– 19 –
5. Before First Use
1. Open the water tank cover, take out the water tank and clean.
2. Pour water into the water tank until the highest water level (reached “3500mL” position), and then
put it back into the main body.
3. After plugging the appliance into a socket outlet, turn on the power switch ( ) on the side
of the appliance. The buzzer will sound 1 time, all indicators will light on and then off, known as
the locked stage.
4. Remove the leak-proof rubber plug at the bottom of the water outlet.
5. Place a cup below the spout outlet (Capacity recommended over 300ml), press the safety lock key
[] 1 second to unlock, and press ambient water key [ ] once and final press water extraction
key [ ] to dispense water.
6. After the water is discharged, the cleaning procedure is completed.
Attention!
When the appliance starts to heat up the water, in order to avoid dry-heating and
protect the machine, please extract a cup of ambient water before choosing hot water.
* There could be a temperature deviation of ±3
* There could be a volume deviation of ±10%, the actual temperature and volume
depends on using environment and local tap water quality.
Attention!
Do not use hot water above 50 to cook or steam the water tank and which may
cause deformation.
Attention!
It is normal phenomenon that water droplets after the water is dispensed.
Attention!
In the first time of use, check whether there is water leaked from the product, and
check whether there is any abnormal noise, burnt or smoke. If you find any of the
above situations, stop using the appliance immediately and contact Shun Hing Electric
Service Center Limited for checking and repair.
WARNING!
Do not take out the water tank or let the water tank empty when plugged, otherwise,
there will be warning signal, dry-heating or fire.
5.1 Cold Water Function Activation
1. Open the water tank cover, pour 1000ml or above water into water tank.
2. Turn on the power switch ( ) and cold switch ( ) on the side of the appliance.
3. Touch the child lock [ ] for 1 second to unlock, and then long press the cold water key [ ] for 3
seconds. The buzzer will sound 1 time, the cold-water activation program is auto started. After 30
seconds, The buzzer will sound 2 times, and activation is completed.
CAUTION!
During activation process, do not turn off the power of the appliance.
4. The refrigeration indicator ( ) on the display panel will light up. After 5 minutes, there is a sense of
cold in the cold water. Cooling plant capacity stores approximately 500ml of water. The refrigeration
program completed after about 25 minutes, the indicator ( ) will light off.