water, or gas pipes. Drilling into the aforementioned
may result in electric shock or short circuit, gas leak or other hazards that can
cause serious accidents or injuries.
2. Make sure to securely hold the tool during operation. Failure to do so can result in
accidents or injuries.
3. Secure the workpiece. A workpiece clamped with clamping devices or vice is held
more secure than by hand.
4. Setting up and checking the work environment. Check if the work environment is
suitable by following the precaution.
5. Do not allow foreign matter to enter the hole for connecting the battery.
6. Never disassemble the battery and charger.
7. Never short-circuit the battery. Shortcircuiting the battery will cause a great electric
current and overheat. It results in burn or damage to the battery.
8. Do not dispose of the battery in fi re. If the battery is burnt, it may explode.
9. Bring the battery to the shop from which it was purchased as soon as the post-
charging battery life becomes too short for practical use. Do not dispose of the
exhausted battery.
10. Do not insert object into the air ventilation slots of the charger. Inserting metal
objects or infl ammables into the charger air ventilation slots will result in electrical
shock hazard or damaged charger.
11. The motor may stop in the event the tool is overloaded. In this should occur,
release the tool’s switch and eliminate the cause of the overload.
12. The use of the battery in a cold condition (below 0 degree Centigrade) can
sometimes result in the weakened tightening torque and reduced amount of
work. This, however, is a temporary phenomenon, and returns to normal when the
battery warms up.
13. To prevent the battery power consumption caused by forgetting to turn off the LED
light, the light goes off automatically in about 15 minutes.
CAUTION ON LITHIUM-ION BATTERY
To extend the lifetime, the lithium-ion battery equips with the protection function to stop
the output.
In the cases of 1 to 3 described below, when using this product, even if you are pulling the
switch, the motor may stop. This is not the trouble but the result of protection function.