Sony CDX-L440B インストールガイド

タイプ
インストールガイド

このマニュアルも適しています

Parts Iist (1)
The numbers in the list are keyed to those in the
instructions.
Caution
Handle the bracket 1 carefully to avoid injuring
your fingers.
Cautions
This unit is designed for negative earth 12 V
DC operation only.
Do not get the wires under a screw, or caught
in moving parts (e.g. seat railing).
Before making connections, turn the car
ignition off to avoid short circuits.
Connect the yellow and red power input leads
only after all other leads have been connected.
Run all earth wires to a common earth
point.
Be sure to insulate any loose unconnected
wires with electrical tape for safety.
Notes on the power supply cord (yellow)
When connecting this unit in combination with
other stereo components, the connected car
circuit’s rating must be higher than the sum of
each component’s fuse.
When no car circuits are rated high enough,
connect the unit directly to the battery.
Connection example (2)
Notes (2-B)
• Be sure to connect the earth cord before
connecting the amplifier.
• If you connect an optional power amplifier and do
not use the built-in amplifier, the beep sound will
be deactivated.
Connection diagram (3)
1 To a metal surface of the car
First connect the black earth lead, then connect
the yellow and red power input leads.
2 To the power aerial control lead or power
supply lead of aerial booster amplifier
Notes
• It is not necessary to connect this lead if there
is no power aerial or aerial booster, or with a
manually-operated telescopic aerial.
• When your car has a built-in FM/AM aerial in
the rear/side glass, see “Notes on the control
and power supply leads.”
3 To AMP REMOTE IN of an optional power
amplifier
This connection is only for amplifiers. Connecting
any other system may damage the unit.
4 To the +12 V power terminal which is energised
in the accessory position of the ignition key
switch
Notes
• If there is no accessory position, connect to the
+12 V power (battery) terminal which is
energised at all times.
Be sure to connect the black earth to it first.
• When your car has a built-in FM/AM aerial in
the rear/side glass, see “Notes on the control
and power supply leads.”
5 To the +12 V power terminal which is energised
at all times
Be sure to connect the black earth to it first.
3-237-524-12 (2)
Installation/Connections
Sony Corporation © 2002 Printed in Korea
CDX-L460X
CDX-L440B
2
B
A
AUDIO OUT
TOP
1
FM/AM
Compact Disc
Player
1
12
TOP
× 4
3
45
67
× 2
8
Equipment used in illustrations (not supplied)
Front speaker
Rear speaker
Power amplifier
AUDIO OUT
REAR
L
R
3
from car aerial
1
4
5
2
AMP REM
ANT REM
RCA pin cord (not supplied)
Max. supply current 0.3 A
Max. supply current 0.1 A
Fuse (10 A)
Red
Yellow
Black
Blue
Blue/white striped
White
Green
Purple
White/black striped
Grey/black striped
Green/black striped
Purple/black striped
AUDIO OUT
Grey
1
1
2
2
3
1
2
3
4
5
3
Left
Right
Left
Right
TOP
Notes on the control and power supply leads
• The power aerial control lead (blue) supplies +12 V
DC when you turn on the tuner.
• When your car has built-in FM/AM aerial in the
rear/side glass, connect the power aerial control
lead (blue) or the accessory power input lead (red)
to the power terminal of the existing aerial
booster. For details, consult your dealer.
• A power aerial without relay box cannot be used
with this unit.
Memory hold connection
When the yellow power input lead is connected,
power will always be supplied to the memory circuit
even when the ignition key is turned off.
Notes on speaker connection
• Before connecting the speakers, turn the unit off.
• Use speakers with an impedance of 4 to 8 ohms,
and with adequate power handling capacities to
avoid its damage.
• Do not connect the speaker terminals to the car
chassis, or connect the terminals of the right
speakers with those of the left speaker.
• Do not connect the ground lead of this unit to the
negative (-) terminal of the speaker.
• Do not attempt to connect the speakers in parallel.
• Connect only passive speakers. Connecting active
speakers (with built-in amplifiers) to the speaker
terminals may damage the unit.
1
7
TOP
1 2 3
4
4
5
5
4
4
182 mm
53 mm
TOP
1
Bend these claws outward
for a tight fit, if necessary.
4
5
6
1
2
5
Fire wall
Dashboard
Ribs
with the ribs on bottom
1
3
5 A
to dashboard/center console
Bracket
Bracket
max. size
5 × 8 mm
B
max. size
5 × 8 mm
TOYOTA NISSAN
to dashboard/center console
Bracket
Bracket
max. size
5 × 8 mm
max. size
5 × 8 mm
Existing parts supplied with your car
Existing parts supplied with your car
with the TOP marking up
2
4
4
4
4
4
5
4
(OFF)
(OFF)
Precautions
Choose the installation location carefully so
that the unit will not interfere with normal
driving operations.
Avoid installing the unit in areas subject to
dust, dirt, excessive vibration, or high
temperatures, such as in direct sunlight or near
heater ducts.
Use only the supplied mounting hardware for
a safe and secure installation.
Mounting angle adjustment
Adjust the mounting angle to less than 60°.
Frequency select switch
The AM (FM) tuning interval is factory-set to the
9 k (50 k) position. If the frequency allocation
system of your country is based on 10 kHz
(200 kHz) interval, set the switch on the bottom
of the unit to the 10 k (200 k) position before
making connections.
Mounting example (4)
Installation in the dashboard
Mounting the unit in a Japanese
car (5)
You may not be able to install this unit in some
makes of Japanese cars. In such a case, consult
your Sony dealer.
Note
To prevent malfunction, install only with the
supplied screws 4.
Warning when installing in a car
without ACC (accessory)
position on the ignition key
switch
Be sure to press (OFF) on the unit for two
seconds to turn off the clock display after
turning off the engine.
When you press (OFF) only momentarily, the
clock display does not turn off and this causes
battery wear.
RESET button
When the installation and connections are
completed, be sure to press the reset button with
a ballpoint pen, etc.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Sony CDX-L440B インストールガイド

タイプ
インストールガイド
このマニュアルも適しています

他の言語で