15.6寸屏
15.6 - inch
screen
产品规格表Item Specification 各部件名称
Component Name
使用说明书
15口机柜1
主板型号(Mainboard Model) ：RK3288A
CPU ：RK3288, 四核 (Quad-core) ，主频(main
frequency) 1.8GHz，And roid 5.1.1
Operating Instruction
5 slots station
注：机柜包装箱不含移动电源
Note: The station packing case does not
contain a power supply
产品特点product feature
本产品适合于公共场所及店铺中为客人提供共享充电服务的充
电及控制机柜，产品正面15.6寸LCD 显示屏幕。
This product is suitable for charging and control cabinets that
provide shared charging services for guests in public places and stores.
The front of the product has a 15.6- inch LCD display screen.
扣手Handle
喇叭trumpet
15.6寸屏
15.6 - inch
screen
充电宝
底座
power bank
产品名称 product name
型号 model
尺寸 size
支持通讯
communication support
机柜输入电压
station input voltage
机柜输入最大电流
Maximum station input current
机柜额定功率
Rated cabinet power
AC电源适配器输入
AC power adapter input
螢幕
机柜输出
power output
screen
5V1.5A*15口
100Vac-240Vac（60Hz/60Hz）
1.31A（满载状态）/0.41A（待机状态）1.31A(full load) /0.41A(standby)
300W（充电宝充电状态）(Charging status of the power bank)
220V/50hz
4G WIFI 2G
15.6英寸15.6-inch
15.6寸广告机15.6
150cm（L）*22.1cm（W）*28.8cm（H）
inch advertising machine
YBT-001
电源孔位指示灯
轴视图Axis view
Power socket indicator
pedestal
1.将AC电源线连接机柜背面的输入口。
2.接AC线接入电源插座。
3.15.6寸屏幕亮起启动安卓屏幕进入广告界面。
4.自动连接上网络后，有充电宝的孔位指示灯常亮，没有充电宝的孔位指示 灯熄灭。
1.Connect the AC power cord to the input port on the back of the cabinet .
2. Connect the AC cord to the power outlet .
1.消费者找到附近网点，将充电宝触点朝充电站孔位插入机柜中，并按到底。
2.充电宝正常归还后，机柜对应的孔位指示灯常亮。证明充电宝归还成功
3.消费者APP提示归还成功，根据借出于归还时间计算租借费用与退押金。
4.
100%
1. Consumers find a nearby outlet, insert the charging treasure contacts into the cabinet towards
the hole of the charging station, and press in the end.
2. After the power bank is returned normally, the indicator light of the corresponding hole in the cabinet
is always on. Prove the successful return of the power bank
3. The consumer APP prompts that the return is successful, and calculates the rental fee and the refund
of the deposit according to the return time of the loan.
4: Returning the power bank will establish serial communication with the main board of the cabinet.
After the communication hand shake protocol is consistent, the
charging module will be activated to charge the power bank until the power of the power bank is 100%,
and the charging will be stopped.
3.The 15.6-inch screen lights up to start the Android screen and enter the advertising interface.
4. After connecting to the network auto matically the in dicator light of the holeposition with the,
power bank is always on, and the indicator light of the hole position without the power bank is off
首次上电
还充电宝
return power bank
first time to electricity
各部件名称 Component Name
电源开关
power switch
AC电源线插孔
AC power cable
jack
故障及处理方法 Fault and handling methods使用方法HOW TO USE 各装箱明细 Packing details
服务热线service hotline：
售后服务 After-sales service
借充电宝
Renting power bank
15.6寸广告机1台
15.6 inch advertising 1 machine set
AC电源线1条
AC power cable 1PCS
说明书1本
Manual 1 PCS
服务地址 service address ：
电子元器件可回收再利用
请勿将本产品投入火中
请勿随意丢弃在垃圾桶，需专业回收处理
Electronic components can be recycled
Do not throw this product into fire
Do not throw it away in the trash can. It should be recycled
professionally
注意事项 Notice
处理方法
handling method
插紧或更换插头
Insert tightly or replace the plug
1
2
3
故障现象
fault phenomenon
插上电源线，显示屏及指示灯不良
Plug in the power cord , the display
screen and indicator light are not
working
故障原因
fault cause
网络异常
network anomaly
network anomaly
充电宝检测失败
Failed to detect the
power bank
插头未插紧
plug is not firmly
inserted
网络异常
充电宝插入机柜立即又弹出
The power bank pops out
immediately after being inserted
into the cabinet
充电宝归还后，APP未收
到归还成功提示
Afte rthe power bank is returned,
the APP does not receive as uccessful
return message
清理充电宝触点，再次尝试归还
Clean the charging pad and try to return it
重新拔插电源，重新联网或联系客服收到结束订单
again
重新拔插电源，重新联网
Re-plug the power supply and reconnect the network
Plug in the power again , reconnect
the Internet or contact customer service to receive the end of the order
后视图rear view
底座pedestal
锁lock
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and
operated with minimum 20cm distance between the radiator and your body: Use only the supplied
antenna.
/
