Whenyouusethevacuumcleanertovacuumashes,nesand,lime,cementdustandsimilar
substances, the pores of the dustbag become clogged. As a result, the dustbag-full indicator will
indicate that the dustbag is full. Replace the dustbag, even if it is not full yet (see chapter
‘Replacement’).
Never use the appliance without the Motor Protection Filter. This damages the motor and
shortens the life of the appliance.
Only use Philips s-bag
` double-layer paper dustbags.
The translucent display panel is made of recyclable polycarbonate (>PC<).
Electromagnetic elds (EMF)
ThisPhilipsappliancecomplieswithallstandardsregardingelectromagneticelds(EMF).Ifhandled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scienticevidenceavailabletoday.
Preparing for use
Connecting accessories
Hose
Toconnectthehose,pushitrmlyintotheappliance(‘click’)(Fig.2).
To disconnect the hose, push the buttons and pull the hose out of the appliance (Fig. 3).
Telescopic tube
1 To connect the tubes to each other and to the handgrip of the hose, press the spring-loaded
lock button. Then insert the part with the lock button into the part with the hole and t
the lock button into the hole (‘click’) (Fig. 4).
2 To disconnect the tubes from each other and from the handgrip, press the spring-loaded lock
button and pull the part with the lock button out of the part with the hole.
Use the same method to connect and disconnect the nozzles.
3 Adjust the tube to the length you nd most comfortable during vacuum cleaning (Fig. 5.)
Tri-Active nozzle
TheTri-Activenozzleisamulti-purposenozzleforcarpetsandhardoors.
The side brushes catch more dust and dirt at the sides of the nozzle and allow you to clean
better along furniture and other obstacles (Fig. 6).
The opening at the front of the nozzle allows you to suck up larger particles (Fig. 7).
1 Connect the Tri-Active nozzle to the tube.
2 Hard oor setting: push the rocker switch on top of the nozzle with your foot to make the
brush strip come out of the housing. At the same time the wheel is lifted to prevent
scratching and to increase manoeuvrability (Fig. 8).
3 Carpet setting: push the rocker switch again to make the brush strip disappear into the
nozzle housing. The wheel is lowered automatically (Fig. 9).
Small nozzle, crevice tool and small brush (FC9066 only)
1 Connect the crevice tool (1), the small nozzle (2) or the small brush (3) (specic types only)
directly to the handgrip or to the tube (Fig. 10).
Accessory clip (FC9060 only)
The accessory clip can simply be snapped onto the tube.
The crevice tool and the small brush can be snapped onto the clip (Fig. 11).
-
-
-
-
-
-
-
-
-
ENGLISH 7