RH-L20
Owner’s Manual
Copyright ©2009 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the
written permission of ROLAND CORPORATION.
WARNING
Before using this unit, make sure to read the instructions below, and the Owner’s Manual.
In the interest of personal and public safety, never wear the headphones while operating any
type of vehicle.
Do not use the headphones in a location where safety requires that you be able to hear the
sounds around you (such as on a train platform, at a railroad crossing, in a factory, or along a
busy road).
CAUTION
Using headphones for an extended time at high volume may damage your ears or negatively
impact your hearing. Such use will also strain the headphones themselves, so please enjoy them
at an appropriate volume.
When using headphones while on public transportation or in a public place, please be aware of
the possibility of annoyance to people around you.
Always handle either the headphones themselves or the plug, not the cord. This will help in
maintaining the electrical integrity of the cord by preventing any damage to it.
When connecting the headphones, always have the volume on the unit you are connecting them
to turned down to the minimum. Damage to the headphones may occur otherwise.
Protect the unit from strong impact.(Do not drop it!)
Do not expose the unit to direct sunlight, place it near devices that radiate heat, leave it inside an
enclosed vehicle, or otherwise subject it to temperature extremes. Excessive heat can deform or
discolor the unit.
When the headphones need cleaning, wipe them with a soft, dry cloth.
Should you remove the plug, keep it in a safe place out of children’s reach, so there is no chance
of it being swallowed accidentally.
If you experience any abnormality in the skin area contacted by the headphones, immediately
stop using them.
For China
WARNING
This product contains chemicals known to cause cancer,
birth defects and other reproductive harm, including lead.
For C.A. US
(
Proposition 65
)
For EU Countries
*5100004375 -01*
Wear the headphones as shown in the illustration below. The headphones will be stable and will provide optimal audio quality.
When the headphones are worn correctly, your earlobe
will be between the ear pad and the neck band.
We recommend that the neck band be nearly horizontal.
Wearing the headphones
Wear the headphones so that the top
of each ear is caught between the
ear pads and the neck band.
Neck band
Ear pads
* In the interest of product improvement, the specifications and/or
appearance of this unit are subject to change without prior notice.
SPECIFICATIONS
Type of Const ruction Closed type; dynamic
Driver 40 mm in diameter
Sensitivity 103 dB/mW
Maximum Input 100 mW
Frequency Response 20–25,000Hz
Weight 43 g (without cord)
Cord 7’ (2.2 m) OFC litz wire
Plug Stereo mini (gold-plated)/
Plug adaptor (mini plug 1/4 inch phone plug)
Impedance 36
RH-L20
/
