12g
MADE IN TAIWAN
AAKCCD46 INSTRUCTION MANUAL
www.kwcgun.com
KIEN WELL TOY INDUSTRIAL CO., LTD
SINCE 1978
AAKCCD46 系列說明書
操作/OPERATION 故障/BREAK DOWN
Turn the magazine cap out counter-
clockwise and place CO2 cartridge B
inside the magazine. Rapidly turn the
screw A clockwise when piercing the
cartridge in the magazine.
逆時針轉出彈匣
底內件後，置入
小鋼瓶B，再以
順時針方向鎖緊彈匣底內件A。當刺破鋼瓶
出氣時，請快速鎖緊。
4.
Maximum BB capacity is 15 rounds.
CO2 Cartridge is not included
Load BBs one by one.
Use hexagonal wrench to remove the
magazine cap by counter clockwise.
Insert fully loaded magazine in the airsoft
until you hear the sound of “CLICK”.
Loading BBs
Press the button.
Release the magazine.
台南市仁德區義林路168巷89號
NO.89, LN. 168, YILIN RD.,
RENDE DIST., TAINAN CITY
71752, TAIWAN (R.O.C.)
TEL+886-6-2798175
FAX+886-6-2798176
www.kwcgun.com
Pulling trigger will load BB in the barrel.
Therefore, please do not pull the trigger half
way and release the trigger. This action could
load 2 BBs in the pistol and cause jamming.
Bad quality BB is the main reason to cause
BB jam. Please use the best quality KWC
BB to avoid jamming problem.
When BB jammed, first please release the
magazine from pistol then use a soft stick
(diameter no bigger than 6mm) to clear up the
barrel.
Please avoid dry firing, for it could cause
parts deformed or damage.
此低動能遊戲用槍是針對喜愛射擊運動
的消費者所開發。避免因使用方法不正確或
改造所發生的故障或事故，請務必詳讀說明
書，正確的操作享受愉快的射擊運動。
This airsoft is intended for recreational or
training purposes.To prevent improper
handling, modification or alteration
causing malfunction or accident, please
read the owner’s manual carefully. Enjoy
the pleasant shooting experience by
proper operation.
1.除了發射時外，不要將手指頭掛在板機上。
2.選擇安全與適當標靶
3.在非使用期間，請保持保險關閉且退彈的狀態，
就算在非使用狀態，也要如同其己裝彈。
4.如任何的機械產品，槍的保險也可能失效。即使
在保險關閉的狀態下也請小心的操作此槍，請勿
將槍口對人。
5.千萬不要對堅硬或平坦表面、水面射擊，以避免
跳彈。
6.請妥善保管產品在未成年孩童無法伸手取得的場
所。
7.每次使用前後都應該檢查擋彈物，假如擋彈物表
面有磨損失效或是反彈時請停止使用。
8.請使用高品質BB彈，請勿使用 口徑大於6mm
表面不平滑的 重複使用過的BB彈 非本說
明書指名的發射物。
9.最 高的使用及儲藏CO2小鋼瓶環境為50℃
(122℉)以內，高溫可能會造成CO2小鋼瓶過熱
甚至爆炸。
10.檢查任何掉落之槍枝，以確保未影響其功能。
1.Do not put your finger on the trigger except shooting.
2.Please choose safe and proper target.
3.Please always keep the airsoft on safe and unloaded when
not using.
4.Like all mechanical devices, an airsoft safety can fail.
Always handle the airsoft safely even when the safety is “on
safe”. Never point the airsoft at any people.
5.Avoid ricochet. Never shoot at a hard or flat surface or at
water.
6.Keep the airsoft out of reach for small children.
7.Your backstop should be inspected for wear before and
after each use. Discontinue use of the backstop if surface
shows signs of failure or ricochet.
8.Only use high quality BB. Never use BB diameter larger
than 6mmBB with unsmoothed surfacereused BB that
has been firedincorrect projectiles not design for this
airsoft.
9.Do not expose CO2 cartridges to heat or store them at
temperatures above 50∘C(122∘F). CO2 cartridges may
over heat or explode at temperatures above 50∘C(122∘F).
10.Check any gun that has been dropped to ensure that its
function has not been affected.
For your safefy, please read this manual carefuly before use.
1. 按下卡榫
2. 取出彈匣
3. 使用六角鈑手反時針方向取出彈匣底內件。
5. 拉下滑粒。
7. 最多可裝15粒。
可射擊 保險
6. 填裝BB粒。
為了使擊發順暢，填裝
方法是讓BB彈在彈匣中一粒接著一粒。
將裝好B.B彈的彈匣插入槍身往上推入，
直到彈匣卡榫發出"卡嚓"為止。
1.
2.
瞄準目標物扣引鈑機，即可擊發。
注意:在長期不使用的狀態下，請將彈匣
內的氣體洩放掉。
1.不良的B.B彈是造成卡彈的原因，請使用
品質優良的KWC B.B彈。
2.當卡彈時，請盡可能先取出彈匣，再以不
傷槍管的軟質細棒(不可大於6mm直徑)從
槍口置入清除。
3.空擊發易造成零件損耗，請避免此動作。
4.當扣引鈑機時，此時B.B彈即同時在上膛
階段，不可扣引一半時又回復，因為如此
的動作，將有可能上膛兩發B.B彈。
5.使用一段時間後，請再次用中性矽油脂潤
滑撞針及鈑機軸心。
Do not display this pistol in public—it may confuse people and may be a crime.
Always wear eye
protection when
using airsoft.
使用玩具槍前，
請務必戴上保護
眼鏡或面罩。
★使用玩具槍前，
請務必詳讀說明
書內容。
Read the owner’s
manual before
using the airsoft.
Never brandish or aiming this airsoft at any
people or domestic animals. Brandish this
airsoft in public is dangerous and may be a
crime.
★請不要在公開場合使用玩具槍，也請不
要拿玩具槍對準人或動物。
★不可攜帶玩具槍
在公共場所行
走，請務必裝在
袋子或盒子內。
Always transport an
airsoft in a locked
carrying case.
Make sure it is
unloaded and on
safe.
★請不要由槍口向
內探視。
To Avoid accidental
discharge, do not
look directly into the
barrel.
★請確認後再發射BB彈方向，附近無人
或動物存在。
Always be aware of your surrounding
before and during shooting and select a
safe area for target practice.
Disassemble, modify, or alter of your airsoft
may cause malfunction, void your warranty
and may make it unsafe to use.
★不可任意改造或加工玩具槍，私自改造
加工會造成產品損壞、保固失效，導
致使用上不安全，甚至觸法送辦。
警告
Spare parts may be modified for quality improvement
And such modification may be without advance notice.
K08-00637-K3 2018 © 10
AAKCCD46 SERIES PARTS LIST
AAKCCD46 系列 零件表
AAKCCD46 SERIES PARTS LIST
AAKCCD46 系列 零件表
AAKCCD46 系列 零件分解圖
AAKCCD46 SERIES
EXPLODED
VIEW
NO.
UNIT
零件名稱 NO.
UNIT
零件名稱
VALVE PACKING
MAGAZINE FOLLOWER
SLIDE(PLASTIC)
CHASSIS(L)
CHASSIS(R)
SAFETY(L)
SLIDE STOPPER
FRAME
GRIP
MAGAZINE CATCH
OUTER BARREL CAP
P31
P403
P417
P460
P461
P462
P465
P466
P468
P469
P601
P603
P607
P727
Z442
Z462
Z465
Z468
Z469
B19
B33
B215
B461
B465
B468
F03
F401
F465
F468
F601
F705
SM04
SM05
SM63
S401
S404
S406
S613
S461
S466
S804
E01
E03
E04
R01
R02
R03
R04
R05
R07
R08
U02
U1
U2
心棒蓋迫緊
彈匣底內件
彈匣滑粒
槍身上蓋
擊鐵箱(左)
擊鐵箱(右)
保險左(新規)
上蓋止動片
彈匣底座定位件
導管配件
槍身本體
槍柄(射包)
彈匣卡榫
槍管套(KA.KG)
撞針
上蓋(鋅合金)
鈑機
鈑機連動件
槍管連動件
心棒蓋
氣瓶頂針(新)
氣瓶頂針迫緊
槍管
心棒
撞針軸(新)
軸(擊鐵)
心棒壓簧墊圈
鈑機連桿壓簧軸
保險釋放件(新規)
軸(擊鐵箱用)
平頭軸(活塞卡榫用)
鈑機連動件扭簧
鈑機連動件壓簧
撞針扭簧
彈匣壓簧
心棒壓簧
鈑機扭簧
彈匣卡榫線簧
鈑機連桿壓簧
保險釋放件扭簧
撞針緩衝扭簧(新規)
E型扣環
⊕
2.3X8束黑 螺絲
⊕
2.3X6尖黑熱 螺絲
子彈迫緊
O形環
1.45X6.9id
O形環 1X5
O型環 1X4
O型環
∮0.8x∮11.3id
O型環 1X7
O形環 1X3
六角鈑手
內槍管組件
氣瓶頂針組件
MAGAZINE BOTTOM
CAP
MAGAZINE BASE JOINT
OUTER BARREL COVER
FIRING PIN
SLIDE(METAL)
TRIGGER
TRIGGER CONNECTOR
BARREL TOW
VALVE CAP
PUNCTURE VAVLE
BARREL
VALVE
FIRING PIN AXLE
PUNCTURE VAVLE
PACKING
PIN (HAMMER)
VALVE SPRING GASKET
SAFETY RELEASE
PIN(CHASSIS)
PIN
(PISTON CATCH)
F464
鈑機連桿
TRIGGER BAR
TRIGGER CONNECTOR
SPRING #04
TRIGGER BAR SPRING
PIN
TRIGGER CONNECTOR
SPRING #05
FIRING PIN SPRING
MAGAZINE SPRING
VALVE SPRING
TRIGGER SPRING
TRIGGER BAR SPRING
MAGAZINE CATCH SPRING
FIRING PIN BUFFER
SPRING
E-RING
SCREW 2.3X6
SCREW 2.3X6
RUBBER CHAMBER
O-RING 1.45X6.9id
O-RING 1X5
O-RING 1X4
O-RING ∮0.8x∮11.3id
O-RING 1X7
O-RING 1X3
WRENCH
INNER BARREL UNIT
PUNCTURE VAVLE UNIT
SAFETY RELEASE
SPRING
-
1
-
2
