Mackie Control Mode MC Assignment
9~14 VPOT
15 16
X-TOUCH COMPACT RX MIDI DATAX-TOUCH COMPACT MIDI MAP
This RX MIDI data table shows what can get controlled and changed from outside (via MIDI receive) independent of the X-TOUCH editorsoftware.
Function RX CH RX Command RX Value
Operation Mode Select GLOBAL CH CC 127 0 = Standard Mode, MC Mode LED o
1 = MC Mode, MC Mode LED on
2-127 = ignored
Preset Layer Change GLOBAL CH Program Change ONLY in Standard Mode (see above):
0 = Layer A, A-button LED on
1 = Layer B, B-button LED on
2-127 = ignored
Fader Movement GLOBAL CH CC 1 – CC 9 0-127 = Fader position, bottom to top
LED Ring Behavior
Change
GLOBAL CH Encoders 1-8:
CC 10 – CC 17
Encoders 9-16:
CC 18 – CC 25
0 = Single
1 = Pan
2 = Fan
3 = Spread
4 = Trim
5-127 = ignored
LED Ring Remote
Control (Value Change)
GLOBAL CH Encoders 1-8:
CC 26 – CC 33
Encoders 9-16:
CC 34 – CC 41
0 = all LEDs o
1-13 = LEDs 1 (left) – 13 (right) on
14-26 = LEDs 1 (left) – 13 (right) blinking
27 = all LEDs on
28 = all LEDs blinking
29-127 = ignored
Buttons LED Remote
Control
GLOBAL CH Upper Top Row 1-8:
Note 0 – Note 7
Upper Mid Row 9-16:
Note 8 – Note 15
Upper Bottom Row 17-24:
Note 16 – Note 23
Lower Row 25-33:
Note 24 – Note 32
Right Area 34-39:
Note 33 – Note 38
Layer A, B LEDs:
Not assignable; only 1 of 2 LEDs
lights if Standard mode selected
(see above “Preset Layer Change”)
Note o or Note on with Velocity 0: Button LED o
Note on with Velocity 1: Button LED on
Note on with Velocity 2: Button LED blinking
Note on with Velocity 3-127: ignored
Status LEDs Remote
Control
GLOBAL CH Foot Switch LED: CC 42
Exp. Pedal LED: CC 43
MC Mode LED:
Not assignable; lights
only if MC mode selected
(see above “Operation Mode
Select”)
USB LED:
Not assignable; always
active if valid connection
to computer available
MIDI I/O LEDs:
Not assignable; always
active while data transfer
For Foot Switch:
0-63 = LED o
64-127 = LED on
For Expression Pedal:
LED only on while data transfer (value change)
