TestRun Program Descriptions for the MS167 moving sign
1 2 3 4
1. ID 01:Set the ID number of the moving sign that you are going to send to,
ID number from 01~07
,
if you set ID=99 means broadcast to every signs
。
To find out the display board ID: Power off the display board then power on,
the display will show “SDC DISPLAY 01”---means ID=01, the ID can be
changed from the DIP-SW on the PCB inside the display board. The factory
set ID is 01.
2. Stay 03: means the first 16 characters will stay for 3 seconds than begin to
scrolling left, the setting ranged from 01 to 99
。
3. Speed 04: means the speed for scrolling, ranged from 0(fastest) to
9(slowest)
。
4. Function 1: means showing the message for 1 time only the blanked.
Function 2 means showing the message for many times and the message
will be stored into the display board. If you send a new message to the
display board, it will waiting for the previous message scrolling out
completely than shows up the new one. Function 3 means shows up new
message immediately. Function 0 means just clear the display boards.
。
5. Send: When you finished key in all the data, you need to click “Send” for
sending out via RS232 port
。
Max. data can be 160 charaters.
6. RunTime: When you click “RunTime” the display board will show the date
hours : minutes : seconds : 1/10 & 1/100 seconds
。
The function should set
to 3. You need to stop the “RunTime” then back to send message.
7. Load: means to read out the setting before from the “TestRun.ini” file
include the message data
。
8. Save: means to save the current setting to the “TestRun.ini” file include the
message data
。
6
7
8