Quick Start Guide
SB300
Specications are subject to change without notice.
This product has been manufactured by, and is
sold under the responsibility of WOOX Innovations
(Shanghai) Commercial Company Ltd., and WOOX
Innovations (Shanghai) Commercial Company Ltd., is
the warrantor in relation to this product.
Philips and the Philips Shield Emblem are registered
trademarks of Koninklijke Philips N.V. and are used
under license.
SB300_93_QSG_V1.0
在以下网站上注册产品并获得支持
www.philips.com/support
3 sec.
User Manual
PDF
www.philips.com/support
www.philips.com/support
Philips SB300
3 sec.
123-456-7890
快速使用指南
Quick Start Guide
便携式扬声器
简体中文
1
重要事项
• 仅使用制造商指定的附件
/
配件。
• 不可将电池置于高温环境，如阳光直射处、
明火或类似环境。
• 不要将任何危险源放在本装置上（例如点
燃的蜡烛）。
• 仅当
USB/AUDIO-IN
插孔盖完全盖
好时，产品才能达到
IPX7
防水标准。
• 产品工作温度为
-10
°
C
到
40
°
C
。
• 产品只支持
USB V2.0
或
V1.1
。
注意：
铭牌（铭牌上的信息包括工作电压）位
于产品背面，使用前请先了解铭牌上的
相关信息。
2
声明
如果用户未经
Gibson Innovations
的明确
许可而擅自对此设备进行更改或修改，则可能
导致其无权操作此设备。
弃置旧产品
本产品采用可回收利用的高性能材料和
组件制造而成。
弃置产品时，请不要将其与一般生活垃
圾一同丢弃，应将其交给政府指定的回收中心
或回收。这样做有利于环保。
警告：拆卸内置电池将使保修失效，并可能毁
坏本产品。
务必让专业人员拆卸产品中的内置电池。
蓝牙
®
字样和徽标均为
Bluetooth SIG, Inc.
所
有的注册商标，
Gibson
Innovations Limited
对此类字样和徽标的
任何使用均已获得许可。其它商标和商品名称
均属于它们各自的所有者。
3
规格
• 额定输出功率（功放器）：
4W RMS
≤
1% THD
• 声频响应：
110-16000 Hz
• 扬声器驱动器：
1.5
英寸全频，
4
Ω
• 低音增强：
2
个无源辐射器
• 蓝牙版本：
V4.0
• 支持的蓝牙配置文件：
HFP V1.6
、
A2DP V1.2
、
AVRCP V1.4
• 蓝牙频段
/
输出功率：
2.400 GHz
~
2.483 GHz ISM
频段
/
≤
4 dBm
（
2
类）
•
AUX
输入电平：
500
毫伏
±
100
毫伏
• 防水等级：
IPX7
• 电池：内置锂离子充电电池（
3.7
伏，
800
毫安时）
• 电池供电模式下的播放时间：约
8
小时
• 充电时间：约
3
小时
•
USB
充电：
5
伏，
500
毫安
/A
型插孔
• 产品尺寸（宽
x
高
x
厚）：
117 x 77 x 74
毫米
• 产品重量：
0.23
千克
4
故障排除
不能通电
• 闲置
15
分钟后，为了节省电量，扬声器会
自动关闭。
• 电池电量不足时，红色
LED
指示灯会闪烁
10
分钟。这时请为您的扬声器充电。
LED
指示灯行为（红色）
• 电池电量不足：呈红色闪烁
10
分钟，然后
关闭（在开机模式下）；
• 正在充电：呈红色持续亮起；
• 充满电：红色指示灯关闭。
无法与您的蓝牙设备配对
• 按住
3
秒钟进入蓝牙配对模式。
LED
指示灯行为（蓝色）
• 配对就绪：呈蓝色快速闪烁；
• 当连接先前连接的设备时：
呈蓝色缓慢闪烁；
• 连接后：呈蓝色持续亮起。
如何使用免提通话
• 按下
可接听来电。
• 按住
3
秒钟可拒接来电。
• 通话时，按下
可结束当前通话。
• 通话时，按住
3
秒钟可将通话转接至移
动设备。
注意：
若有来电，音乐播放会暂停。
播放我的
MP3
播放器中的音乐时没有声音
• 确保通过蓝牙播放的音乐已停止运行。
English
1 Important
• Only use attachments/accessories
specied by the manufacturer.
• The battery shall not be exposed to
excessive heat such as sunshine, re or
the like.
• Do not place any sources of danger on
the apparatus (e.g. lighted candles).
• The product can meet IPX7 waterproof
standard only when the USB/AUDIO-IN
socket cover is covered seamlessly.
• The operation temperature of the
product is from -10 °C to 40 °C.
• The product supports USB V2.0 or V1.1 only.
Note: The type plate is located on the back
of the product.
2 Notice
Any changes or modications made to this
device that are not expressly approved by
Gibson Innovations may void the user’s
authority to operate the equipment.
Disposal of your old product
Your product is designed and
manufactured with high quality
materials and components, which can
be recycled and reused.
Do not throw away the product with the
normal household waste at the end of its
life, but hand it in at an ocial collection
point or recycling. By doing this, you help to
preserve the environment.
Caution: Removal of the built-in battery
invalidates the warranty and may
destroy the product.
Always bring your product to a professional
to remove the built-in battery.
The Bluetooth
®
word
mark and logos are
registered trademarks
owned by Bluetooth SIG, Inc. and any use of
such marks by Gibson Innovations Limited
is under license. Other trademarks and trade
names are those of their respective owners.
3 Specifications
• Rated Output Power (Amplier):
4W RMS ≤ 1% THD
1
93_version
○：
表示该有害物质在该部件所有均质材料中的含量均在 GB/T 26572 标准规定的限量要求以下。
O:
Indicates that this hazardous substance contained in a
ll of the homogeneous materials for this
part is below the limit requirement in GB/T 26572.
×：
表示该有害物质至少在该部件的某一均质材料中的含量超出 GB/T 26572 标准规定的限量要求。
X:
Indicates that this hazardous substance contained in a
t least one of the homogeneous materials
used for this part is above the limit requirement in GB/T 26572.
环保使用期限 Environmental Protection Use Period
部件名称
Name of the Parts
铅 (Pb,
Lead)
汞 (Hg,
Mercury)
镉 (Cd,
cadmium)
六价铬(Chromium
(VI))
多溴联苯
(PBB)
多溴二苯醚
(PBDE)
Housing
外壳
O
O O O O O
Loudspeakers
喇叭单元
O O O O O O
PWBs
电路板组件
X
O O O O O
Accessories
(Cables)
附件
（电源线，连接线）
X
O O O O O
本表格依据SJ/T 11364的规定编制。
The table is compiled according to SJ/T 11364.
有害物质
Hazardous Substances
产品中有害物质的名称及含量
Names and Contents of Hazardous Substances
这标志表示的期间（10年）是电子电气产品中有害物质在正常使用的条件下不会发生外泄或突变，
电子电气产品用户使用该电子电气产品不会对环境造成严重污染或对其人身、财产造成严重损害的
期限。
This logo refers to the period ( 10 years ) during which the ha
zardous substances in electronic and
electrical products will not leak or mutate so that the use of
these [substances] will not result in
any severe environmental pollution, any bodily injury or damage
to any assets.
93 Rosh table.indd 1 1/14/2015 10:24:16 AM
• Acoustic Frequency Response:
110-16000 Hz
• Speaker Driver: 1.5” full range, 4 Ω
• Bass Enhancement : 2 x passive radiator
• Bluetooth Version: V4.0
• Bluetooth Supported Proles:
HFP V1.6, A2DP V1.2, AVRCP V1.4
• Bluetooth Frequency Band / Output
Power: 2.400GHz ~ 2.483GHz ISM Band /
≤ 4dBm (Class 2)
• AUX Input Level: 500mV±100mV
• Water Resistance: IPX7
• Battery: Built-in Li-ion rechargeable
battery (3.7V, 800 mAh)
• Play Time in Battery Mode: Approx. 8 hours
• Charging Time: Approx. 3 hours
• USB Charging: 5V, 500mA / Type-A socket
• Product Dimensions (W x H x D):
117 x 77 x 74 mm
• Product Weight: 0.23 kg
4 Troubleshooting
No power
• The speaker switches o automatically
for power saving when being idle for 15
minutes.
• The red LED indicator ashes for
10 minutes when the battery is low.
Recharge your speaker.
LED indicator behavior (red)
• Low battery: ashing red for 10 minutes,
then turn o (in power-on mode);
• Under charging: solid red;
• Fully charged: no light.
Cannot pair with your Bluetooth device
• Press and hold for 3 seconds to enter
pairing mode.
LED indicator behavior (blue)
• Ready for pairing: ashing blue quickly;
• When connecting the previously
connected device: f
lashing blue slowly;
• When connected: solid blue.
How to use handfree call
• Press to answer an incoming call.
• Press and hold for 3 seconds to reject
an incoming call.
• During a call, press to end the current call.
• During a call, press and hold for
3 seconds to transfer the call to your
mobile device.
Note:
Music play pauses when there is an
incoming call.
No sound while playing my MP3 player.
• Make sure that music playback through
Bluetooth is stopped.
-
1
-
2
他の言語で
- English: Philips SB300B/93 Quick start guide