Product Information
Directional Antenna G-16
G-16
AEROSCOPE
2018.05
V1.4
1
EN
Disclaimer and Warning
Congratulations on purchasing your new DJI
TM
product. The information in this document
affects your safety and your legal rights and responsibilities. Read this entire document
carefully to ensure proper conguration before use. Failure to read and follow instructions
and warnings in this document may result in serious injury to yourself or others, damage
to your DJI product, or damage to other objects in the vicinity. This document and all other
collateral documents are subject to change at the sole discretion of DJI.
By using this product, you hereby signify that you have read this disclaimer and warning
carefully and that you understand and agree to abide by the terms and conditions herein.
You agree that you are solely responsible for your own conduct while using this product,
and for any consequences thereof. You agree to use this product only for purposes that
are proper and in accordance with all applicable laws, rules, and regulations, and all terms,
precautions, practices, policies and guidelines DJI has made and may make available.
DJI accepts no liability for damage, injury or any legal responsibility incurred directly or
indirectly from the use of this product. The user shall observe safe and lawful practices
including, but not limited to, those set forth in this document. Notwithstanding above, your
statutory rights under applicable national legislation are not affected by this disclaimer.
DJI is a trademark of SZ DJI TECHNOLOGY CO., LTD. (abbreviated as “DJI”) and its afliated
companies. Names of products, brands, etc., appearing in this document are trademarks
or registered trademarks of their respective owner companies. This product and document
are copyrighted by DJI with all rights reserved. No part of this product or document shall be
reproduced in any form without prior written consent of or authorization from DJI.
Product Prole
Introduction
The G-16 antenna is designed for the AEROSCOPE
TM
system and aims to provide 16
dBi* gain and 22.5-degree* coverage. The two types of antenna included, a 2.4 GHz and
5.8 GHz antenna, work on different frequency bands. An Aeroscope stationary unit can
connect up to four dual band antennas. A set of G-16 antennas consists of four 2.4 GHz
antennas and four 5.8 GHz antennas. A 5.8 GHz antenna can be connected to one 2.4
GHz antenna to act as a dual band antenna. Therefore, a set of G-16 antennas can be
congured with one stationary unit. Due to the narrow beamwidth of the G-16 antenna,
a set of G-16 antennas only has 90-degree coverage. For 360-degree coverage, four
Aeroscope stationary units and four sets of G-16 antennas can be combined.
* Refer to the Specications section for details.
2
In the Box
2.4 GHz High-gain Antenna × 4
5.8 GHz High-gain Antenna × 4
High-gain Antenna Mounting Bracket × 8
Antenna Cable (1.8 m) × 4
Antenna Cable (1 m) × 4
M4×13 Screw × 64
Overview
G-16 2.4 GHz Antenna
Connection to the 5.8 GHz
antenna IN port
Connection to the 2.4 GHz antenna
Connection to the Aeroscope
stationary unit
G-16 5.8 GHz Antenna
3
G-16 Antenna Installation
The gure below illustrates the G-16 antenna installation when attached to a pole.
The gure below illustrates the connections between antennas. Note that the 2.4 GHz
antenna connects to the 5.8 GHz antenna IN port via the antenna cable and the antenna
cable from the OUT port connects to the Aeroscope stationary unit (the stationary unit is
not shown in the gure).
High-gain Antenna
Mounting Bracket
4
G-16 Antenna Basic Features
The gures below show the 2.4 GHz and 5.8 GHz vertical and azimuth plane patterns.
G-16 2.4 GHz antenna
vertical plane pattern
G-16 2.4 GHz antenna
azimuth plane pattern
G-16 5.8 GHz antenna
vertical plane pattern
G-16 5.8 GHz antenna
azimuth plane pattern
0deg
270deg90deg
180deg
0deg
270deg90deg
180deg
0deg
270deg90deg
180deg
0deg
270deg90deg
180deg
5
Specications
2.4 GHz antenna 5.8 GHz antenna
Working Frequency (MHz) 2400 - 2500 5700 - 5850
Antenna Gain (dBi) 15.5 14
Beamwidth 30 28
VSWR (Voltage Standing-Wave Ratio) ≤ 2.0 ≤ 2.0
Input Impedance (Ohm) 50 50
Polarization Vertical Vertical
Diameter of Pole for Installation (mm) 120 (-10,+0) 120 (-10,+0)
JP
DJI
TM
DJI
DJI
DJI
DJI
DJI SZ DJI TECHNOLOGY CO., LTD. DJI
DJI DJI
6
G-16 AEROSCOPE
TM
16dBi* 22.5 *
2.4GHz 5.8GHz 2
Aeroscope 4
G-16 2.4GHz 4 5.8GHz
4 5.8GHz 1 2.4GHz 1
1 G-16
1 G-16
1 G-16 90 360
4 Aeroscope 4 G-16
*
2.4GHz 4
5.8 GHz 4
8
1.8m 4
1m 4
M4 13 64
G-16 2.4GHz
5.8GHz IN
7
2.4GHz
Aeroscope
G-16 5.8 GHz
G-16
G-16
8
2.4GHz 5.8GHz
IN OUT Aeroscope
G-16
2.4GHz 5.8GHz
G-16 2.4GHz
G-16 2.4GHz
0deg
270deg90deg
180deg
0deg
270deg90deg
180deg
9
G-16 5.8 GHz G-16 5.8 GHz
0deg
270deg90deg
180deg
0deg
270deg90deg
180deg
2.4GHz 5.8 GHz
MHz 2,400 2,500 5,700 5,850
dBi 15.5 14
30 28
VSWR ≤ 2.0 ≤ 2.0
50 50
mm 120 -10 +0 120 -10 +0
Compliance Information
FCC Compliance Notice
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
EU Compliance Statement: SZ DJI TECHNOLOGY CO., LTD. hereby declares that this device is in
compliance with the essential requirements and other relevant provisions of the Directive 2014/53/EU.
A copy of the EU Declaration of Conformity is available online at www.dji.com/euro-compliance
EU contact address: DJI GmbH, Industriestrasse 12, 97618, Niederlauer, Germany
Declaración de cumplimiento UE: SZ DJI TECHNOLOGY CO., LTD. por la presente declara que este
dispositivo cumple los requisitos básicos y el resto de provisiones relevantes de la Directiva 2014/53/EU.
Hay disponible online una copia de la Declaración de conformidad UE en
www.dji.com/euro-compliance
Dirección de contacto de la UE: DJI GmbH, Industriestrasse 12, 97618, Niederlauer, Germany
EU-verklaring van overeenstemming: SZ DJI TECHNOLOGY CO., LTD. verklaart hierbij dat dit apparaat
voldoet aan de essentiële vereisten en andere relevante bepalingen van Richtlijn 2014/53/EU.
De EU-verklaring van overeenstemming is online beschikbaar op www.dji.com/euro-compliance
Contactadres EU: DJI GmbH, Industriestrasse 12, 97618, Niederlauer, Germany
Declaração de conformidade da UE: A SZ DJI TECHNOLOGY CO., LTD. declara, através deste
documento, que este dispositivo está em conformidade com os requisitos essenciais e outras
disposições relevantes da Diretiva 2014/53/EU.
Existe uma cópia da Declaração de conformidade da UE disponível online em
www.dji.com/euro-compliance
Endereço de contacto na UE: DJI GmbH, Industriestrasse 12, 97618, Niederlauer, Germany
Dichiarazione di conformità UE: SZ DJI TECHNOLOGY CO., LTD. dichiara che il presente dispositivo
è conforme ai requisiti essenziali e alle altre disposizioni rilevanti della direttiva 2014/53/EU.
Una copia della dichiarazione di conformità UE è disponibile online all'indirizzo Web
www.dji.com/euro-compliance
Indirizzo di contatto UE: DJI GmbH, Industriestrasse 12, 97618, Niederlauer, Germany
Déclaration de conformité UE: Par la présente, SZ DJI TECHNOLOGY CO., LTD déclare que cet
appareil est conforme aux principales exigences et autres clauses pertinentes de la directive
européenne 2014/53/EU.
Une copie de la déclaration de conformité UE est disponible sur le site www.dji.com/euro-compliance
Adresse de contact pour l'UE : DJI GmbH, Industriestrasse 12, 97618, Niederlauer, Germany
YC.BZ.SS000207.03
EU-Compliance: Hiermit erklärt SZ DJI TECHNOLOGY CO., LTD., dass dieses Gerät den wesentlichen
Anforderungen und anderen einschlägigen Bestimmungen der EU-Richtlinie 2014/53/EU entspricht.
Eine Kopie der EU-Konformitätserklärung nden Sie online auf www.dji.com/euro-compliance.
Kontaktadresse innerhalb der EU: DJI GmbH, Industriestrasse 12, 97618, Niederlauer, Germany
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF
USED BATTERIES ACCORDING TO THE INSTRUCTIONS
Equipment intended only for installation in a RESTRICTED ACCESS LOCATION.
for PLUGGABLE EQUIPMENT, the socket-outlet shall be installed near the equipment
and shall be easily accessible.
Copyright © 2018 DJI All Rights Reserved.
Printed in China.
This content is subject to change.
Download the latest version from
https://www.dji.com/aeroscope
If you have any questions about this document, please contact DJI by
sending a message to
.
/