12g
www.kwcgun.com
KIEN WELL TOY INDUSTRIAL CO., LTD
SINCE 1978
MADE IN TAIWAN
CO2 Cartridge is not included
Turn the magazine cap a
out counter-clockwise
and place CO2 cartridge
B inside the magazine.
Rapidly turn the screw A clockwise when
piercing the cartridge in the magazine.
Insert fully loaded magazine in the airgun until
you hear the sound of “CLICK”.
Bad quality BB is the main reason to cause
BB jam. Please use the best quality KWC
BB to avoid jamming problem.
When BB jammed, first please release the
magazine from pistol then use a soft stick
(diameter no bigger than 4.4mm) to clear up
the barrel.
Pulling trigger will load BB in the barrel.
Therefore, please do not pull the trigger half
way and release the trigger. This action could
load 2 BBs in the pistol and cause jamming.
Please avoid dry firing, for it could cause
parts deformed or damage.
此低動能遊戲用槍是針對喜愛射擊運動
的消費者所開發。避免因使用方法不正確或
改造所發生的故障或事故，請務必詳讀說明
書，正確的操作享受愉快的射擊運動。
This airgun is intended for recreational or
training purposes.To prevent improper
handling, modification or alteration
causing malfunction or accident, please
read the owner’s manual carefully. Enjoy
the pleasant shooting experience by
proper operation.
1.除了發射時外，不要將手指頭掛在板機上。
2.選擇安全與適當標靶
3.在非使用期間，請保持保險關閉且退彈的狀態，
就算在非使用狀態，也要如同其己裝彈。
4.如任何的機械產品，槍的保險也可能失效。即使
在保險關閉的狀態下也請小心的操作此槍，請勿
將槍口對人。
5.千萬不要對堅硬或平坦表面、水面射擊，以避免
跳彈。
6.請妥善保管產品在未成年孩童無法伸手取得的場
所。
7.每次使用前後都應該檢查擋彈物，假如擋彈物表
面有磨損失效或是反彈時請停止使用。
8.請使用高品質BB彈，請勿使用 口徑大於4.4mm
表面不平滑的 重複使用過的BB彈 非本說
明書指名的發射物。
9.最高的使用及儲藏CO2小鋼瓶環境為50∘C(122∘
F)以內，高溫可能會造成CO2小鋼瓶過熱甚至爆
炸。
10.檢查任何掉落之槍枝，以確保未影響其功能。
1.Do not put your finger on the trigger except shooting.
2.Please choose safe and proper target.
3.Please always keep the airgun on safe and unloaded when
not using.
4.Like all mechanical devices, an airgun safety can fail.
Always handle the airgun safely even when the safety is “on
safe”. Never point the airgun at any people.
5.Avoid ricochet. Never shoot at a hard or flat surface or at
water.
6.Keep the airgun out of reach for small children.
7.Your backstop should be inspected for wear before and
after each use. Discontinue use of the backstop if surface
shows signs of failure or ricochet.
8.Only use high quality 4.5mm steel BBs. Never use BB
diameter larger than 4.4 mmBB with unsmoothed surface
reused BB that has been firedincorrect projectiles not
design for this airgun
9.Do not expose CO2 cartridges to heat or store them at
temperatures above 50∘C(122∘F). CO2 cartridges may
over heat or explode at temperatures above 50∘C(122∘F).
10.Check any gun that has been dropped to ensure that its
function has not been affected.
台南市仁德區義林路168巷89號
NO.89, LN. 168, YILIN RD.,
RENDE DIST., TAINAN CITY
71752, TAIWAN (R.O.C.)
TEL+886-6-2798175
FAX+886-6-2798176
www.kwcgun.com
AAKCMD43 INSTRUCTION MANUAL
AAKCMD43 系列說明書
For your safefy, please read this manual carefuly before use.
Press the button.
Release the magazine.
1. 按下卡榫
2. 取出彈匣
Use hexagonal wrench to remove the
magazine cap by counter clockwise.
使用六角鈑手反時針方向取出彈匣底內件。
3.
逆時針轉出彈匣底內件
後，置入小鋼瓶B，再
以順時針方向鎖緊彈匣
底內件A。當刺破鋼瓶
出氣時，請快速鎖緊。
4.
為了使擊發順暢，填裝
方法是讓B.B彈在彈匣中一粒接著一粒。
填裝B.B彈。
6.
最多可裝21粒。
7.
拉下滑粒。
5.
Maximum BB capacity is 21 rounds.
Load BBs one by one.
Loading BBs
將裝好B.B彈的彈匣插入槍身往上推入，直
到彈匣卡榫發出"卡嚓"為止。
1.
瞄準目標物扣引鈑機，即可擊發。
2.
注意:在長期不使用的狀態下，請將彈匣內氣
體洩放掉。
CAUTIONRelease all the gas in the magazine
when it will be unused for a long period of time.
可射擊 保險
1.不良的B.B彈是造成卡彈的原因，請使用
品質優良的KWC B.B彈。
2.當卡彈時，請盡可能先取出彈匣，再以不
傷槍管的軟質細棒(不可大於4.4mm直徑)
從槍口置入清除。
3.空擊發易造成零件損耗，請避免此動作。
5.使用一段時間後，請再次用中性矽油脂潤
滑撞針及鈑機軸心。
4.當扣引鈑機時，此時B.B彈即同時在上膛
階段，不可扣引一半時又回復，因為如此
的動作，將有可能上膛兩發B.B彈。
本體
保險(左)
保險(右)
擊鐵
上蓋止動片
彈匣卡榫
槍柄(左)
槍柄(右)
底座定位件
保險定位軸
KM46-槍管套
內槍管導引件
心棒蓋迫緊
彈匣底內件
彈匣滑粒
零件名稱圖號 UNIT
零件名稱圖號 UNIT
K08-00647-X10 2019 © 01
Spare parts may be modified for quality improvement
And such modification may be without advance notice.
警告
Do not display this pistol in public—it may confuse people and may be a crime.
Always wear eye
protection when
using airsoft.
★使用低動能遊戲
用槍前，請務必
戴上保護眼鏡或
面罩。
★使用低動能遊戲
用槍前，請務必
詳讀說明書內容
。
Read the owner’s
manual before
using the airsoft.
Never brandish or aiming this airsoft at any
people or domestic animals. Brandish this
airsoft in public is dangerous and may be a
crime.
★請不要在公開場合使用低動能遊戲用槍
，也請不要拿低動能遊戲用槍對準人或
動物。
★不可攜帶低動能
遊戲用槍在公共
場所行走，請務
必裝在袋子或盒
子內。
Always transport an
airsoft in a locked
carrying case.
Make sure it is
unloaded and on
safe.
★請不要由槍口向
內探視。
To Avoid accidental
discharge, do not
look directly into the
barrel.
★請確認後再發射BB彈方向，附近無人
或動物存在。
Always be aware of your surrounding
before and during shooting and select a
safe area for target practice.
Disassemble, modify, or alter of your airsoft
may cause malfunction, void your warranty
and may make it unsafe to use.
★不可任意改造或加工低動能遊戲用槍，
私自改造加工會造成產品損壞、保固
失效，導致使用上不安全，甚至觸法
送辦。
AAKCMD43
系列零件表
AAKCMD43 SERIES PARTS LIST
AAKCMD43 SERIES EXPLORED VIEW
AAKCMD43
系列零件分解圖
KG43-P02
KG43-P03
KG43-P04
KG43-P05
KG43-P06
KG43-P07
KG43-P08
KG43-P09
KM43-P11
KG43-P16
KM43-P27
KM43-P28
UKG01-P31
KG12-P60
KM47-P477
KPMD43-Z03
KG43-Z04
KG43-Z07
KG43-Z08
KG43-Z11
KG43-Z12
KG43-Z13
KG43-Z14
KM47-Z31
KM47-Z33
KM43-Z34
彈匣本體 4.5
撞針
保險連桿
鈑機連桿
上蓋
擊鐵箱(右)
擊鐵箱(左)
握柄配件
槍管連動件
鈑機連動件
鈑機
KM47-R01
子彈迫緊HOP-UP
KG43-B02
KM43-B03
KG42-B04
KM43-B11
KW-B07
KW-B15
UKG01-B19
KG12-B215
鈑機軸套
鈑機連動件軸#1
撞針軸套
槍管 HOP-UP用
氣瓶頂針M14
RKM系心棒(兩孔)
心棒蓋
氣瓶頂針迫緊
KG43-F01
KG43-F04
KG43-F05
KA11-F07
KG47-F401
KG46-F463
KA18-F801
EF005
軸(鈑機用)
軸(鈑機連桿用)
軸(擊鐵用)
KA-11 軸B(擊鐵箱)
心棒壓簧墊圈
撞針軸
軸(彈匣用)
鈑機連動件軸#2
KG43-S01
KG43-S02
KM43-S04
KG43-S05
KG43-S06
KM47-S471
鈑機連桿扭簧
彈匣卡榫扭簧
鈑機扭簧
擊鐵扭簧
保險定位軸壓簧
彈匣壓簧
KM43-SM1
KM43-SM2
KM43-SM6
鈑機連動件扭簧
撞針扭簧
心棒壓簧
ED007
EA006
EA018
EA021
EA043
EA103
EC011
E型扣環
一字特殊3.0X6束黑
⊕
2.3X6 尖黑熱螺絲
⊕
2.3X6 束黑熱螺絲
⊕ 3X8 尖錏螺絲
止付螺絲3X3
彈簧銷(底座定位件用)
G005
G001
G013
G024
G036
U1
U2
U3
內槍管組件
鈑機連桿組件
氣瓶頂針組件
O型環 1X4
O型環
0.8X11.3id
O形環
1.45X6.9id
O形環 S-10
O形環 2X11
FRAME
SAFETY(L)
SAFETY(R)
HAMMER
SLIDE STOPPER
MAGAZINE CATCH
GRIP (L)
GRIP (R)
MAGAZINE BASE LOCATOR
SAFETY FLOCATOR PIN
OUTER BARREL CAP
INNER BARREL GUIDE
VALVE PACKING
MAGAZINE BOTTOM CAP
MAGAZINE FOLLOWER
MAGAZINE FRAME
FIRING PIN
SAFETY LINK
TRIGGER BAR
SLIDE
CHASSIS (R)
CHASSIS (L)
GRIP PLUG
BARREL TOW
TRIGGER CONNECTOR
TRIGGER
RUBBER CHAMBER
TRIGGER SLEEVE
FIRING PIN SLEEVE
BARREL
PUNCTURE VAVLE
VALVE
VALVE CAP
PUNCTURE VAVLE
PACKING
PIN (TRIGGER)
PIN (TRIGGER BAR)
PIN (HAMMER)
PIN (CHASSIS)
VALVE SPRING GASKET
FIRING PIN AXLE
PIN (MAGAEINE)
TRIGGER BAR SPRING
MAGAZINE CATCH SPRING
TRIGGER SPRING
HAMMER SPRING
MAGAZINE SPRING
FIRING PIN SPRING
VALVE SPRING
TRIGGER CONNECTOR
SPRING
E-RING
SCREW 3.0X6
SCREW 2.3X6
SCREW 2.3X6
SCREW 3X8
SET SCREW 3X3
SPRING PIN
O-RING 1X4
O-RING 0.8X11.3id
O-RING 1.45X6.9id
O-RING S-10
O-RING 2X11
INNER BARREL UNIT
TRIGGER BAR UNIT
PUNCTURE VAVLE UNIT
P28
Z31
Z34
S04
SM2
Z33
TRIGGER CONNECTOR
PIN#1
TRIGGER CONNECTOR
PIN#2
SAFETY LOCATOR PIN
SPRING
-
1
-
2
他の言語で
- English: KWC 941 User manual