20_ operating20_ operating
CHILD LOCK
This icon will light up when you activate the Child
Lock function by pressing Child Lock button.
Press this button again to reactivate.
Use this function to prevent children from tampering
with temperature and fi lter settings.
Canceling Exhibition Mode
In case of Exhibition Mode, It seems working
but doesn’t make cool air. To cancel this
mode, press the Power Freeze and Freezer
buttons at the same time for 8 seconds until
“Ding-dong” sounds.
CONTROLLING THE
TEMPERATURE
Basic Temperature of Freezer and
Fridge
The basic and recommended temperature of Freezer
and Fridge compartments are -19ºC / 3ºC.
If the temperature of Freezer and Fridge
compartments are too high or low, adjust the
temperature manually.
Controlling the Freezer temperature
The freezer temperature can be set between -15°C
and -23ºC to suit your particular needs.
Press the Freezer button repeatedly until the
desired temperature is shown in the temperature
display. Keep in mind that foods like ice cream may
melt at -16ºC.
The temperature display will move sequentially
from -15°C and -23ºC. When the display reaches
-15ºC, it will begin again at -23ºC.
Five seconds after the new temperature is set the
display will again show the actual current freezer
temperature. However, this number will change as
the Freezer adjusts to the new temperature.
CAUTION
LIGHTING
This icon will light up when you activate the
“Lighting” feature. In this case, the dispenser light
(under the display) will be on constantly. If you would
like the dispenser light to come on only when using
the dispenser, turn the “Lighting” feature off.
POWER COOL
This icon will light up when you activate the “Power
Cool” feature. For a quick fridge cool down, use
“Power Cool”. If you select “Power Cool”, the inside
temperature of the Fridge will decrease for about
two and a half hours.
FILTER INDICATOR
When the fi lter indicator light changes to red, it is
time to change the fi lter.
Typically this happens about every 6 months.
The fi lter Indicator will be Blue when you initially
insert the water fi lter. The fi lter Indicator will be purple
when you have used your water fi lter for 5 months.
The fi lter Indicator will be Red when you have used
your water fi lter for 6 months.
After removing the old water fi lter and installing a
new one (see page 17 for instructions on how to do
this), reset the indicator status light by pressing the
Ice off button for about 3 seconds.
CUBED ICE , CRUSHED ICE
Enjoy cubed or crushed ice by selecting your
preference from the digital control panel. The ice
type light indicates the type of ice that is currently
chosen.
WATER
This icon will light up when you activate the “Water”
feature.
ICE OFF
This icon will light up when you activate the “Ice Off”
feature. In this case, the ice will not be produced.
When Ice Off blinks on the display panel, reinsert the
bucket and/or make sure it’s installed properly.
Exhibition
mode
DA68-02924A-07.indb 20DA68-02924A-07.indb 20 2017. 5. 22. 2:422017. 5. 22. 2:42