Philips DLP6100V/93 重要情報

カテゴリー
パワーバンク
タイプ
重要情報
User manual
用户手册
Register your product and get support at
www.philips.com/support
DLP6100V
Power Bank
1
EN Power button
ZHCN
电源按钮
EN Charging port
ZHCN
充电端口
EN Output port |
ZHCN
输出端口
LED
>90%
60%-90%
30%-60%
10%-30%
LED
2
EN Sold separately
ZHCN
分开售卖
3
5V 2.1A
5V
1A
EN
Why can my power bank not be charged?
If the power status light goes off within 30
seconds,
• Press to start charging a few more times.
• Change the micro-USB cable.
If neither of these steps are successful, the power
bank’s battery has exceeded its lifetime and the
power bank needs to be replaced.
Why does the device connected to my
power bank not charge?
If the power status indicator light goes off after a
minute of charging, your device’s current power
consumption exceeds the specifications of your
power bank.
If the power status light is blinking couple of times
before going off, charge the power bank for a
second to reset the short circuit protection mode.
If the phenomena still persists, stop charging
with the power bank. Your device may have
internal short circuit, or its current consumption is
extremely high.
ZH-CN
为什么无法对我的移动电源进行充电?
如果电量指示灯在
30
秒内熄灭,
多充电数次。
更换
micro-USB
连接线。
如果这两个步骤都不成功,则表示电池已经超过
其寿命,需更换移动电源。
为什么我无法为连接移动电源的数碼设备充电?
如果在充电一分钟后电量指示灯熄灭,则数碼设
备的当前功耗超出了移动电源的规格。
如果电量指示灯在熄灭前闪烁数次,请对电源组
充电一秒钟,以重置短路保护模式。
如此现象仍然存在,请停止使用移动电源充电。
您的数碼设备可能内部短路,或其电流消耗极高。
UM_DLP6100V
93_2L_V1.0
WK17111
2017 © Gibson Innovations Limited. All rights reserved.
This product has been manufactured by, and is
sold under the responsibility of Gibson Innovations
Ltd., and Gibson Innovations Ltd. is the warrantor in
relation to this product.
Philips and the Philips Shield Emblem are registered
trademarks of Koninklijke Philips N.V. and are used
under license from Koninklijke Philips N.V.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9

Philips DLP6100V/93 重要情報

カテゴリー
パワーバンク
タイプ
重要情報