User’s Manual
The OT-PC20 is a soft case exclusively for the TM-P20 printer.
You can use the belt strap to carry the printer around on you.
You can also operate the printer and perform printing with the printer still in the case.
!
CAUTIONS ON HANDLING
❏ If the case gets wet from water or another liquid, dry it thoroughly. If you use it while it
is still wet, the printer will be damaged. When drying the case, do not use a hair dryer,
heater, microwave oven, or the like.
❏ Do not use or store in high temperature places (60°C {140°F} or higher).
Use under the environmental conditions specified for the TM-P20 printer.
❏ Do not swing or throw the case around with the printer stored inside. The printer may
fly out from the case, causing injury.
❏ When taking care of the case, use water or a neutral detergent.
Storing the Printer
Printing in the Case
Cover
Flap
Belt strap
1. Remove the printer's belt clip. 2. Open the case cover.
3. Put the roll paper side on the bottom
and store the printer in the case.
4. Close the case cover.
1. Open the case cover. 2. Attach the flap to the cover
bottom, and close the case
cover.
3. Open the printer's paper
exit port to be able to
print.
© Seiko Epson Corporation 2014. All rights reserved.
Printed in China
!
❏
❏
❏
❏
© Seiko Epson Corporation 2014. All rights reserved.
Printed in China
/