1
1
50% 30
300
2
b
b
3
1
OPEN
2
VOL
VOLUME 6
(FWD)
ϥREPEAT (REV)
p
FF•AMS
REW•AMS
ϥREPEAT
1 2
REP
FF•AMS
2
REW•AMS
2
z
❐
AMS—
FF•AMS REW•AMS
9
FF•AMS 1
AMS FF
REW•AMS 1
AMS REW
AMS 1
AMS 1 4
4
❐
( )
FUNCTION FF•AMS BL SKIP
BL SKIP
( )
• 12
FUNCTION FF•AMS BL SKIP
• 10
❐
* B NR
FUNCTION
p aNR B NR
aNR
*
DOLBY D
a
a
NR
z
HOLD
❐
SOUND
FUNCTION ϥREPEAT
SOUND/AVLS
MB/GRV
/
MB
/
GRV
MB GRV
GRV ( ) MB
(
)
❐
AVLS
FUNCTION REW•AMS AVLS
SOUND/AVLS
2 AVLS
AVLS
AVLS ( )
SOUND AVLS
-
z
•
BATT
(EIAJ*)
NC-6WM 9
(100% )
LR6 (WM) 36
45
R6P (SR) 9
*EIAJ ( )
•
•
1
2
AC AC-E15L )
AC-E15HG DC IN 1.5V
3
AC
AC AC-E15L AC-E15HG
(
EIAJ )
AC
AC-E15HG
z
10 (CHK-1)
3-861-030-01(2)
/
Operating Instructions/XXXX
Sony Corporation ©1997 Printed in Japan
WM-EX655
WALKMAN is a registered trademark of
Sony Corporation.
XXXX
• 45
•16 9 AMS 1
1
• 12
• AVLS
•
•
AC 100V
AC
( )
AC 100V 240V
2
2
VOL
1OPEN
2
1
ϥREPEAT
2VOLUME
FF•AMS
a NR
HOLD
HOLD
BL SKIP
REW
FF
p
FUNCTION
REW•AMS
2
HOLD
HOLD
2REMOTE
1
ϥREPEAT
1
SOUND/AVLS
ϥREPEAT
AVLS
REW•AMS
FUNCTION
GRV
MB
NC-6WM
R6P (SR)
AC
•
•
•
•
•
•
•
•
(60 )
( )
• (40 ) (0 )
•
•
90
OPEN OPEN
BL SKIP
( )
AVLS AVLS
( )
a
NR OFF 30 18,000 Hz (EIAJ
*
)
( )1
8 300
(DC ) 4 mW + 4 mW (EIAJ 32 )
DC 1.5 V
NC-6WM 1.2 V 600 mAh
Ni-Cd) 3 1
(EIAJ)
108.9 80 21.3 mm ( / / )
150 g
215 g ( NC-6WM C-60HF
)
AC AC-E15L ( ) AC AC-E15HG
(
) NC-6WM CHK-1
( ) MDR-E848V MDR-E837V
DCC-E215
*EIAJ ( )
•
•
• 1
(
) 6
House Current
Before using the Walkman, remove
the rechargeable battery if it is
installed. Attach the supplied
battery case and connect the AC
power adaptor AC-E15L for Japan
(not supplied) or AC-E15HG for
overseas (not supplied) to the DC
IN 1.5V jack of the battery case. Do
not use any other AC power
adaptor.
z Operating the
Walkman
Playing a Tape
1 Connect the micro plug
firmly to the remote control.
Then connect the remote
control firmly to the
2REMOTE jack and switch
the Hold function off.
If the earphone do not fit to
your ears or the sound is
unbalanced, turn round the
earphone a little to fit to your
ears firmly.
2 Open the cassette holder and
insert a cassette.
3 Press œ(play)•REPEAT
and adjust the volume with
the volume dial.
Note
• When the tape is playing, the
cassette holder does not open.
To Press
change the tape ϥREPEAT
transport (during playback)
direction
stop the tape p (stop)
fast-forward the FF•AMS
tape (in the stop mode)
rewind the tape REW•AMS
rapidly (in the stop mode)
repeat the ϥREPEAT
current track (2 seconds or more
(Repeat Single during playback)
Track function)
To stop a single
repeat, press it again.
listen to the next FF•AMS (shortly/
track/succeeding repeatedly during
tracks from the playback)
beginning
(AMS* function)
listen to the REW•AMS
current track/ (shortly/
previous tracks repeatedly during
from the playback)
beginning
(AMS function)
listen to the FF•AMS
other side of the (2 seconds or more
cassette from the in the stop mode)
beginning (Skip
reverse function)
listen to the REW•AMS
currently played (2 seconds or more
back side of the in the stop mode)
cassettes from the
beginning (Auto
rewind play
function)
* Automatic Music Sensor
To skip a long space
between tracks (BL SKIP
function)
While holding down FUNCTION,
press the FF•AMS button. The BL
SKIP indicator will be lit.
To cancel the BL SKIP mode, hold
down FUNCTION and then press
FF•AMS. Then the BL SKIP
indicator goes off.
English
Notes on BL SKIP
• For the BL SKIP function, you need a
blank of 12 seconds or longer
between the tracks. Therefore, if
there is noise between the tracks,
these functions will not detect the
blank and will not operate.
Likewise, if the recording level is
moderately low within a track, this
function may inaccurately operate.
• You need a blank of 10 seconds or
longer at the beginning of each side
of the cassette. Otherwise, the first
track will be skipped and will not be
played back.
When you are listening to a
tape recorded with the
Dolby*B NR system
While holding down FUNCTION,
press p. a NR indicator will be lit.
To cancel the Dolby function, hold
down FUNCTION and then press
p. Then the a NR indicator goes
off.
* Dolby noise reduction manufactured
under license from Dolby
Laboratories Licensing Corporation.
“DOLBY” and the double-D symbol
a are trademarks of Dolby
Laboratories Licensing Corporation.
If the cassette holder does
not open
When you remove the power sources
during playback, or when you use
exhausted dry or rechargeable battery,
the cassette holder may not open. In
this case, set the power sources again,
or replace the exhausted battery with a
new one.
Using Other
Functions
To lock the controls
—Hold function
Slide the HOLD switch in the direction
of the arrow to lock the controls of the
Walkman or the remote control.
To emphasize bass sound
—Sound function
While holding down FUNCTION,
press ϥREPEAT repeatedly.
On the remote control, press SOUND/
AVLS repeatedly.
With each press, the MB/GRV
indicators (or indication in the display
of the remote control) change as
follows:
MB (MEGA BASS): emphasizes
bass sound
GRV (GROOVE): emphasizes
deeper bass sound
indicator off (or no message in the
display): off (normal)
To adjust the sound to an
appropriate level
—AVLS (Automatic Volume
Limiter System) function
While holding down FUNCTION,
press REW•AMS. The AVLS indicator
will be lit. On the remote control, press
SOUND/AVLS for two seconds or
more. Then “ ” will appear in the
display.
To cancel the AVLS, press REW•AMS
once while holding down
FUNCTION. Then the AVLS indicator
goes off. On the remote control, press
SOUND/AVLS again until “
”
disappears from the display.
1
2
3
4
9
6
!¡
!º
!™
!£
8
7
5
L R
!º
!¢
3
8
!∞
1
OPEN
2
3
4
5
BL SKIP
6
AVLS
7
FUNCTION
8
HOLD
9
MB/GRV
!º
VOLUME
VOL
!¡
BATT
!™
2REMOTE
!£
a (DOLBY) NR
!¢
SOUND/AVLS
!∞
XXXX
1 90
Before operating the unit, please
read this manual thoroughly
and retain it for future reference.
z Getting Started
Choosing Power
Sources
Dry Battery
Attach the battery case to the
Walkman, and then insert one R6
(size AA) battery (supplied) with
correct polarity.
Note
• Do not charge a dry battery.
Rechargeable Battery
1 Before using the rechargeable
battery, you must charge it
with the supplied battery
charger.
Japanese model: Full-
charging takes about 2 hours.
World model: 50%-charging
takes about 30 minutes. Full-
charging takes about 60
minutes (then the charge
lamp goes off).
2 Open the rechargeable
battery compartment lid at
the left side of the Walkman
and insert the charged
battery.
You can charge the battery
about 300 times.
Notes
• Do not tear off the film on the
rechargeable battery.
• Remove the charger unit from the
wall outlet as soon as possible after
the rechargeable batteries has been
charged. Overcharging may damage
the rechargeable battery.
• Only the NC-6WM (supplied) can be
used with the supplied battery
charger.
• The battery charger and the
rechargeable battery may become
warm during charging, but it is not a
problem.
• Be sure not to short-circuit the
battery. When you carry it with you,
use the supplied carrying case. If
you do not use the carrying case, do
not carry with other metallic objects
such as keys in your pocket.
Battery life (Approx. hours)
Rechargeable NC-6WM 9
fully charged
Sony R6P (SR) 9
Sony alkaline LR6 (WM) 36
Rechargeable NC-6WM 45
Sony alkaline LR6 (WM)
used together
Note
• The battery life may shorten
depending on the operation of the
unit.
For maximum performance we
recommend that you use an alkaline
battery.
/