使⽤⼿册User Manual
演讲咪 SPEECH MICROPHONE
DA10S
■ 前言
■ 产品特性
●
●
●
●
●
●
●
●
●
集麦克风、功放、扬声器于一体的演讲咪，适用于演讲、宣
传、K歌娱乐等场合；
采用稀土扬声器，重量轻、音质好、声音大、峰值功率10W；
一键切换喊话及K歌模式，操作简便；
具备无线播放功能，简化繁琐的线材连接，无线播放音乐更方
便，更自由；
具有音量调节功能，可根据使用的场合情况调整扩音音量；
内置DSP啸叫抑制芯片，有效抑制啸叫声；
超长待机，节能省电，停止使用15分钟后自动关机；
内置大容量锂电池，节能环保，使用时间约8小时；
小巧轻便，握感舒适，适合长时间手持扩音及K歌娱乐。
尊敬的用户：
感谢您选购得胜DA10S演讲咪，为了您能够更好的了解及使
用本产品，建议您在使用前仔细阅读本说明书。
若存在有疑问或者您有宝贵的建议，可通过
拨打得胜官方服务热线400 6828 333或微信扫描
二维码关注得胜官方公众号与我们联系。
■ 适用范围
应用于讲话、宣传、K歌等场合。
01
DA10S 演讲咪
■ 产品配置
DA 10S演讲咪………………………………………………………1个
Type-C充电线…………………………………………………1条
使用手册………………………………………………………1份
防 风 棉 …………………………………………………………1个
■ 技术参数
频率响应： 100Hz-15kHz
峰值功率：10W
扬声器阻抗：4Ω
总谐波失真：THD≤5% 1KHz@4R,4W
信噪比：66dB (A-Weighted)@1W 4Ω（演讲模式）
蓝牙版本：5.0
混响模式：Reverb
工作电压：3.4V-4.2V
电池类型：锂离子电池（18650）
电池容量：3.7V/2600mAh
充电方式：DC5V 1.5A
充电时间：约4小时
使用时间：约8小时（演讲模式）
产品重量：约202g
产品尺寸：Φ64mm*254mm(直径*高)
主机参数
02
DA10S 演讲咪
拾音器：背极式驻极体
指向性：单指向
频率响应：150Hz-16KHz
灵敏度：-47.5±1.5dB(0dB=1V/Pa，at 1KHz)
音头参数
注：以上数据由得胜实验室测试得到，并拥有最终解释权！
■ 功能示意
03
DA10S 演讲咪
④
⑤
⑥
⑦
⑧
①
②
③
① 电源键：长按电源键2秒，开启或关闭扩音器。15分钟后不使
用，将自动关机；
② “M”按键：循环点按切换7种工作模式：演讲模式、主持模
式、K歌模式、蓝牙模式、怪兽模式、萌娃模式、卡通模式，
切换时伴随对应提示音。（备注：长按M键2秒，会自动切换
到演讲模式）
③ 指示灯：电量充足时，指示灯常亮绿灯。电量少于1小时时，
指示灯常亮红灯。充电状态时，指示灯闪烁红灯。充满电状
态时，指示灯长亮绿灯。
④“ + ”按键：点按增加扩音器音量，共5档音量可调节；
⑤“ - ”按键：点按减小扩音器音量，无静音功能；
⑥ 拾音器：喊话时嘴要尽量靠近拾音器，一般保持3-5厘米为
宜。不能用手捂住拾音器部分，否则容易生产啸叫；
⑦ 充电接口：连接Type-C充电线，请使用规格为5V 1.5A且经
过3C认证的充电头为扩音器充电；
⑧ 扩音器喇叭：喊话时不要靠近人耳，以免造成听力受损。请
尽量保持喇叭清洁。
提示：初次使用时，建议先充满电；当电池充满时，请停止对电
池充电，避免电池过充；如长时间不用，需每半年充电一次，避
免电池过放，对电池性能产生影响。
04
DA10S 演讲咪
■ 无线配对方法
05
DA10S 演讲咪
握持示意图
首次使用本机时，需要与手机或无线播放设备配对连接，步
骤如下：
1.打开演讲咪电源开关，点按“M”键切换至蓝牙模式；
2.此时打开手机的“设置”菜单，找到无线连接功能选项，开启
手机的无线播放功能，待搜索到“TAKSTAR DA10S”,点击
“TAKSTAR DA10S”进行连接，当演讲咪可以进行无线播放声
音，则表示设备已连接成功。
3.下次切换至蓝牙模式时，如果是已经进行过无线连接，则自动
回连；在无线连接成功的情况下，切换到其他工作模式则自动
断开无线连接。
■ 安全警示
为避免电击、高温、着火、辐射、爆炸、机械危险以及使用
不当等可能造成的人身伤害或财产损失，使用本产品前，请
仔细阅读并遵守以下事项：
1. 请勿将喇叭靠近人耳，以免造成听力损伤；
2. 使用中若发现有异常（如冒烟、异味等），请立即关闭电源开
关并拔掉电源插头，然后将产品送经销商检修；
3. 本产品及附件都应放置在室内干燥通风处，勿长期存放在潮
湿、灰尘多的环境；使用中避免靠近火源、雨淋、进水、过度
碰撞、抛掷、振动本机及覆盖通风孔，以免损坏其功能；
4. 使用该产品时需遵守相关安全规定，法律法规明确禁止使用场
合请勿使用本机，以免导致意外事故；
5. 请不要自行拆机改装或维修，以防止出现人身伤害，如有问题
或服务需求请联系当地经销商跟进处理；
6. 消费者若使用电源适配器供电，则应购买配套使用获得CCC认
证并满足标准要求的电源适配器。
06
DA10S 演讲咪
■ Product
■ Features
●
●
●
●
●
●
●
●
●
Combining microphone, power amplifier and speaker
together, suitable for speech, publicity, karaoke
Rare earth material speaker, light weight, excellent sound,
high volume, peak power 10W
One button to switch between MC mode and KTV mode,
easy operation
Wireless playing function without the trouble of cable
connection, more convenient to play music
Volume adjusting function to adjust the volume based on
the venue
Built-in DSP chip with the feedback rejecting function to
reject feedback effectively
Ultra-long standby, turning off automatically after no signal
input for 15 minutes to save the power consumption
High capacity Lithium battery for energy saving and
environmental protection, approximately 8h operation time
Compact design, comfortable to hold, suitable for
reinforcement and karaoke for a long time
Dear Customer,
Thank you for purchasing TAKSTAR DA10S speech
microphone. Please read the user manual carefully before
operation and keep it for reference in future. If you have any
questions or suggestions, please contact our local dealer.
07
DA 10S Speech Microphone
■ Product content
DA10S speech microphone……………………………………1 pc
Windscreen………………………………………………………1pc
Type-C charging cable…………………………………………1pc
User manual………………………………………………………1 pc
■ Specification
Specification
08
DA 10S Speech Microphone
Frequency Response: 100Hz-15kHz
Peak Power: 10W
Speaker Impedance: 4Ω
THD: THD≤5% 1KHz@4R,4W
S/N Ratio: 66dB (A-Weighted)@1W 4Ω (speech mode)
Bluetooth Version: 5.0
Reverb: Reverb
Operating Voltage: 3.4V-4.2V
Battery Type: Li-ion battery (18650)
Battery Capacity: 3.7V/2600mAh
Charging: DC5V 1.5A
Charging Time: approx. 4h
Operation Time: approx. 8h (speech)
Net Weight: approx. 202g
Dimension: Φ64mm*254mm (Dia*H)
■ Application
Speech, publicity, karaoke, etc.
Cartridge: back electret
Polar Pattern: unidirectional
Frequency Response: 150Hz-16KHz
Sensitivity: -47.5±1.5dB(0dB=1V/Pa，at 1KHz)
Cartridge Specification
Note: The data is tested by Takstar Laboratory and Takstar has the
final interpretation right!
■ Function
09
DA 10S Speech Microphone
④
⑤
⑥
⑦
⑧
①
②
③
① Power button: Keep pressing it for 2 seconds to turn on or
off the amplifier. If it is not used for 15 minutes, it will
automatically power off.
10
DA 10S Speech Microphone
② "M" button: Click it to cycle through 7 modes (i.e., speech
mode, host mode, karaoke mode, Bluetooth mode,
monster mode, child mode, anime mode), accompanied by
corresponding voice prompt.(Note: Hold M button for 2s to
auto switch to speech mode)
③ Indicator light: If it keeps lighting up green during
operation, this means sufficient power supply. If the power
can last for less than 1h, it keeps lighting up red. It flashes
red when charged. If it keeps lighting up green, this means
it is fully charged.
④ "+" button: Click it to increase the volume of the amplifier.
A total of 5 levels of volume can be chosen.
⑤ "-" button: Click it to decrease the volume of the amplifier.
There is no mute function.
⑥ Cartridge: When speaking, the mouth should be as close
as possible to the pickup, generally 3-5 cm. Do not cover
the cartridge with your hands; otherwise it will easily
produce feedback.
⑦ Charging interface: Connect to the Type-C charging cable.
Please use a charging head with a specification of 5V 1.5A
and 3C certification to charge the amplifier.
⑧ Speaker: Do not put the speaker too close to people's ears
to avoid hearing damaging. Please try to keep the speaker
clean.
Note: When the product is used for the first time, it is
recommended to fully charge it first; when it is fully charged,
please stop charging the battery to avoid overcharge; if it is
When the product is used for the first time, it needs to be
paired with a mobile phone or a wireless playing device. The
steps are as follows:
1. Power up the mic and press "M" button to switch to
Bluetooth mode.
2. Enter SETTINGS menu on your phone, find and enable
Bluetooth, wait until "TAKSTAR DA10S" is discovered and
tap on it to connect. If connected successfully, you should
be able to play audio wirelessly through the mic.
3. Next time you switch to Bluetooth mode, it will
automatically pair to the previously connected device.
Switching to other mode will disable wireless connection
automatically.
■ Wireless pairing method
11
DA 10S Speech Microphone
Holding diagram
not used for a long time, it needs to be charged once every six
months to avoid over discharge of the battery, which will
affect the battery performance.
■ Caution
In order to avoid possible personal injury or property
damage caused by electric shock, high temperature, fire,
radiation, explosion, mechanical hazards and improper use,
please read and observe the following items carefully before
using the product.
1. Please do not put the speaker close to people's ears to
avoid hearing damage.
2. If there is any abnormality (such as smoke, odor, etc.)
during use, please turn off the power switch and unplug the
power plug immediately, and then send the product to the
dealer for maintenance.
3. The product and accessories should be placed indoors in a
dry and ventilated place. Do not store them in a humid and
dusty environment for a long time. Avoid getting close to
fire, rain, water, excessive collision, throwing, vibrating the
machine and covering the ventilation holes during use, so
as not to damage its function.
4. When using the product, you must abide by the relevant
safety regulations. Please do not use the product in the
occasions that are clearly prohibited by laws and
regulations to avoid accidents.
5. Please do not disassemble, refit or repair the product by
yourself to prevent personal injury. If you have any
questions or service needs, please contact our local dealer
for follow-up.
6. If you use a power adapter to supply power, you should
purchase and use a power adapter that has obtained CCC
certification and meets the standard requirements.
12
DA 10S Speech Microphone
DA 10S Speech Microphone
13
DA 10S Speech Microphone
14
/