3
Para usar todas las características, Adonit
Snap debe estar conectado a un dispositivo
compatible. Siga estos pasos:
1. Encender el puntero Adonit Snap:
Mantenga presionado el botón del cilindro
hasta que la luz parpadee.
2. Activar Bluetooth: En su teléfono vaya
a Ajustes > Active Bluetooth > mantenga
pulsado el botón Snap > seleccione Adonit
Snap > Asociar
3a. Para tomar un selfie: Abra la cámara
o la aplicación de fotos seleccionada y
presione el botón rápido Snap para tomar
la f
oto.
3b. Para escribir con Snap: Abra la
aplicación de escritura deseada y comience
a escribir.
Adonit Snap
1.啟 Adonit Snap
2.啟 啟
Snap Adonit Snap
3a. 啟
Snap
3b. Snap 啟
ES
ZH
Adonit Snap Model No: 090
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
Reorient or relocate the receiving antenna. Increase the
separation between the equipment and receiver. Connect
the equipment into an outlet on a circuit different from
that to which the receiver is connected. Consult the dealer
or an experienced radio/TV technician for help. This
device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not
cause interference, and (2) this device
must accept any interference, including interference that
may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions
suivantes : (1) l’appareil ne doit pas produire de brouillage,
et (2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.