Note: The IP phone also supports IPv6, but IPv6 is disabled by default.
The wrong network settings may result in inaccessibility of your phone and may have an impact on the network performance. Contact your
system administrator for more information.
Account Settings: Click on Account->Register
.
Parameters of the account:
Register Status:
It shows the register status of the current account.
Line Active:
You can select Enabled/Disabled to enable/disable the account.
Label:
It is shown on the touch screen to identify the account.
Display Name: It is shown as Caller ID when placing a call.
Register Name: It is an authenticated ID for authentication provided by ITSP (required).
User Name:
It is provided by ITSP for registration (required).
Password:
It is provided by ITSP for registration (required).
Server Host: It is provided by ITSP for registration (required).
Register status icons on the touch screen:
Configuring via phone user interface
Network Settings:
1. Tap Settings->Advanced (default password: admin) ->Network->WAN Port/VLAN/Webserver
Type/802.1x/VPN/LLDP/CDP/NAT to configure the network.
Wireless Network Connection:
1. Tap Settings
from the Home screen.
2
. Tap Wi-Fi from the Basic block.
3. Turn Wi-Fi on.
The button turns to green, and the phone will automatically search for available
wireless
networks in your area.
4. Tap an available
wireless
network from the list of networks.
5. If the network is secure, enter its password in the Password field.
6. Tap Connect to connect to the wireless network.
Account Settings:
1. Tap Settings->Advanced (default password: admin) ->Accounts to configure the account.
(Green) Registered
(Gray) Register Failed
(Green and Flashing) Registering
Configuring via web user interface
Accessing the web user interface:
1. Tap Settings
->General
to obtain the IP address of the phone.
2. Open a web browser on your computer, enter the IP address into the address bar (e.g., "http://192.168.0.10" or
“192.168.0.10”), and then press Enter.
3. Enter the user name (default: admin) and password (default: admin) in the login page and click Confirm.
Network Settings: Click on Network->Basic->IPv4 Config
You can configure the network settings in the following ways:
DHCP: By default, the phone attempts to contact a DHCP server in your network to obtain its valid
network settings, for example, IP address, subnet mask, gateway address and DNS address.
Static IP Address: If the phone cannot contact a DHCP server for any reason, you need to configure IP
address, subnet mask, gateway address, primary DNS address and secondary DNS address for the phone
manually.
PPPoE: If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE mode.
Contact the ITSP for the PPPoE user name and password.
Configuring Your Phone
5
Note: Check with your system administrator if any error appears during the registration process or a specific configuration is required for your
registration.
E
N
G
L
I
S
H