Keyboard stand for FP-7/4 series
KSC-44
* Before using this stand, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT NOTES.” Additionally, the manual should be saved
and kept on hand as a convenient reference.
Before you begin assembling the stand, check that all the parts were
supplied.
A BC
1
2
3
A Side board (left) 1
B Side board (right) 1
C Center board 1
1 Screw “a” (M6 x 18 mm) 4
2 Knob bolt 4
3 Headphone hook 1
Keyboard stand for FP-7/4 series
KSC-44
Owner’s Manual
• Make sure that another person is on hand to help with the assembly and setup.
• Be very careful, when you assemble and move the piano, to make sure that you do not drop it on your
hands or feet.
• Prepare an area in which you can perform the assembly safely.
• Do not use a power tool (e.g., an electric screwdriver) to assemble the stand. You risk damaging or
stripping the screws.
Assembly Procedure
Parts Check
* You will also need to have a Phillips screwdriver.
* Fasten each screw tightly, then place the stand in a stable and horizontal place.
* Do not allow the pedal cord or power cable to get twisted or pinched while
assembling the stand.
1 Stand Assembly
At rst, assemble the entire stand in a temporary fashion, without really
tightening the screws. Then, after checking the overall alignment of the
boards (and gently shifting certain parts where necessary), go around and
tightly fasten each of the screws.
1. Attach the side board (right) for the right sides to the center
board (so that the metal parts face inside) using screws “a” (M6
x 18 mm).
2. Use screws “a” (M6 x 18 mm) to attach the side board (left) in
the same way.
12
Center board
Side board (right)
Side board (left)
1
Screw “a”
2 Installing the Piano on the Stand
1. Set the piano on the stand, then rmly attach the four knob
bolts.
* When handling the piano, rmly grasp it. Be careful, so you do not get your ngers
pinched.
Please don’t get your ngers
pinched!
Knob bolt
Side board
Underneath
the Piano
3 Attaching the Headphone Hook
1. Press and twist the headphone hook included with the piano
into the hole in the bottom of the piano (refer to the gure
below).
2. Turn the thumbscrew of the headphone hook to secure the
headphone hook.
If the optionally available CD drive is installed, attach the headphone
hook at the right of the CD drive (CD drive compatible model only).
* In the interest of product improvement, the speci cations and/or appearance of this
unit are subject to change without prior notice.
* 5 1 0 0 0 1 6 1 6 9 - 0 1 *
WARNING
Do not open or perform any internal
modi cations on the stand. (The only exception
would be where this manual provides speci c
instructions which should be followed in order
to put in place user-installable options.)
Do not attempt to repair the unit, or replace
parts within it (except when this manual
provides speci c instructions directing you to
do so). Refer all servicing to your retailer, the
nearest Roland Service Center, or an authorized
Roland distributor.
Never install the unit in any of the following
locations.
• Subject to temperature extremes (e.g.,
direct sunlight in an enclosed vehicle, near
a heating duct, on top of heat-generating
equipment); or are
• Damp (e.g., baths, washrooms, on wet
oors); or are
• Exposed to steam or smoke; or are
• Subject to salt exposure; or are
• Humid; or are
• Exposed to rain; or are
• Dusty or sandy; or are
• Subject to high levels of vibration and
shakiness.
Make sure you always have the stand placed so
it is level and sure to remain stable. Never place
it on stands that could wobble, or on inclined
surfaces.
In households with small children, an adult
should provide supervision until the child is
capable of following all the rules essential for
the safe operation of the unit.
Protect the stand from strong impact. (Do not
drop it!)
CAUTION
This stand intended for use only with Roland
FP-7/FP-4 series. Use with other apparatus
is capable of resulting in instability causing
possible injury.
Even if you observe the cautions given in the
owner’s manual, certain types of handling may
allow this product to fall from the stand, or
cause the stand to overturn. Please be mindful
of any safety issues before using this product.
Never climb on top of, nor place heavy objects
on the stand.
Install the stand only into the speci ed unit
(Roland FP-7/FP-4 series). Use only the included
knob bolts during the installation.
Keep the included screws, the knob bolts, the
thumbscrew of the headphone hook in a safe
place out of children’s reach, so there is no
chance of them being swallowed accidentally.
IMPORTANT NOTES
Placement
• Do not expose the unit to direct sunlight, place
it near devices that radiate heat, leave it inside
an enclosed vehicle, or otherwise subject it to
temperature extremes. Also, do not allow lighting
devices that normally are used while their light
source is very close to the unit (such as a piano light),
or powerful spotlights to shine upon the same area of
the unit for extended periods of time. Excessive heat
can deform or discolor the unit.
Maintenance
• To clean the unit, use a dry, soft cloth; or one that
is slightly dampened. Try to wipe the entire surface
using an equal amount of strength, moving the cloth
along with the grain of the wood. Rubbing too hard
in the same area can damage the nish.
• Never use benzine, thinners, alcohol or solvents of
any kind, to avoid the possibility of discoloration and/
or deformation.
Additional Precautions
• When you need to transport the stand, package
it in the box (including padding) that it came in, if
possible. Otherwise, you will need to use equivalent
packaging materials.
When Moving the Piano
• You must use two or more people when moving the
piano.
• Before moving the piano, disconnect the AC adaptor
and other cables.
• Keep the piano level when lifting it.
• Be careful not to pinch your hands or drop the piano
on your feet.
Copyright © 2010 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.
Roland is a registered trademark of Roland Corporation in the United States and/or other countries.
Used for instructions intended to alert the
user to the risk of injury or material
damage should the unit be used
improperly.
* Material damage refers to damage or
other adverse effects caused with
respect to the home and all its
furnishings, as well to domestic animals
or pets.
Used for instructions intended to alert the
user to the risk of death or severe injury
should the unit be used improperly.
The symbol alerts the user to things that must be
carried out. The specific thing that must be done is
indicated by the design contained within the circle. In the
case of the symbol at left, it means that the power-cord
plug must be unplugged from the outlet.
The symbol alerts the user to important instructions or
warnings.The specific meaning of the symbol is
determined by the design contained within the triangle. In
the case of the symbol at left, it is used for general
cautions, warnings, or alerts to danger.
The symbol alerts the user to items that must never be
carried out (are forbidden). The specific thing that must
not be done is indicated by the design contained within
the circle. In the case of the symbol at left, it means that
the unit must never be disassembled.
About WARNING and CAUTION Notices
About the Symbols
ALWAYS OBSERVE THE FOLLOWING
WARNING
This product contains chemicals known to cause cancer, birth defects and other reproductive harm, including lead.
For C.A. US
(
Proposition 65
)
/