<tc,
<
<
<tc
t
L
<
-、
• 0
'
인증받은자의 상호: Anker Innovations
Limited
제품명/모델명: 특정소출력 무선기기(무선
데이타통신시스템용 무선기기)/A3102제조자
및 제조국가: Anker Innovations Limited
제조년월: 2019/11
인증번호: R-C-AIl-A3102
이 장치는 보안성이 없으므로 통신보안에
위배되는 사항의 통신을 금지하며 운용 중
기기상호간 혼신 가능성이 있음” 및 “생
활무선국”
- English: "
This device complies with Industry Canada
licence-exempt RSS standard( s). Operation
is subject to the following two conditions:
(1)this device may not cause interference,
and
(2)this device must accept any interference,
including interference that may cause
undesired operation of the device."
- French:"
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables
aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux
conditions suivantes :
(1)l'appareil nedoit pas produire de
brouillage, et
(2)I'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en
compromettre le fonctionnement."
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two
conditions:
(1)This device may not cause harmful interference,
and
(2)This device must accept any interference
received, including interference that may cause
undesired operation.
Warning: Changes or modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipme nt.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates
uses and can radiate radio frequency energy and, if
not installed and used in acc
ordance with the
instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measure s:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which thereceiver is
connected.Consult the dealer or an experienced
radio/TV tec hnician for help.FCC Radiation
Exposure Statement:
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed
and operated with minimum distance 20cm
between the radiator & your body.
