Digital Door Viewer
User Manual
Outdoor unitIndoor unit
Battery bin
LCD display
Testing interface
Power Key
Outdoor Camera
Display screen 3.5’ LCD color screen, Resolution of 480*320
Image sensor 2.0 mega pixel camera resolution
Real viewing angle 120°real viewing angle
Supply power 4pcs AAA batteries
Door hole diameter 14-28mm
Door thickness 40-100mm
Indoor device size diameter:32mm
Outdoor device size 118x62mm
Pressing power button to display image, through the display screen to observe the scene outdoor, after 15s,
the unit will be off automatically.
1. Power on: pressing power button
2. Power off: power off automatically after power on 15s ; During power on status, pressing power button
3s to make power off,too.
1. Please make sure never pull the camera cable in case to break it.
2. The indoor monitor is connected with the outdoor camera by a cable, please press the cable connector
appropriately when connect it to the monitor and remove it with thumb and index finger instead of pulling
directly.
3. Please make sure the AAA battery pole is right when inserting it in case to damage the product chip.
Please don’t insert new and used battery together.
4. Please don’t press hardly on the LCD screen; Please don’t shake and shock the unit. It is not allowed to
use in the high temperature, high humidity, dusty conditions.
Step 1: Take out the screws bag and choose the suitable screws according to the door thickness, insert the screws
to the outdoor camera bracket, and lock the screws loosely using screw driver.
Step 2: Put the outdoor unit with screws into the door hole, Remove the bracket from the indoor unit, Pass the
outdoor unit cable through the up-hole of metal bracket, the screws from the down hole, Please make
sure the outdoor unit and indoor bracket in the right direction (up arrow means upward). Then, move the
metal bracket to the left and make the screws lock it, then, using screw driver to tighten screws again to fix
the metal bracket and outdoor unit firmly.
Step 3: Open the battery slot to insert the batteries according to the right instructed direction on the slot cover.
Step 5: The four slots on the back of the indoor unit is aligned with four projection on the mental bracket and
buckle up, then, pull down the unit to lock tightly.
Step 4: Connect the cable from outdoor unit to the connector of the indoor unit in right direction.
Step 6: Romove the protective film from indoor unit and outdoor unit surface.
Installation finished.
PRODUCT IMAGE AND PARTS
Technical specification
Function operations:
Installing Diagram and Instruction
Installation Caution
1. Indoor unit(monitor) 1 pc
2. Outdoor camera 1 pc
3. Screws 3 pairs
4. Mental bracket 1 pc
5. User manual 1 pc
Standard Package
Common Problems and treatment methods:
Question 1: The screen shows no picture or “sensor fail”
Solution:The problem is usually casued by the cable connector loose or shake,please power-off the device
and connect the cable again.
The cable is broken and damaged, please check the cable in good condition or not.
Question 2: The device can’t open or power-off automatically.
Solution: Please check whether the battery is in low power, and change new ones if needed.
Warranty terms and period
The whole unit guarantee one year for non-human factors lead to the fault and failure.
Picture is just for reference, goods in kind prevail, manufacture reserves the right to improve the appearance
and functionality and upgrades without notice.
1
2
3
4
1
2
4
3
4
