X1D www.hasselblad.com/jp
15
2.4 FCC
Federal Communication Commission Interference Statement:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and
receiver.
● Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician
for help.
FCC Caution
Any changes or modications not expressly approved by the
party responsible for compliance could void the user’s authority
to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1 This device may not cause harmful interference, and
2 This device must accept any interference received, including
interference that may cause undesired operation.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. The highest SAR value as
reported to the authorities for the X1D-50c when tested for use
by the Body is 0.10 W/kg and Extremity is 0.33W/kg against a
limit of 1.6W/kg.
2.5 ISED
RSS-Gen Information for the Certication of Radio Apparatus
This device complies with ISED licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
1 This device may not cause interference, and
2 this device must accept any interference, including
interference that may cause undesired operation of the
device.
Cet appareil est conforme au(x) standard(s) RSS exempt(s)
de licence de ISED. Son fonctionnement est sujet aux deux
conditions suivantes:
1 cet appareil ne doit pas occasionner d’interférence
2 cet appareil doit supporter toutes les interférences, y
compris celles qui pourraient provoquer un mauvais
fonctionnement de cet appareil.
RSS-102 RF Exposure Compliance of Radiocommunication
Apparatus
The X1D-50c has been designed to comply with safety
requirements for exposure to radio waves. SAR testing has
been performed in accordance with RSS-102, with the X1D-
50c transmitting at its highest certied power level in all used
frequency bands. The highest Body SAR value for the X1D-
50c when tested was 0.10 W/kg against a limit of 1.6 W/kg.
Extremity SAR was measured to 0.33 W/kg.
Please follow the instructions included in the user guide for
product installation and use.
Le X1D-50c a été conçu pour se conformer aux exigences de
sécurité en matière d’exposition aux ondes radio.
Des tests SAR ont été effectués conformément à la RSS-
102 avec le X1D-50c transmettant à son plus haut niveau
de puissance certié dans toutes les bandes de fréquences
utilisées.
La valeur SAR la plus élevée pour la X1D-50c lors des tests
était de 0,10 W/Kg contre une limite de 1.6 W/kg. On a mesuré
l’extrémité SAR à 0,33 W/kg.
Merci de suivre les instructions fournies dans le mode d’emploi
pour l’installation et l’utilisation du produit.
2.6
E