S
18
20
21
22
24
28
29
30
31
32
HBF800TE
2
HBF800TE
,
DŽ
Intense
Prewash
Normal
Middle
Delicate
Normal
Middle
Delicate
Normal
Delicate
Normal
Delicate
Silk
8
9
10
11
12
13
14
15
0
1
2
3
4
5
6
7
Very heavy soil
Non-fade heavily soiled
woolen fabrics
Fading and medium
soiled woolen fabrics
Non-fade heavily soiled
silk fabrics
Fading and medium
soiled silk fabrics
End
Spin
Rinse
Quick
Medium-soiled lanudry
Fading and medium
soiled chemical fiber
Non-fade and medium
soiled chemical fiber
Non-fade heavily
soiled chemical fiber
Fading and medium
soiled cotton
Non-fade and medium
soiled cotton
Soiled cotton
Heavy soil
Program Setting Laundry Temperature
-30-40-50-60
-70-80-90
*
-30-40-50-60
*
-30-40-50-60
*
-30-40
*
*
-30-40-50-60
*
-30-40
*
*
-30-40
*
*
-30
*
*
-30
*
*
*
Turn the program knob at "0" position and turn off the power. The wash
program ends and the washing machine stops operation.
1
2
3
1
-30-40-50-60
-70-80-90
2
-30-40-50-60
3
-30-40-50-60
X
4
-30-40
X
5
X
6
-30-40-50-60
X
7
-30-40
X
8
X
9
-30-40
X
10
X
11
-30
X
12
X
13
-30
X
14
X
15
X
0
“0”
HBF800TEHBF800TE
5. 洗
滌量
類型 不褪色棉織物 精細織物
羊毛織
物
混合織物
最高洗衣量
5公斤
2公斤
1公斤
2.5
公斤
其他功能其他功能
1.1. 斷電記斷電記憶功能憶功能
本產品具有斷電記憶功能。如果在洗滌週期中出現突然的停電或者需要中斷電源，當前的設定將被保
電 源重新接 運轉將 繼續
進行
。
2.2.
故障資故障資訊：根訊：根據門據門鎖指示鎖指示燈判斷燈判斷故障的故障的類別類別
故障 1：門鎖指示燈不亮
原因：門未 。
解決辦法：把門關嚴。
故障 2：門鎖指示燈閃 2 次之後熄滅，4秒後重複出現。
原因：排水故障，水未
在 4 分鐘之內排出。
解決辦法：清洗 並檢查排水軟管是否堵塞。如果故障依舊存在，請與維修人員聯絡。
故障 3：門鎖指示燈閃 3 次之後熄滅，4秒後重複出現。
原因：溫度感測器連接不當或者損壞。
解決辦法：請與維修人員聯絡。
故障
4： 門鎖指示燈閃 4 次之後熄滅，4 秒後重複出現。
原因：加熱管損壞
造成無法在規定時間內達到設定溫度（該資訊在程式結束
時顯示）。
解決辦法：
故障 5：門鎖指示燈閃 5 次之後熄滅，4秒後重複出現。
原因：未能在 8 分鐘內達到預定水位。
解決辦法：檢查水龍頭是否打開，水壓是否正常，如故障依舊存在，請與維修人員聯絡。
故障 6：門鎖指示燈閃 6 次之後熄滅，4秒後重複出現。
原因：定時控制器損壞。
解決辦法：請與維修人員聯絡。
故障 7：門鎖指示燈閃 7 次之後熄滅，4秒後重複出現。
原因：電機過熱保護或者損壞。
解決辦法：請與維修人員聯絡。
故障 8：門鎖指示燈閃 8 次之後熄滅，4秒後重複出現。
原因
解決辦法：請與維修人員聯絡。
。
能
請與維修人員聯絡。
Other Functions
or the power must be cut off during a program cycle, the present settings will be
saved, and operation will resume when the power is switched on again.
2. Trouble messages: judge the malfunctions from door lock light
Error 1: The door lock light does not illuminate.
Cause: Door is not properly shut.
Correction: Shut the door properly.
Error 2: The door lock light glitters 2 times and stops 4 seconds repeatedly.
Cause: Drainage error, water not emptied within 4 minutes.
Correction: Clean the filter and check the drain hose for blockage. If error still
exists, please contact the maintenance personnel.
Error 3: The door lock light glitters 3 times and stops 4 seconds repeatedly.
Cause: Temperature sensor not properly connected or damaged.
Correction: Contact the maintenance personnel.
Error 4: The door lock light glitters 4 times and stops 4 seconds repeatedly.
Cause: Heating coil damage that leads to a failure to
reach the
at the end of a program).
Correction: If error still exists , please contact the
maintenance personnel.
Error 5: The door lock light glitters 5 times and stops 4 seconds repeatedly.
Cause: Water level not met in 8 minutes.
Correction: Make sure that tap is turned on, and water pressure is normal.
If problem still exists, please contact the maintenance personnel.
Error 6: The door lock light glitters 6 times and stops 4 seconds repeatedly.
Cause: Timing control silicon damage.
Correction: Contact the maintenance personnel.
Error 7: The door lock light glitters 7 times and stops 4 seconds repeatedly.
Cause: Motor overheat protection or damage.
Correction: Contact the maintenance personnel.
Error 8: The door lock light glitters 8 times and stops 4 seconds repeatedly.
Cause: Water exceeds protective level.
Correction: Contact the maintenance personnel.
set temperature within the specified time (This message is display
4
HBF800TE
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
