Instruction Manual : Ver 1.00
Specification
CS-270R
Name of each part
●Material : Stainless Steel
●Size : Bottom : dia 115 × 247mm (4.5” x 9.7”)
●Full water capacity : 1.8L (.5gal)
●Weight : 690g (24.3 oz)
Safety Precautions: Before use, please read thoroughly to ensure safety and avoid accidents.
How to use
Maintenance
WARNING / Misuse could result in a potentially hazardous situation that can result in serious injury or death to the user.
CAUTION / Indicates actions that may lead to injury, damage to the product, or damage to other items.
●Before use, wash well with mild detergent and a soft sponge. ●Do not use the kettle if it is full of water. Instead, leave a bit of space at the top, so the boiling
water does not spill over. ●Since this product is made of metal, it will become hot during use and will remain so for a while after use. Avoid burns by using a
potholder or other protection when handling. ●Adjust the heat so that the flame is not larger than the bottom of the kettle. A large flame may cause the product
to become hot, resulting in burns. ●When using this product over a bonfire or charcoal fire, adjust the heating power so the heat from the flames of the charcoal
or firewood is indirect. The product may become hot and burn. Do not put firewood or charcoal on the lid - doing so may damage the product. ●Do not apply a
sudden impact, jolt, or sudden temperature change (such as pouring cold water over the heated product) as burns or damage may occur. ●Never use the kettle
on a heater or induction burner. ●The metal fittings that hold the spout lid are very easy to bend, so please handle with care. ●Only use this product over an
open flame; do not use it on an induction stove.
●Do not turn this product upside down to dry. Drying the kettle upside down will damage the connection between the lid and the main
body. ●Do not use a metal scrubbing brush or detergents containing polishing powder when washing. Abrasive materials may damage
the surface. Similarly, removing soot will damage the surface, so please do not remove it. ●Do not use a dishwasher. It may cause
damage to the product. ●After use, wash thoroughly, wipe off the water, and dry well in a well-ventilated shade. ●Store in a dry place
with no moisture.
●Before using the product, check each part for abnormalities. If there are abnormalities, take the product to the dealer or Snow Peak Customer Service for
inspection or repair. ●When using the product with Snow Peak's stoves or burners, please read the instruction manual of the stove or burner carefully. Check
that the model is compatible before handling according to the precautions. ●This product is a kettle. Do not use this product for any purpose other than boiling
water. ●Do not use this product empty. Heating an empty kettle may result in fire, burns, or product damage. ●The kettle is very hot during and after use. Please
be careful not to burn yourself. Keep a close eye on the kettle to prevent serious accidents, especially when young children are present.
Instruction manual
About Spout Springs
You can keep the spout open by securing
the spout lid spring to the lid. Attach itas
shown.
When boiling water
Fill with water until it reaches the center
hole with 3 holes as shown in the figure.
It can hold about 1.3Lof water. If you
add too much water, there is a risk of it
overflowing when it boils.
Guide for boiling water
When the water boils, steam is generated
between the lid and the main body or
from the spout. Oncethe water is boiling,
turn off the heat
immediately. If using
the kettleon a
bonfire, remove from
the fire and place on
a pot stand.
When pouring
After boilingwater,
the entire product will
heat up, includingthe
handle. Please use a
pot holder to avoid
burns.
WARNING / Opening the spoutwhile
heating may release steam that can cause
burns. Never touch the productwhile it is
heating.
WARNING / The entire product becomes
very hot after heating water. If you wantto
use the spring, use a pot holder.
CAUTION / Be careful to
avoid tipping it over, as it will
be unstable when sitting on
a towel.
Bracket
Body Handle
Body
Handle
Spout lid
The specifications of Snow Peak products are based on field testing and quality control to ensure the correct function and longevity of every product. If apparent defects
in the manufacturing of the product are found, the defective product will be repaired or exchanged free of charge. Damages, as follows, are not covered under warranty.
1. Material deterioration caused by age. / 2. Damage caused by modifications or rough handling. / 3. Damage caused by improper use not following the instruction manual.
/ 4. Damage caused by unexpected accidents. / 5. Damage not caused by defects in the manufacturing process. / 6. Damage caused by dust or rust. / 7. Damage or
defects caused when dismantling the product. / 8. Damage and defects caused by dropping or other shocks to the product. / 9. Deterioration or failure of parts due to
friction. / 10. Damage caused by the use of the product in combination with other maker’s products.
Warranty
●For repairs, please contact the retailer where you purchased the product or Snow Peak user service. ●When you ask for repair, please make sure that the product is dry
and clean. ●Please attach a memo or some kind of tag indicating the needed repair, and please write details of when and how the damage occurred. ●Shipping cost and
repair fee for the repair as follows. 1. Within warranty: Return shipping cost and repair fee will be covered by Snow Peak / 2. Outside warranty: Return shipping cost and
repair fee will be covered by the user.
Repair
MADE IN CHINA
Snow Peak, Inc.
456, Nakanohara, Sanjo-Shi, Niigata 955-0147 Japan
Tel. +81 256-46-5858 Fax. +81 256-46-5860
www.snowpeak.co.jp
Snow Peak USA, Inc.
404 NW 23rd Avenue, Portland, Oregon 97210, USA
Tel. +1-503-697-3330 Instagram. @snowpeakusa
www.snowpeak.com Email. [email protected]
For cold drinks
Please place a towel under
the product to prevent
condensation.
NG
/
