Note
2020.10
Printed in Japan
©2016 Magnescale Co., Ltd.
2-A02-321-0B
A connector of this product is using waterproof connector
corresponding to SPEEDCON made of PHOENIX
CONTACT. When connecting the connector, be sure to
check following instruction. Failure to do so waterproof
function falls remarkably.
Set marking position (Machine side – black print, Tools
setter side – projection portion) of both connectors in
alignment and put in until the faces.
Rotate the threaded section 180 degrees.
Note
readed section will further turned when a force is
applied, but please stop at 180 degrees.
Do not use pliers or any tools, please rotate the threaded
by hand.
When the machine side connector is traditional M12
type, please use torque driver and tighten at 0.4 N m.
Machine side Tool setter side
/