NEC MultiSync® LCD2180WG LED 取扱説明書

  • NEC LCD2180WG液晶ディスプレイの取扱説明書の内容を理解しました。接続方法から高度な設定、トラブルシューティングまで、このディスプレイに関するご質問にお答えします。例えば、OSD機能の使い方、カラーキャリブレーションの方法、アームの取り付け方法など、お気軽にご質問ください。
  • 電源が入らない場合はどうすれば良いですか?
    画面の明るさを調整するにはどうすれば良いですか?
    画面の色合いを調整するにはどうすれば良いですか?
    液晶パネルのお手入れ方法は?
    VESA規格のアームを取り付けることはできますか?
R
R
R
R
q
w
e
r
t
q
w
q
w
e
r
t
q
w
q
w
e
r
Ü
Declaration of Conformity
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions. (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
U.S. Responsible Party: NEC Display Solutions of America, Inc.
Address: 500 Park Blvd, Suite 1100
Itasca, Illinois 60143
Tel. No.: (630) 467-3000
Type of Product: Display Monitor
Equipment Classification: Class B Peripheral
Model: LCD2180WG LED (L215GF)
FCC Information
1. Use the attached specified cables with the LCD2180WG LED colour monitor so as not to interfere with radio and
television reception.
(1) The power supply cord you use must have been approved by and comply with the safety standards of U.S.A.
(2) Please use the supplied shielded video signal cable, DVI-D to DVI-D cable.
Use of other cables and adapters may cause interference with radio and television reception.
2. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult your dealer or an experienced radio/TV technician for help.
If necessary, the user should contact the dealer or an experienced radio/television technician for additional
suggestions. The user may find the following booklet, prepared by the Federal Communications Commission,
helpful: “How to Identify and Resolve Radio-TV Interference Problems.” This booklet is available from the U.S.
Government Printing Office, Washington, D.C., 20402, Stock No. 004-000-00345-4.
We hereby declare that the equipment specified above conforms
to the technical standards as specified in the FCC Rules.
/