Gigabyte GC-WB150 取扱説明書

タイプ
取扱説明書

このマニュアルも適しています

12WE6-WIFIBT-10AR
GC-WB300D
GC-WB150
Installation Guide/ //
トール ガ
Antenna Connector
线接端口
アンナ コネクタ
Antenna Connector
线接端口
アンナ コネクタ
WIFI/Bluetooth Card
WIFI/
WIFI/Bluetooth カード
USB Port
USB
USB接端口
USB ポー
(Only for GC-WB300D)
USB Connector
USB
USB接端口
USB コネクタ
Antenna
/天线
アンテナ
USB Cable
USB/ 排线
USB ケーブル
* The photos are for reference only.
Installing the WIFI/Bluetooth Card/ WIFI/
安装WIFI/蓝牙/ WIFI/Bluetooth ードの イスト
Step 1:
Install the WIFI/Bluetooth card in a PCI Express x1 slot.
Connect one end of the USB cable to the USB connector
on the WIFI/Bluetooth card.
WIFI/ PCI Express x1
USB WIFI/ USB
骤一
先将WIFI/装至PCI Express x1
USB排线端接WIFI/卡的USB连接
座。
テップ 2:
WIFI/Bluetooth カードを PCI Express x1 スロットに装着しま
す。 USB ケーブルの一方の端を WIFI/Bluetooth カードの
USB コネクタに接続します。
Step 2:
Connect the other end of the USB cable to the F_USB con-
nector on the motherboard.
USB F_USB
再将USB线端接至主板F_USB座。
テップ 2:
USB ケーブルのもう一方の端をマザーボードの F_USB
コネクタに接続します。
Step 3:
Tighten the two antenna cables to the antenna connectors
on the WIFI/Bluetooth card respectively.
WIFI/
骤三
天线分别WIFI/卡的天线连接
テップ 3:
2 本のアンテナケールをそれぞれ WIFI/Bluetooth カード
のアンテナ コネクタにピンと張るように接続します。
Step 5:
After the computer starts, install the driver for the WIFI/Bluetooth card. Adjust your wireless LAN conguration
based on your environment after installing the driver.
WIFI/
电脑后请WIFI/动程序完成后依环境无线络选择连接。
テップ 5:
コンピータの起動後WIFI/Bluetooth カードのドライバーをイストールします ドラーをインストール後、
使用の環境づいて無線 LAN を設定します
The Wi-Fi Share Utility is for Windows 7 only.
Wi-Fi Share Utility Windows 7
Wi-Fi Share Utility仅支Windows 7操作
Wi-Fi Share Utility Windows 7 専用です
Step 4:
Then move the antennas to a place where the signal is
good.
完成将天线移至接良好地方
テップ 4:
次に、信号が良好な場所にアンテナを移動します。
FCC Notice (U.S.A. Only)
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult a dealer or experienced TV/radio technician for help.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits.
Neither the Dealer nor the Manufacturer are responsible for any radio or television interference caused by us-
ing other than recommended cables and connectors or by unauthorized changes or modications to this equip-
ment. Unauthorized changes or modications could void the user's authority to operate the equipment.
European Community Directive R&TTE Directive Compliance Statement:
This equipment complies with all the requirements and other relevant provisions of Directive 1999/5/EC of the
European Parliament and the Council of March 9, 1999 on Radio Equipment and Telecommunication Terminal
Equipment (R&TTE).
This equipment is suitable for home and ofce use in all the European Community Member States and EFTA
Member States.
Taiwan Wireless Statements:
無線設備告聲明
經型式認證合格功率射頻電機非經許可商號或使用者均不得擅自變更頻率加大功率或
計 之 特 性 及 功 能。
低功率射頻電機之使用不得影響飛航安全及干擾合法通信經發現有干擾現象時應立即停用並改善
至無干擾時方得繼續使用
前項合法通信指依電信法規定作業之無線電通信
功率忍受合通信及醫療用電波備之干擾
GC-WB300D:
Wireless Module Country Approvals/無線裝置國家/地區認證:
PCIe add-in card
GC-W B300D
02. 16, 2012
Declaration of Conformity
We, Manufacturer/Importer,
G.B.T. Technology Trading GMbH
Address: Bullenkoppel 16, 22047 Hamburg, Germany
Declare that the product
Product Type: PCIe add-in card
Product Name: GC-WB300D
conforms with the essential requirements of the following directives:
2004/108/EC EMC Directive:
Conduction & Radiated Emissions: EN55022:2006+A1:2007
Immunity:EN55024:1998+A1:2001+A2:2003
Power-line harmonics: EN61000-3-2:2006
Power-line flicker: EN61000-3-3:1995+A1:2001+A2:2005
2006/95/EC LVD Directive
Safety:EN60950-1:2006+A11:2009
1999/5/EC R&TTE Directive
Technical Requirements: EN 300 328 v1.7.1
EN 301 489-17 v2.1.1
2011/65/EU RoHS Directive
Restriction of use of certain
substances in electronic equipment:
This product does not contain any of the restricted
substances listed in Annex II, in concentrations
and applications banned by the directive.
CE marking
(EC conformity marking)
Signature:
(Stamp) Date: 02/16/2012 Name:
Timmy Huang
Timmy Huang
See the latest safety and regulatory documents at:
http://www.gigabyte.com/products/product-page.aspx?pid=4135
PCIe add-in card
GC-WB150
02. 16, 2012
GC-WB150:
Wireless Module Country Approvals/無線裝置國家/地區認證:
Declaration of Conformity
We, Manufacturer/Importer,
G.B.T. Technology Trading GMbH
Address: Bullenkoppel 16, 22047 Hamburg, Germany
Declare that the product
Product Type: PCIe add-in card
Product Name: GC-WB150
conforms with the essential requirements of the following directives:
2004/108/EC EMC Directive:
Conduction & Radiated Emissions: EN55022:2006+A1:2007
Immunity:EN55024:1998+A1:2001+A2:2003
Power-line harmonics: EN61000-3-2:2006
Power-line flicker: EN61000-3-3:1995+A1:2001+A2:2005
2006/95/EC LVD Directive
Safety:EN60950-1:2006+A11:2009
1999/5/EC R&TTE Directive
Technical Requirements: EN 300 328 v1.7.1
EN 301 489-17 v2.1.1
2011/65/EU RoHS Directive
Restriction of use of certain
substances in electronic equipment:
This product does not contain any of the restricted
substances listed in Annex II, in concentrations
and applications banned by the directive.
CE marking
(EC conformity marking)
Signature:
(Stamp) Date: 02/16/2012 Name:
Timmy Huang
Timmy Huang
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Gigabyte GC-WB150 取扱説明書

タイプ
取扱説明書
このマニュアルも適しています

他の言語で