1
6
2
3
4
8
9
!º
!¡
7
5
!™
5
7
8
2
!£
1
OPEN ( )
2
3
4
5
6
BATT ( )
7
HOLD ( )
8
VOLUME ( )
VOL
9
Åa ( )•BL SKIP
0
a (DOLBY) NR
!⁄
2REMOTE ( )
!™
!£
SOUND/AVLS
L R
14
3
2
7
5
6
5
7
3
1
2
3
4
5 p•
6
7 •
1
BAND•RADIO ON
2
ENTER PRESET
3
AREA 1 BAND•RADIO ON
4
PRESET
USA Eur ENTER
87.50MHz PRESET 1
USA FM: 87.5 108MHz
AM: 530 1,710kHz
Eur FM: 87.5 108MHz
AM: 531 1,602kHz
5
1 A ASP
AM FM
6
BAND•RADIO ON AM FM
PRESET
3 ENTER
ASP
z
HOLD
❐
SOUND
SOUND/AVLS
/
MB
/
GRV
GRV ( ) MB
(
)
❐
1
2
ENTER PRESET
3
PRESET
TUNE
4
ENTER
5
PRESET
ENTER
TUNE
ENTER
❐
11
ASP
11
1
BAND•RADIO ON
2
COPY11 BAND•RADIO ON
AM FM TV 11
11
ENTER
PRESET
BAND
RADIO
ON
2 AREA 1
PRESET AREA11
ENTER
(60 )
( )
(40 ) (0 )
90
OPEN OPEN
BL SKIP
OFF
ASP (
( )
(
) )
AVLS
a
NR OFF 30 18,000 Hz (EIAJ )
( )1
8 300
(DC ) 3 mW + 3 mW (EIAJ 32 )
DC 1.5 V
( NC-6WM 1.2 V 600 mAh Ni-Cd)
3 1
(EIAJ)
108.7 80.0 23.5 mm ( / / )
150 g
210 g ( NC-6WM C-60HF
)
FM 76.0 90.0MHz
AM 531 1,710kHz
TV
1 12ch
AC AC-E15L ( ) AC AC-E15HG (
) NC-6WM CHK-1
( ) MDR-E848MP MDR-E868MP
MDR-E847MP DCC-E215
*EIAJ ( )
•
•
• 1
(
) 6
L R
English
z Getting Started
Choosing Power
Sources
Using with a Dry Battery
Attach the battery case to the
Walkman, and then insert one R6
(size AA) battery (supplied) with
correct polarity.
Using with a
Rechargeable Battery
1 Before using the rechargeable
battery, you must charge it
with the supplied battery
charger.
Japanese model: Full-
charging takes about 2 hours.
World model: 50%-charging
takes about 30 minutes. Full-
charging takes about 60
minutes (then the charge
lamp goes off).
2 Open the rechargeable
battery compartment lid at
the left side of the Walkman
and insert the charged
battery.
Battery life (Approx. hours)
Rechargeable NC-6WM
fully charged
Playback 10
Radio/TV reception 9
Sony alkaline LR6 (WM)
Playback 36
Radio/TV reception 29
Sony R6P (SR)
Playback 10
Radio/TV reception 9
Rechargeable NC-6WM
Sony alkaline LR6 (WM)
used together
Playback 45
Radio/TV reception 36
Notes
• Remove the charger unit from the
wall outlet as soon as possible after
the rechargeable battery has been
charged. Overcharging may damage
the rechargeable battery.
• Only the NC-6WM rechargeable
battery (supplied) can be used with
the supplied battery charger.
• Be sure not to short-circuit the
battery. When you carry it with you,
use the supplied carrying case. If
you do not use the carrying case, do
not carry with other metallic objects
such as keys in your pocket.
Using on AC Power
Before using the Walkman, remove
the rechargeable battery if it is
installed. Attach the supplied
battery case and connect the AC
power adaptor AC-E15L for Japan
(not supplied) or AC-E15HG for
overseas (not supplied) to the DC IN
1.5V jack of the battery case. Do not
use any other AC power adaptor.
Listening to the
Radio
1 Connect the micro plug
firmly to the remote control.
Then connect the remote
control firmly to the
2REMOTE jack and switch
the Hold function off.
2 Press BAND•RADIO ON to
turn on the radio.
3 Press ASP button until
“AREA” will be displayed.
4 After the FM frequency and
“PRESET 1” is displayed,
press BAND•RADIO ON to
select AM, FM or TV.
5 Press PRESET+/– to select
the preset number you wish
to listen to and adjust the
volume using the volume
dial.
To turn off the radio, press
p•RADIO OFF.
Next time you listen to the
radio in the same area, you
can skip step 3.
To improve radio reception
When you are listening to FM or
TV, extend the earphones cord for
better reception. When you are
listening to AM, rotate the unit
horizontally for optimum reception.
When you are listening to an
FM stereo broadcast
Set the FM ST/MONO selector to
ST (stereo).
If the reception is poor, set it to
MONO (monaural).
What the ASP button does
(ASP function)
This Walkman stores the main
stations of nine areas of Japan
(Sapporo, Sendai, North Kanto,
South Kanto, Nagoya, Osaka,
Hiroshima, and Fukuoka and
Shinkansen). You can tune in the
originally stored stations by simply
pressing the ASP button. If you are
out of the areas when you press the
ASP button, the Walkman searches
and stores receivable stations
automatically.
If the ASP function does not store
the desired station, or you want to
customize the preset number of the
stations, see Tuning in the Radio
Manually or Storing Radio Stations
Manually and Receiving the Stations
as following.
Tuning in the Radio
Manually (Manual tuning)
Turn on the radio and select the
desired band. Then press TUNE +/–.
If you press and hold TUNE +/– for
more than few seconds, the
Walkman will start tuning the
stations automatically.
Receiving Stations
Outside Japan
1 Press BAND•RADIO ON to
turn on the radio.
2 Press ENTER. The frequency
numbers, "PRESET" and a
preset number will flash in
the display.
3 Press and hold
BAND•RADIO ON until
“AREA 1” flashes in the
display.
4 While “AREA 1” is flashing,
press PRESET+/– repeatedly
to select either area “USA”
(USA, Canada and Central
and South America) or “Eur”
(Europe and other countries)
and then press ENTER.
5
Press and hold ASP until “1”
changes to “A”, to store the
radio stations (both AM and
FM) automatically.
The Walkman starts searching
and storing stations.
6 Press BAND•RADIO ON to
select the desired band and
press PRESET+/– to select a
station.
Storing Radio Stations
Manually and Receiving
the Stations (Manual-
Memory function)
1 Turn on the radio and select
the desired band.
2 Press ENTER. The frequency
numbers, “PRESET” and a
preset number will flash in
the display.
3 While the frequency
numbers, “PRESET” and the
preset number is flashing,
tune in to a station you wish
to store using TUNE+/–, and
select a preset number on
which you wish to store a
station using PRESET+/–.
4 While the frequency
numbers, “PRESET” and the
preset number are flashing,
press ENTER.
5 Tune in to a station using
PRESET+/–.
Notes
• If you cannot complete step 3 or 4
while the indications are flashing,
repeat from step 2.
• If you preset automatically using
ASP, the stations stored before will
be erased.
To cancel the stored station
Operate the unit according to the
steps in Storing Radio Stations
Manually and Receiving the Stations
from step 1 to step 3. Instead of
tuning in to a station, press and
hold TUNE+/– until “----” is
displayed. Then press ENTER
while “----” is flashing.
Using Other Functions
To lock the controls
—Hold function
Set the HOLD switch to the
direction of the arrow to lock the
controls.
To emphasize bass sound
—SOUND function
Press SOUND/AVLS repeatedly.
With each press, the indications
change as follows.
MB : emphasizes bass sound
GRV : emphasizes deeper bass
sound
No message: off (normal)
To adjust the sound to an
appropriate level
—AVLS (Automatic Volume
Limiter System) function
To limit the maximum volume,
press and hold SOUND/AVLS for
two seconds or more.
“ ” will appear in the display.
z Operating the
Walkman
Playing a Tape
1 Connect the micro plug
firmly to the remote control.
Then connect the remote
control firmly to the
2REMOTE jack and switch
the Hold function off.
If the earphones do not fit to
your ears or the sound is
unbalanced, turn round the
earphones a little to fit to
your ears firmly.
2 Open the cassette holder and
insert a cassette.
3 Press œ(play)•REPEAT
and adjust the volume with
the volume dial.
Note
• When the tape is playing, the
cassette holder does not open.
To Press
change the tape ϥREPEAT
transport (during playback)
direction
stop the tape p (stop)
fast-forward the FF•AMS
tape (in the stop mode)
rewind the tape REW•AMS
rapidly (in the stop mode)
repeat the ϥREPEAT
current track (2 seconds or more
(Repeat Single during playback)
Track function) To stop a single
repeat, press it again.
find the beginning FF•AMS (once/
of the next track/ repeatedly
succeeding 3 tracks during
(AMS* function) playback)
find the beginning REW•AMS
of the current track/ (once/repeatedly
previous 2 tracks during playback)
(AMS function)
play the same side REW•AMS
from the beginning (2 seconds or more
(Auto Rewind in the stop mode)
Play function)
play the other side FF•AMS
from the beginning (2 seconds or more
(Skip Reverse in the stop mode)
function)
* Automatic Music Sensor
To select a tape playing
mode
Use the Åa (playback
mode)•BL SKIP (blank skip)
selector as follows:
To Set the
selector to
playback both sides a•ON
repeatedly, switch the
BL SKIP on (fast-forward
the tape to the next track
if there is a blank space
longer than 12 seconds)
playback both sides Å•OFF
once from the side
facing the tape holder,
switch the BL SKIP off
When you are listening to a
tape recorded with the
Dolby*B NR system
Set the a NR (Dolby noise
reduction) selector to ON.
* Dolby noise reduction manufactured
under license from Dolby
Laboratories Licensing Corporation.
“DOLBY” and the double-D symbol
a are trademarks of Dolby
Laboratories Licensing Corporation.
PRESET
1 90
BAND•RADIO ON
❐
AVLS
SOUND/AVLS 2
AVLS
AVLS
SOUND AVLS
z
BATT
NC-6WM (100% ) 10 9
LR6 WM 36 29
45 36
R6P (SR) 10 9
•
1
2
AC AC-E15L )
AC-E15HG DC IN 1.5V
3
AC
AC AC-E15L AC-E15HG
(
EIAJ )
AC
AC-E15HG
z
10 CHK-1
BAND•RADIO ON
TUNE
ENTER
BAND•RADIO ONPRESET
ASP
SOUND/AVLS
HOLD
HOLD
ENTER