How to replace the fascia Set
Step 1: Pull out the side burner ignition wire.
Step 2: Take out the three bolts on either side of the side burner shelf as shown.
Step 3: Loosen the front fixing screws 3mm on either side of the side burner shelf,
as shown.
Step 4: Fold open the left side table
Step 5: Take out the three screws on the left side shelf, as shown below.
Step 6: Loosen the front fixing screws 3mm on the left side shelf, as shown below.
Step 7: Fold open the left side table
Step 8: Loosen the two sets of screws in the sides of the panel。
Step 9: Take out all the knobs.
Step 10: Remove all screws from the knob bezel.
Step 11: Loosen the set screws at the back of the panel
Step 12: Remove the panel
-
1
-
2
-
3
-
4
-
5
-
6
