Keyboard stand for FP-7/4 KSC-44
©
KSC-44
Keyboard Stand for FP-7/4 KSC-44 ’
“ ”
“ ”
Make sure that another person is on hand to help with the assembly and setup.
Be very careful, when you assemble and move the piano, to make sure that you do not
drop it on your hands or feet.
Copyright
©
2006 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.
40677567 2PS
*40677567- 02*
A
B
C
3
2
1
1
2
Part Check
Before you begin assembling the stand, check that all the parts
were supplied. You will also need to have a Phillips screwdriver.
fig.01
A: Side Board (left) 1: Screw “a” (M6 x 14 mm) x 4
B: Side Board (right) 2: Knob bolt x 4
C: Center Board 3: Headphone hook x 1
* Fasten each screw tightly, then place the stand in a stable and
horizontal place.
* Do not allow the pedal cord or power cable to get twisted or pinched
while assembling the stand.
Stand Assembly
At first, assemble the entire stand in a temporary fashion, without
really tightening the screws. Then, after checking the overall
alignment of the boards (and gently shifting certain parts where
necessary), go around and tightly fasten each of the screws.
1.
Attach the side boards (right) for the right sides to the
center board (so that the metal parts face inside)
using screws “a” (M6 x 14 mm).
2.
Use screws “a” (M6 x 14 mm) to attach the left side
board in the same way.
fig.02.e
Installing the Piano on the Stand
3.
Set the piano on the stand, then firmly attach the four
knob bolts.
* When handling the piano, firmly grasp it. Be careful, so you do not get
your fingers pinched.
fig.03.e
Attaching the Headphone Hook
4.
Press and twist the headphone hook included with
the piano into the hole in the bottom of the piano
(refer to the figure below).
5.
Turn the headphone hook thumbscrew to secure the
headphone hook.
If the optionally available CD drive is installed, attach the
headphone hook at the right of the CD drive. (FP-7 only)
A
B
C
3
2
1
Center board
Side board (right)
Side board (left)
Screw “a”
1
2
Side Board
underneath
the Piano
Knob bolt
Please don't get
your fingers
pinched!
KSC-44_je 1 ページ ２００８年１０月２８日 火曜日 午前１０時５８分
•
•
•
•
Using The Unit Safely
..........................................................................................................
001
• Before using this stand, make sure to read the
instructions below, and the Owner’s Manual.
..........................................................................................................
003
• Do not attempt to repair the stand, or replace
parts within it (except when this manual provides
specific instructions directing you to do so). Refer
all servicing to your retailer, the nearest Roland Service
Center, or an authorized Roland distributor, as listed on
the “Information” page.
..........................................................................................................
004
• Never use or store the stand in places that are:
• Subject to temperature extremes (e.g., direct
sunlight in an enclosed vehicle, near a heating
duct, on top of heat-generating equipment); or
are
• Damp (e.g., baths, washrooms, on wet floors); or are
• Humid; or are
• Exposed to rain; or are
• Dusty; or are
• Subject to high levels of vibration.
..........................................................................................................
007
• Make sure you always have the stand placed so it
is level and sure to remain stable. Never place it
on stands that could wobble, or on inclined
surfaces.
..........................................................................................................
013
• In households with small children, an adult
should provide supervision until the child is
capable of following all the rules essential for the
safe operation of the stand.
..........................................................................................................
014
• Protect the stand from strong impact.
(Do not drop it!)
..........................................................................................................
101d
• This stand intended for use only with Roland FP-
7/4. Use with other apparatus is capable of
resulting in instability causing possible injury.
..........................................................................................................
106
• Never climb on top of, nor place heavy objects on
the stand.
..........................................................................................................
118b
• Keep the included screws, seal, the thumbscrew
of the headphone hook in a safe place out of
children’s reach, so there is no chance of them
being swallowed accidentally.
..........................................................................................................
Important Notes
354b
• Do not expose the stand to direct sunlight, place it near
devices that radiate heat, leave it inside an enclosed
vehicle, or otherwise subject it to temperature extremes.
Also, do not allow lighting devices that normally are used
while their light source is very close to the stand (such as a
piano light), or powerful spotlights to shine upon the
same area of the stand for extended periods of time.
Excessive heat can deform or discolor the stand.
401b
• To clean the stand, use a dry, soft cloth; or one that is
slightly dampened. Try to wipe the entire surface using an
equal amount of strength, moving the cloth along with the
grain of the wood. Rubbing too hard in the same area can
damage the finish.
402
• Never use benzine, thinners, alcohol or solvents of any
kind, to avoid the possibility of discoloration and/or
deformation.
962a
• In the interest of product improvement, the specifications
and/or appearance of this stand are subject to change
without prior notice.
When Moving the Piano
- You must use two or more people when moving the
piano.
- Before moving the piano, disconnect the AC adaptor and
other cables.
- Keep the piano level when lifting it.
- Be careful not to pinch your hands or drop the piano on
your feet.
KSC-44_je 2 ページ ２００８年１０月２８日 火曜日 午前１０時５８分
/