Easythreed X3 3D Printer
Install Manual
This manual is written in accordance
with EasyThreed X3 3D printer。
Printer upgrades and equipment models
are slightly different, is a normal phenomenon,
based on the actual products received.
User’s manual inside TF card.
Parts List：Take out parts from package , check if all parts have as listed below。
`
1. Install the XZ Axis set to the Printer Base.
1. Put Z-axis
motor wire
through this
hole
2. Install it
downward in
the direction of
this arrow
2.After insert the XZ Axis, Fixed with 2 screws.
3. Connect the Z-axis motor line to the output line of the printer control box as
shown in the figure below..
Fixed with
screws
Z-axis motor
end-to-end
docking
4.Install the Filament Holder as below.
Important Notice：This filament holder can only hang on 250g weight filament.
connect the power and start the 3D printing journey.。
ShenZhen EasyThreed Technology CO.,LTD
http://www.easythreed.com
-
1
-
2
-
3
-
4
EasyThreed X3 3D Printer ユーザーマニュアル
- タイプ
- ユーザーマニュアル
- このマニュアルも適しています
他の言語で
- English: EasyThreed X3 3D Printer User manual