G6037005R0
©
1.
2.
BKT-S
Bracket
1
2
3
1
2
3
2
2
2
3
3
G6037005R0
Copyright
©
2007 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form
without the written permission of ROLAND CORPORATION.
Check the parts
Before you begin assembly, check that you have
all of the parts.
ig.parts.eps
Holder(with rebber foot)
Screws(for attaching SonicCell)
Knob(for attaching PDS-10)
* A screwdriver is not included with this product.To fasten
screws (2) you will need to use a Phillips screwdriver.
Specifications
SonicCell stand and PDS-10 bracket
Dimensions
160 (W) x 178.4 (D) x 100 (H) mm
6-5/16 (W) x 7-1/16 (D) x 3-15/16 (H) inches
Materials
Iron
Weight
850g
1 lb 14 oz
<Others>
Accessories
Owner's Manual
Knob Bolt x 4
Screw x 2
* In the interest of product improvement, the specifications
and/or appearance of this unit are subject to change
without prior notice.
Attachment method
Attaching SonicCell
Use the included screws (2) to attach SonicCell
to the BKT-S (two locations).
In this state you can use the BKT-S as a table-top stand.
Attaching the BKT-S to the PDS-10 (pad stand)
1.
1. Using the included knob bolts (3), attach the
mounting plate (included with the PSD-10) to the
BKT-S (four locations).
2.
Fasten the mounting plate to the PSD-10.
Owner's Manual
Bracket
Before using this unit, carefully read the sections entitled: "USING THE UNIT SAFELY"
and "IMPORTANT NOTES".These sections provide important information concerning the
proper operation of the unit. Additionally,in order to feel assured that you have gained a
good grasp of every feature provided by your new unit, Owner's Manual should be read
in its entirety. The manual should be saved and kept on hand as a convenient reference.
1
2
3
1
2
3
2
3
* When using the PDS-10, spread the legs to
the maximum extent, and ensure that
the maximum height including
this product does not exceed 1 meter.
USING THE UNIT SAFELY
001
• Before using this unit, make sure to
read the instructions below, and the
Owner’s Manual.
..................................................................................................
013
• In households with small children, an
adult should provide supervision
until the child is capable of following all the
rules essential for the safe operation of the
unit.
..................................................................................................
014
• Protect the unit from strong impact.
(Do not drop it!)
115b
• Install the circuit board only into the
specified unit (SonicCell). Remove
only the specified screws during the
installation.
..................................................................................................
118b
• Keep the included scews and knobs
in a safe place out of children’s reach,
so there is no chance of them being
swallowed accidentally.
Maintenance
401a
• For everyday cleaning wipe the unit with a
soft, dry cloth or one that has been slightly
dampened with water. To remove stubborn
dirt, use a cloth impregnated with a mild,
non-abrasive detergent. Afterwards, be sure
to wipe the unit thoroughly with a soft, dry
cloth.
402
• Never use benzine, thinners, alcohol or
solvents of any kind, to avoid the possibility
of discoloration and/or deformation.
Additional Precautions
add
• Do not use screws other than those included.
Doing so may damage SonicCell.
Used for instructions intended to alert
the user to the risk of injury or material
damage should the unit be used
improperly.
* Material damage refers to damage or
other adverse effects caused with
respect to the home and all its
furnishings, as well to domestic
animals or pets.
Used for instructions intended to alert
the user to the risk of death or severe
injury should the unit be used
improperly.
The ● symbol alerts the user to things that must be
carried out. The specific thing that must be done is
indicated by the design contained within the circle. In
the case of the symbol at left, it means that the power-
cord plug must be unplugged from the outlet.
The symbol alerts the user to important instructions
or warnings.The specific meaning of the symbol is
determined by the design contained within the
triangle. In the case of the symbol at left, it is used for
general cautions, warnings, or alerts to danger.
The symbol alerts the user to items that must never
be carried out (are forbidden). The specific thing that
must not be done is indicated by the design contained
within the circle. In the case of the symbol at left, it
means that the unit must never be disassembled.
-
1
-
2
