1
3
4
2
3G HD SD
1
2
1
2
2
1
安全上のご注意
火災・感電・傷害を防止するには
以下の指示を必ず守ってください
取り扱いを誤った場合に、使用者
が傷害を負う危険が想定される場
合および物的損害のみの発生が想
定される内容を表しています。
※物的損害とは、家屋・家財およ
び家畜・ペットにかかわる拡大
損害を表しています。
取り扱いを誤った場合に、使用者が
死亡または重傷を負う可能性が想定
される内容を表しています。
警告
注意
注意の意味について警告と
図記号の例
● は、強制（必ずすること）を表しています。
具体的な強制内容は、
● の中に描かれています。
左図の場合は、「電源プラグをコンセントから抜く
こと」を表しています。
は、注意（危険、警告を含む）を表しています。
具体的な注意内容は、 の中に描かれています。
左図の場合は、「一般的な注意、警告、危険」を表
しています。
は、禁止（してはいけないこと）を表しています。
具体的な禁止内容は、 の中に描かれています。
左図の場合は、「分解禁止」を表しています。
* 5 1 0 0 0 3 9 1 2 2 - 0 1 *
VC-1 Series Dedicated Rack-mount Tray
Contents of the Package
1
3
4
2
No. Part name Quantity
1 Rack mount tray 1
2 Screw set 1
3 This document 1
4 Cable tie (Sample) 3
Before using this unit, carefully read the sections entitled “USING
THE UNIT SAFELY” and “IMPORTANT NOTES.”
The example shown is merely for reference, and may dier from
actual situations.
Specications
Roland RAD-3: Rack Mount Tray
Compatible
Models
VC-1-SH, VC-1-HS, VC-1-DL, VC-1-SC
Material Steel
Dimensions
482 (W) x 380 (D) x 44 (H) mm
19 (W) x 15 (D) x 1-3/4 (H) inches
EIA-compliant 1U rack
Weight
2.4 kg
5 lbs 5 oz
Weight
Capacity
2.4 kg
5 lbs 5 oz
Accessories
Owner's manual
Cable tie x 3
Screw set (Flat head screw M3 x 6 10 pieces)
* In the interest of product improvement, the specications and/
or appearance of this unit are subject to change without prior
notice.
Installation
1. Remove the screws at the locations on the VC-1 in the
gure (2 locations on either the top or underside),
according to how the unit is to be used.
3G HD SD
2. Using the screws included with the RAD-3, securely
fasten the VC-1 and the tray.
Use the included screws.
1
2
1
2
2
is for use with the unit installed ush against the front panel.
1
is for use with the unit installed 40 mm inward from the front
panel.
3. Secure the AC adapter in place using the included cable ties.
Up to three VC-1 series units can be mounted in this product at the
same time.
Ten screws, including spares, are packed with the product.
201_edit
962a
Copyright © 2014 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION.
202
RAD-3
USING THE UNIT SAFELY
Used for instructions intended to alert the
user to the risk of injury or material
damage should the unit be used
improperly.
* Material damage refers to damage or
other adverse effects caused with
respect to the home and all its
furnishings, as well to domestic animals
or pets.
Used for instructions intended to alert the
user to the risk of death or severe injury
should the unit be used improperly.
The symbol alerts the user to things that must be
carried out. The specific thing that must be done is
indicated by the design contained within the circle. In the
case of the symbol at left, it means that the power-cord
plug must be unplugged from the outlet.
The symbol alerts the user to important instructions or
warnings.The specific meaning of the symbol is
determined by the design contained within the triangle. In
the case of the symbol at left, it is used for general
cautions, warnings, or alerts to danger.
The symbol alerts the user to items that must never be
carried out (are forbidden). The specific thing that must
not be done is indicated by the design contained within
the circle. In the case of the symbol at left, it means that
the unit must never be disassembled.
About WARNING and CAUTION Notices
About the Symbols
ALWAYS OBSERVE THE FOLLOWING
WARNING
002a
Do not disassemble or modify by yourself
Do not carry out anything unless you are
instructed to do so in the owner’s manual.
Otherwise, you risk causing malfunction.
003
Do not repair or replace parts by yourself
Refer all servicing to your retailer, the
nearest Roland Service Center, or an
authorized Roland distributor, as listed on
the “Information.”
004
Do not use or store in the following types of
locations
• Subject to temperature extremes (e.g.,
direct sunlight in an enclosed vehicle,
near a heating duct, on top of
heat-generating equipment); or are
• Damp (e.g., baths, washrooms, on wet
oors); or are
• Exposed to steam or smoke; or are
• Subject to salt exposure; or are
• Exposed to rain; or are
• Dusty or sandy; or are
• Subject to high levels of vibration and shakiness.
013
Be cautious to protect children from injury
Always make sure that an adult is on hand
to provide supervision and guidance
when using the unit in places where
children are present, or when a child will
be using the unit.
014
Do not drop or subject to strong impact
Otherwise, you risk causing damage or
malfunction.
022c
Turn the unit o before installing expansion
boards
Before installing the equipments
corresponding to this product, you must
rst always turn o the equipments and
unplug its power cord.
CAUTION
106
Avoid climbing on top of the unit, or placing
heavy objects on it
Otherwise, you risk injury as the result of
the unit toppling over or dropping down.
118d
Keep small items out of the reach of children
To prevent accidental ingestion of the
parts listed below, always keep them out
of the reach of small children.
• Included Parts:
Countersunk screws (M3×6, BZC)
• Removable Parts:
VC-1 assembly screws
(countersunk screws; M3×5 NI)
IMPORTANT NOTES
401a
• For everyday cleaning wipe the unit with a soft,
dry cloth or one that has been slightly dampened
with water. To remove stubborn dirt, use a cloth
impregnated with a mild, non-abrasive detergent.
Afterwards, be sure to wipe the unit thoroughly
with a soft, dry cloth.
402
• Never use benzine, thinners, alcohol or solvents of
any kind, to avoid the possibility of discoloration
and/or deformation.
• This product is a rack-mount tray exclusively for
the VC-1. Never use it for any other purpose.
• Never use any screws other than those in the
included screw set.
• When installing this product on a rack, make sure
the procedure is carried out by two or more
persons while exercising care to prevent falls or
dropped items. Whenever possible, placing the
rack on its side and installing this product from
above is recommended.
• When installing this product on a rack, exercise
care to avoid pinched ngers.
• Never install other equipment on this product or
transport a rack while the product is mounted on
it. The impact of shaking might deform the
product.
• When shipping the product in a ight case,
excessive shaking or impact might deform the
sheet metal or cause screws to be loosened or fall
out.
• When this unit is installed in a location subject to
vibration or shaking, scraping of cable surfaces
might occur, depending on cable layout and the
type of cable coating. Protect the cables as
needed (such as by arranging them so that they do
not touch sheet-metal edges or by attaching
protective material to the cable ends).
/