9
en
Cleaning and care
Working
Detail images 6-11
■ Press release button and move swivel
arm to vertical position.
■ Cover unused drives with drive covers.
■ Remove the blender drive cover.
■ Put on attachment (arrow on the blade
holder points to arrow on the base unit)
and press downwards (detail image 8).
■ Turn attachment all the way anti- clock-
wise (dot on the blade holder points to
arrow on the base unit, detail image 9).
■ Insert the mains plug.
■ Turn rotary switch to setting M and
hold. The longer the appliance remains
switched on, the ner the ingredients
are cut.
In the case of herbs the required cutting
result can be achieved very quickly after
switching the appliance on. A brief “tap” on
setting M may be adequate.
Note: Recommendations on using the
accessories can be found in the section
“Recipes”.
Figure G shows guide values for the
maximum quantities and processing
times when working with the different
attachments.
After using the appliance
W Risk of injury from rotating drive!
Do not touch blender blades with bare
hands.
Detail images 12-17
■ Release rotary switch.
■ Remove mains plug.
■ Turn attachment clockwise and remove.
■ Turn the attachment over.
■ Loosen blade holder by turning it clock-
wise and remove.
■ Attach blade guard and press into place.
■ Place the lid on the container and
close (b).
Tip: Preferably clean the attachment
immediately after use. The blade insert can
be cleaned thoroughly by taking it out of the
blade holder (see “Cleaning and care”).
Cleaning and care
W Risk of injury from sharp blades!
When working with the blade insert (assem-
bly, disassembly, cleaning), always attach
the blade guard. Do not touch blade with
bare hands!
Warning!
Do not use abrasive cleaning agents.
Surfaces may be damaged.
Blade inserts, container and lid are
dishwasher-proof.
The blade insert can be cleaned thoroughly
by taking it out of the blade holder.
Fig. F
■ Turn the blade holder over (with blade
guard attached).
■ Press the blade insert out of the centre of
the blade holder.
■ To re-assemble, grip the blade insert by
the blade guard and insert into the blade
holder. Press it down into place.
Tip: To preclean the appliance, put a
little water and washing-up liquid in the
attachment immediately after use. Close
with blade holder and place on the food
processor. Switch on for a few seconds
(setting M). Pour out water and rinse parts
with fresh water.