Roland Aerophone 取扱説明書

タイプ
取扱説明書

このマニュアルも適しています

BiteCtrl
2
VibSens
Pit Down
2
Pit Up
2
Bite Adj
C A
BiteSens
FingMode
2
Functional Additions and Changes
P.7 MENU List
Menu Value Default Explanation
BiteCtrl
OFF
PIT1
PIT2
VIB
Depends on
the tone
Specifying the Control of the Bite Sensor (Reed Bite Strength)
The parameter that is controlled by the strength with which you bite the reed is specied for each individual tone.
OFF
OFF
Control via the bite sensor is turned o.
(For SuperNATURAL sounds, vibrato is naturally applied when you blow.)
PIT1
Pitch control 1
You can lower the pitch by weakening the strength of your bite
on the reed.
This is close to pitch control operation of a sax.
PIT2
Pitch control 2
You can apply vibrato by repeatedly strengthening and
weakening the strength of your bite on the reed.
This is the vibrato operation of a wind synth.
VIB
Vibrato control
Vibrato is automatically applied when you bite the reed strongly.
2
VibSens
0–10 5
Pitch Change Sensitivity Setting
This species how easily vibrato is applied by pitch control.
* This is valid only when “BiteCtrl” is set to “PIT2.
S
Pit Down
0–64
Depends on
the tone
Pitch Change Setting (Down)
This species how the pitch falls when you weaken your bite on the reed.
* This is valid only when “BiteCtrl” is set to “PIT1” or “PIT2.
2
Pit Up
0–64
Depends on
the tone
Pitch Change Setting (Up)
This species how the pitch rises when you strengthen your bite on the reed.
* This is valid only when “BiteCtrl” is set to “PIT2.
2
Bite Adj
AUTO
0–100
AUTO
Specifying the Basic State of the Bite Sensor (Reed Bite Strength)
This species the basic state for the strength with which you bite the reed.
Normally, you can specify “AUTO so that the adjustment is automatic.
If you want to adjust this manually, proceed as follows.
1. Bite the mouthpiece (reed) with your normal playing strength.
2. While continuing to bite the mouthpiece, press the octave key [+2]
button. The strength at which you are biting the reed at this time is
specied as the basic state.
* You can also use the [
C
] [
A
] buttons to adjust the value of the setting.
S
BiteSens
AUTO
0–100
AUTO
Specifying Sensitivity of the Bite Sensor (Reed Bite Strength)
Adjust the reed position at which the pitch eect specied
by "BiteCtrl" starts to take eect. Normally, you can specify
"AUTO" so that the adjustment is automatic.
If the bite sensor has too much eect, decrease the value.
If the eect is dicult to apply, increase the value.
S
FingMode
SAX1
SAX2
RECO
EWND
TRPT
LEFT
RIGH
SAX1
Switches the ngering mode.
SAX1 Sax ngering with altissimo
SAX2 Sax ngering without altissimo
RECO Recorder ngering
EWND Electronic wind instrument ngering
TRPT Trumpet ngering
LEFT Fingering that lets you perform using only the left hand
RIGH Fingering that lets you perform using only the right hand
S
Please be aware of the following additions and changes to the content of the Aerophone
AE-10 Owner’s Manual.
* The underlined bold characters are the additions or changes.
Weakening the strength
of your bite on the reed
lowers the pitch
Apply vibrato by repeatedly
strengthening and weakening the
strength of your bite on the reed
Bite the mouthpiece
(reed) with your normal
playing strength
Increasing the value increases
the range of eectiveness
Decreasing the value decreases
the range of eectiveness
No eect
Eect
Notice of Added and Changed Function
Ver. 2.20
2
: Tone Setting S: System Setting
Aerophone AE-10 Copyright © 2017 ROLAND CORPORATION
* 5 1 0 0 0 6 1 1 9 0 - 0 1 *
Fingering Mode /
Fingering Chart /
Fingering that lets you perform using only the left hand (LEFT) / LEFT
Fingering that lets you perform using only the Right hand (RIGH) / RIGH
Notice of Added and Changed Function /
C4 D4 F4
C#/D
²
4 D#/E
²
4
E4
G4
F#/G
²
4
A#/B
²
4G#/A
²
4
A4
D5
C#/D
²
5
C5
B4
E5
D#/E
²
5
F5
C#/D
²
4
C4
D#/E
²
4
D4 E4
F#/G
²
4
A4
F4
G4
G#/A
²
4
B4
A#/B
²
4
D#/E
²
5
E5C5
C#/D
²
5
D5
F5
  • Page 1 1
  • Page 2 2

Roland Aerophone 取扱説明書

タイプ
取扱説明書
このマニュアルも適しています

他の言語で