How to replace the fascia set
Step 1: Pull out the side burner ignition wire.
Step 2: Take out the bolt from the side burner injector bracket.
Step 3: Take out the three bolts shown on either side of the side burner shelf.
Step 4: Loosen the front fixing screws 3mm as shown below on either side of the
side burner shelf.
Step 5: Fold open the right-side furnace
Step 6: Take out the three screws as shown below on the left side shelf.
Step 7: Loosen the front fixing screws 3mm on the left side shelf as shown below.
Step 8: Fold open the left side table
Step 9: Loosen the two set screws in the sides of the panel。
Step 10: Take out all the knobs.
Step 11: Remove all screws from the knob bezel.
Step 12: Remove the replacement panel。
-
1
-
2
-
3
-
4
-
5
-
6
