ページを読み込んでいます...
1
40561734 1*PD
Concerning added functionality
A new feature has been added since the “MC-909 Owner’s Manual”
was printed. The additions are as described below.
•
P. 127 “Panel/Controller” table
Add the following parameters in the [F2 (TTE/Tap/DB)] section.
(Procedure: [MENU]
→
“System”
→
[F1 (Panel/Control)]
→
[F2 (TTE/Tap/DB)])
•
MC-909
D Beam Sens L
0–127 Sensitivity of the D Beam controllers
The sensitivity of the D Beam controller will
change depending on the amount of light in
the vicinity of the unit. If it does not function
as you expect, adjust the sensitivity as appro-
priate for the brightness of your location.
Increasing this value will raise the sensitivity.
D Beam Sens R
/