13
en
Use
Using the to-go or chopper
blender jug
X Fig. C
1. Put the desired ingredients into the
blender jug.
2. Hold the blade insert by the plastic
ring and insert it – blade first – into
the blender jug. Turn the blade insert
anticlockwise until it audibly clicks
into place.
3. Turn the blender jug over.
4. Insert the blender jug into its recess on
the motor block and turn it clockwise
until it audibly clicks into place.
5. Plug the mains plug into the mains.
6. Hold the blender jug firmly with one
hand. Hold down the t or u button until
the mixture has reached the desired
consistency.
7. Release the button and wait until the
appliance comes to rest. Disconnect the
mains plug.
8. Turn the blender jug anti-clockwise and
then remove it.
9. Turn the blender jug over.
10. Turn the blade insert clockwise and then
remove it.
Caution!
Never set the blade insert down with the
blade underneath. This could damage
the blade and scratch your work surface.
X Fig. B
11. Close the jug with the lid.
12. To pour out or drink contents, undo
screw cap and remove, or lift up drinking
cap.
Clean all the parts.
X “Cleaning and servicing” see page 14
Working with the glass blender jug
X Fig. D
1. Hold the blade insert by the plastic
ring and insert it – blade first – into the
blender jug. Turn the blade insert anti-
clockwise until it audibly clicks into place.
2. Turn the blender jug over.
3. Insert the blender jug into its recess on
the motor block and turn it clockwise
until it audibly clicks into place.
4. Put the desired ingredients into the
blender jug.
5. Put the lid and locking cap in place.
6. Plug the mains plug into the mains.
7. Hold the lid firmly with one hand, but
don’t place your hand over the filling
opening. Hold down the t or u button
until the mixture has reached the
desired consistency.
8. Release the button and wait until the
appliance comes to rest. Disconnect the
mains plug.
9. Turn the blender jug anti-clockwise and
then remove it.
10. Remove the lid.
11. Pour the blended food into another
container.
12. Turn the blade insert clockwise and then
remove it.
Caution!
Never set the blade insert down with the
blade underneath. This could damage
the blade and scratch your work surface.
X Fig. B
Clean all the parts.
X “Cleaning and servicing” see page 14
Adding more ingredients
X Fig. E
1. Release the button and wait until the
appliance comes to rest.
2. Remove the locking cap or the entire lid.
3. Add the extra ingredients.
4. Replace the lid and the locking cap, and
again hold down the t or u button.
Note: you can remove the locking cap by
turning it anticlockwise.