KDK GCR14H 取扱説明書

Fault

Please check the following first.

If the problem persists after taken all these steps, disconnect power plug and call your dealer or

service center.

3Water is leaking.

Error Please ensure its contents

1Buttons do not operate.

7Clothes do not dry

completely.

2The Full Tank indicator is

flashing even though the

tank is not full.

4The tank does not fill up

with water.

(The unit is not

dehumidifying very well.)

5No water remains inside

the unit.

6It takes a long time to dry

clothes.

8The humidity does not

go down.

9Condensation forms all

the time, even during

dehumidifying.

10

The [ Rep ] indicator

flashes with error code

[11] displays.

Are the tank and float correctly installed inside the unit? (P.13, P.15)

Was the tank banged against the unit during insertion? (P.13)

→ Remove the tank and then reinstall it gently.

Has the unit been tilted or knocked over?

Was the unit moved while there was still water in the tank? (P.4)

Has the float come off? (P.15)

Is wet, cold air entering the room?

→ Keep doors and windows closed as much as possible while drying clothes.

Did prior clothes drying cycle complete?

Is wet, cold air entering the room?

→ Avoid open doors and windows as much as possible while drying clothes.

Is there a heater in use near the unit?

(If the surrounding temperature is too high, the sensor will be unable to

accurately judge the drying time.)

Is the air blowing onto the all clothes?

Are the clothes hung too closely together or in layers?

Is wet, cold air entering the room?

→ Avoid opening doors and windows while lanundry.

Is there other steam release equipment exists indoor?

Is machine body tilting?

→1. Disconnect the plug, lift machine body up straight and wipe waters

leaked

2. leave the machine idle for more than half a day (to dry the unit inside

completely in case any water has spilled inside)

3. connect the plug, run dehumidification again

Is machine body tilted too much?

→ Unplug the power plug and then reconnect it.

Is the Fan mode set? (P.8)

→ Fan mode will not retain water.

It may not be possible for dehumidifying to be fully effective if you place the

dehumidifier in some places such as near windows, or behind furniture

where air circulation is poor.

Is the Full tank indicator is flashing (P.13), or is The [ Rep ] indicator flashing?

(P.7), Key lock Set? (P.8)

Is the filter clogged (P.16), or is something blocking the air inlet or air outlet?

(P.4)

Are the room temperature and humidity low? (The unit dehumidifies less as

the room temperature and humidity become lower.)

Is the unit set to operate in “Auto” or “Mild” mode? (P.8)

If the temperature is outside the range of 7 ˚C ~ 40 ˚C , dehumidifier

operation will stop and become blower operation. (P.7)

18

11

There is hiss, squeak, or

water flow sound heard

This is the sound of refrigerant flowing within dehumidifier or nano-ion

generation and is not a failure.

In case of the following, disconnect the power plug and call service center or dealer

Error Please ensure its contents

12

The [ Rep ] indicator

lights (without flashing)

and prompts error code

(P.7 Repair)

Machine failure, please note down the error code and call service center or

dealer.

Emergency measures

Please have your power cord replaced by equipment manufacturer, service center, or

qualified technician for your own safety.

Please observe the rule

19GCR14H

In case of the following situations, remove power cord and call your dealer or service

center immediately.

 Poor switch operation.

 Leak switch or fuse cutout frequently.

 Power cord and plug over heated.

 Odor or noise during operation.

 Water leaks from host.

 Other error or failure.

Specifications

Model No.

DATE OF PURCHASE

DEALER'S ADDRESS

TELEPHONE NUMBER

SERIAL NO.

DEALER'S NAME

Customer's record

For model name and production number of this product, please refer to the back side of machine.

Please record them in the space provided and keep for future reference.

Temperature

Relative humidity

Power consumption by dehumidifier at standby mode: 0.8 W. (with power plug connected)

2018.10

C8041-2990

Model No.

Power supply

Power plug shape

Operating

condition

Dehumidification capacity (L/Day)

Power consumption (W)

Water tank capacity (L)

Weight (kg)

Dimensions (W X H X D) (mm)

The unit automatically stops at around 3.5 litres

26.7 ˚C

60 %

8.3

160

30 ˚C

80 %

14

182

GCR14H

220 V~ 50 Hz

315X580X225

13.0

20

KDK Company, Division of PES

Head office : 4017,Takaki-cho,Kasugai,Aichi,Japan

ページを読み込んでいます...

KDK GCR14H 取扱説明書

関連論文

その他の書類