Philips S3110/06 ユーザーマニュアル

S3520, S3510, S3120, S3110

S3520

S3510

1

9

2

3

4

5

10

8

7

6

empty page before TOC

English 6

Bahasa Indonesia 21

Bahasa Melayu 35

Tiếng Việt 50

ภาษาไทย

64

简体中文

77

繁體中文

90

한국의

102

ﺔﻴﺑﺮﻌﻟﺍ

115

یسرﺍف

128

תירבע 142

English

Introduction

Congratulations on your purchase and welcome to

Philips! To fully benefit from the support that

Philips offers, register your product at

www.philips.com/welcome.

General description (Fig. 1)

1 Protection cap

2 Shaving unit

3 Shaving unit release button

4 On/off button

5 Shaving head symbol

6 Charging light

7 Trimmer (S3520, S3510 only)

8 Trimmer release slide (S3520, S3510 only)

9 Supply unit (adapter, type HQ8505)

10 Small plug

Important safety information

Read this important information carefully before

you use the appliance and its accessories and

save it for future reference. The accessories

supplied may vary for different products.

Danger

- Keep the supply unit dry.

6

English

Warning

- To charge the battery, only use

the detachable supply unit

(type HQ8505) provided with

the appliance.

- The supply unit contains a

transformer. Do not cut off the

supply unit to replace it with

another plug, as this causes a

hazardous situation.

- This appliance can be used by

children aged from 8 years and

above and persons with

reduced physical, sensory or

mental capabilities or lack of

experience and knowledge if

they have been given

supervision or instruction

concerning use of the

appliance in a safe way and

understand the hazards

involved. Children shall not play

with the appliance. Cleaning

and user maintenance shall not

be made by children without

supervision.

7

English

- Always unplug the shaver

before you clean it under the

tap.

- Always check the appliance

before you use it. Do not use

the appliance if it is damaged,

as this may cause injury. Always

replace a damaged part with

one of the original type.

- Do not open the appliance to

replace the rechargeable

battery.

Caution

- Never immerse the cleaning

system or the charging stand in

water and do not rinse it under

the tap.

- Never immerse the shaver in

water. Do not use the shaver in

the bath or in the shower.

- Never use water hotter than

80°C to rinse the shaver.

- Only use this appliance for its

intended purpose as shown in

the user manual.

8

English

- For hygienic reasons, the

appliance should only be used

by one person.

- Never use compressed air,

scouring pads, abrasive

cleaning agents or aggressive

liquids such as petrol or

acetone to clean the appliance.

- If your shaver comes with a

cleaning system, always use

the original Philips cleaning

fluid (cartridge or bottle,

depending on the type of

cleaning system).

- Always place the cleaning

system on a stable, level and

horizontal surface to prevent

leakage.

- If your cleaning system uses a

cleaning cartridge, always make

sure the cartridge compartment

is closed before you use the

cleaning system to clean or

charge the shaver.

9

English

- When the cleaning system is

ready for use, do not move it to

prevent leakage of cleaning

fluid.

- Water may drip from the socket

at the bottom of the shaver

when you rinse it. This is normal

and not dangerous because all

electronics are enclosed in a

sealed power unit inside the

shaver.

- Do not use the supply unit in or

near wall sockets that contain

an electric air freshener to

prevent irreparable damage to

the supply unit.

Electromagnetic fields (EMF)

- This Philips appliance complies with all

applicable standards and regulations regarding

exposure to electromagnetic fields.

General

- This shaver can be safely cleaned under the

tap.

- The appliance is suitable for mains voltages

ranging from 100 to 240 volts.

- The supply unit transforms 100-240 volts to a

safe low voltage of less than 24 volts.

10

English

Charging

It takes approx. 1 hour (S3520, S3510) or 8 hours

(S3120, S3110) to fully charge the appliance. When

you charge the appliance for the first time or after

a long period of disuse, let it charge until the

charging light lights up continuously. A fully

charged appliance provides up to 50 minutes

(S3520, S3510) or 45 minutes (S3120, S3110) of

shaving time. The shaving time may be less than

50 or 45 minutes as a result of your shaving

behavior, your cleaning habits or your beard type.

Charging with the adapter

2

1

1 Put the small plug in the appliance.

2 Put the adapter in the wall socket.

- The charging light shows the charging status of

the appliance (see section ‘Charge indications’

in this chapter).

3 After charging, remove the adapter from the

wall socket and pull the small plug out of the

appliance.

Charge indications

Battery low

- When the battery is almost empty (when there

are only 5 or fewer shaving minutes left), the

charging light starts to flash orange.

- When you switch off the appliance, the

charging light continues to flash orange for a

few seconds.

Quick charging

When you start charging the empty battery, the

charging light alternately flashes orange and

green. After approx. 3 minutes the charging light

starts flashing green only. The appliance now

contains enough energy for a 5-minute shave.

11

English

Charging

- When the appliance is charging, the charging

light flashes green.

Battery fully charged

- When the battery is fully charged, the charging

light lights up green continuously.

Note: After approx. 30 minutes, the charging light

goes out to save energy.

Using the appliance

Note: This appliance can be used without cord or

when it is connected to the wall socket.

Shaving tips and tricks

- Make circular movements during use. Circular

movements provide better shaving results than

straight movements.

- Your skin may need 2 or 3 weeks to get

accustomed to the Philips shaving system.

Switching the appliance on and off

1 To switch on the appliance, press the on/off

button once.

2 To switch off the appliance, press the on/off

button once.

Shaving

1 Switch on the appliance.

12

English

2 Move the shaving heads in circular movements

over your skin.

3 After shaving, switch off the appliance.

4 Clean the appliance (see chapter ‘Cleaning and

maintenance’).

Trimming (S3520, S3510 only)

You can use the trimmer to groom your sideburns

and moustache.

1 Push the trimmer slide downwards to open the

trimmer.

2 Switch on the appliance.

- You can now start trimming.

3 After trimming, switch off the appliance.

4 Clean the trimmer (see chapter ‘Cleaning and

maintenance’).

5 Close the trimmer (‘click’).

Cleaning and maintenance

Danger: Remove the detachable cord

from the handheld part before cleaning

this part in water.

Caution: Never use compressed air, scouring

pads, abrasive cleaning agents or aggressive

13

English

liquids such as petrol or acetone to clean the

appliance.

- Clean the appliance after every shave for

optimal shaving performance.

- Regular cleaning guarantees better shaving

performance.

- Be careful with hot water. Always check if the

water is not too hot, to prevent your hands from

getting burnt.

Note: Water may leak from the socket at the

bottom of the appliance when you rinse it. This is

normal and not dangerous because all electronics

are enclosed in a sealed power unit inside the

shaver.

Cleaning the shaving unit under the tap

1 Switch off the appliance and make sure it is

disconnected from the wall socket.

2 Press the release button to open the shaving

unit. Rinse the inside of the shaving unit and the

hair chamber under a hot tap for 30 seconds.

- Rinse the outside of the shaving unit.

3 Close the shaving unit and shake off excess

water.

Caution: Be careful not to hit the shaving unit

against anything while you shake off excess

water.

Caution: Never dry the shaving unit and the hair

chamber with a towel or tissue, as this may

damage the shaving unit.

4 Open the shaving unit again and leave it open

to let the appliance dry completely.

14

English

Thorough cleaning

Clean the shaving heads thoroughly once a month

for optimal performance.

1 Switch off the appliance and make sure it is

disconnected from the wall socket.

2 Press the release button to open the shaving

unit. Pull the shaving unit off the appliance.

2

1

3 Turn the lock anticlockwise and remove the

retaining frame.

4 Remove and clean one shaving head at a time.

Each shaving head consists of a cutter and a

guard.

Note: Do not clean more than one cutter and

guard at a time, since they are all matching sets.

If you accidentally mix up the cutters and

guards, it may take several weeks before

optimal shaving performance is restored.

- Remove the cutter from the shaving guard and

clean both parts under the tap.

15

English

5 Put the cutter back into the guard.

6 Put the shaving heads back into the shaving

unit.

Note: Make sure that the projections of the

shaving heads fit exactly into the recesses of

the shaving head holder.

1

2

7 Put the retaining frame back into the shaving

unit and turn the lock clockwise.

8 Insert the lug of the shaving unit into the slot in

the top of the appliance. Then close the shaving

unit ('click').

Note: If the shaving unit does not close

smoothly, check if you have inserted the

shaving heads properly and if the retaining

frame is locked.

Cleaning the trimmer under the tap (S3520, S3510

only)

Clean the trimmer every time you have used it.

1 Switch off the appliance and make sure it is

disconnected from the wall socket.

16

English

2 Push the trimmer slide downwards to open the

trimmer.

3 Switch on the appliance and clean the trimmer

under the tap.

4 Switch off the appliance and leave the trimmer

open to let it dry.

5 Close the trimmer (‘click’).

Tip: For optimal trimming performance, lubricate

the trimmer teeth with a drop of sewing machine

oil every six months.

Storage

Note: We advise you to let the appliance dry

before you put the protection cap on it.

Put the protection cap on the appliance to prevent

damage.

Replacement

2yrs

For maximum shaving performance, we advise you

to replace the shaving heads every two years.

Replace damaged shaving heads immediately.

Always replace the shaving heads with original

Philips shaving heads' (see 'Ordering accessories').

17

English

Replacement reminder

The shaving unit symbol will light up to indicate

that the shaving heads need to be replaced.

1 The shaving unit symbol lights up orange

continuously.

2 Switch off the appliance and make sure it is

disconnected from the wall socket.

3 Press the release button to open the shaving

unit. Pull the shaving unit off the appliance.

2

1

4 Turn the lock anticlockwise and remove the

retaining frame.

5 Remove the shaving heads from the shaving

unit and throw them away.

6 Place new shaving heads in the shaving unit.

Note: Make sure that the projections of the

shaving heads fit exactly into the recesses of

the shaving head holder.

1

2

7 Put the retaining frame back into the shaving

unit and turn the lock clockwise.

18

English

8 Insert the lug of the shaving unit into the slot in

the top of the appliance. Then close the shaving

unit ('click').

Note: If the shaving unit does not close

smoothly, check if you have inserted the

shaving heads properly and if the retaining

frame is locked.

5 sec.

9 Press and hold the on/off button for 5 seconds

to reset the replacement reminder on the

shaver. The orange light goes out.

Ordering accessories

To buy accessories or spare parts, visit

www.shop.philips.com/service or go to your

Philips dealer. You can also contact the Philips

Consumer Care Center in your country (see the

worldwide guarantee leaflet for contact details).

The following accessories and spare parts are

available:

- SH30 Philips Shaving Heads.

- HQ110 Philips shaving head cleaning spray

Recycling

- Do not throw away the product with the normal

household waste at the end of its life, but hand

it in at an official collection point for recycling.

By doing this, you help to preserve the

environment.

Guarantee and support

If you need information or support, please visit

www.philips.com/support or read the separate

worldwide guarantee leaflet.

19

English

Guarantee restrictions

The shaving heads (cutters and guards) are not

covered by the terms of the international

guarantee because they are subject to wear.

Troubleshooting

This chapter summarizes the most common

problems you could encounter with the appliance.

If you are unable to solve the problem with the

information below, visit www.philips.com/support for

a list of frequently asked questions or contact the

Consumer Care Center in your country.

Problem Possible cause Solution

The appliance

does not shave as

well as it used to.

The shaving heads

are damaged or

worn.

Replace the shaving heads

(see chapter

'Replacement').

Long hairs obstruct

the shaving heads.

Clean the shaving heads

one by one (see chapter

'Cleaning and

maintenance').

You have not

inserted the

shaving heads

properly.

Make sure that the

projections of the shaving

heads fit exactly into the

recesses (see chapter

'Cleaning and

maintenance').

The appliance

does not work

when I press the

on/off button.

The rechargeable

battery is empty.

Recharge the battery (see

chapter 'Charging'.

The temperature of

the appliance is too

high. In this case,

the appliance does

not work.

As soon as the

temperature of the

appliance has dropped

sufficiently, you can switch

on the appliance again.

20

English

ページが読み込まれています...

Philips S3110/06 ユーザーマニュアル

このマニュアルも適しています

Philips S3110/06 ユーザーマニュアル

関連論文