2
参考指南
Reference Guide
HP LaserJet Tank MFP
260x series
简体中文
有关指示灯和错误的详细信息，请访
问 hp.com/support
1 仅限无线机型
打印机功能
1控制面板 5碳粉测量计
2扫描仪盖板 6重新灌注碳粉指示器
3碳粉检修门/出纸盒 7纸盘
4 出纸盒延长板 8 纸盒盖板
（仅限部分机型）
按钮和指示灯
6
57
8
1234
显示屏图标 Wi-Fi按钮/指示灯1
按下此按钮可开关 Wi-Fi。Wi-Fi 指示灯
用于指示状态。
Wi-Fi指示灯1
正在建立连接时闪烁。已连接后亮起。
警示指示灯
打开扫描仪盖指示灯
打开盖子并翻转身份证以复印第二面。
复印选项按钮/指示灯
开始复印按钮/指示灯
身份证复印按钮/指示灯
信息按钮/指示灯
按下即可打印打印机设置
和状态的摘要。
重新开始按钮/指示灯
亮起时按下即可继续完成作业。
取消按钮/指示灯
电源按钮/指示灯
正在启动或处理作业时闪烁。
无线警报1
Wi-Fi 已连接。重新启动设置模式。
以太网连接状态
Wi-Fi Direct 状态1
纸张问题
放入纸张/检查是否卡纸。
字符显示
份数、错误代码、对比度等级。参阅在
线使用手册。
份数指示器
变淡/变暗（对比度）图标
1
2
只有在端口指示器显示解锁
图标 时，才能添加碳粉。
有关更多信息，请参阅用户
指南，网址：hp.com/support
打印机在购买时已预灌注碳粉。 HP 碳粉重新灌注套件 (TRK) 提供 2 种选项：标准容量和大容量。
碳粉测量计上测量条的值为估算碳粉量，可能与实际碳粉量略有不同。
检查碳粉测量计指示器，确定何时添加碳粉。要购买 HP 原装碳粉包，请访问 hp.com/buy/supplies
或咨询当地的 HP 分销商。
检查碳粉余量
A
X
大容量 TRK标准 TRK
碳粉余量指示器状态
碳粉余量
极低时，
箭头呈琥
珀色闪烁。
碳粉
几乎装满
碳粉已部分
耗尽
碳粉余量低，但仍
可继续打印。
碳粉余量极低。
无法打印。
不能再
添加
碳粉
可加装 1 个
标准 TRK
可加装 1 个大容
量 TRK 或 2 个标准
TRK。
必须加装 1 个大容
量 TRK 或 2 个标准
TRK。
查看碳粉
余量
加装智能
闪充粉盒
(TRK)
1
2
简体中文
Wi-Fi 及连接帮助与提示
如果软件在设置过程中未能找到打印机，请检查以下情况以解决问题。
hp.com/support
帮助和支持
如需了解打印机故障排除相关信息和观看视
频，请访问 HP 支持网站。输入您的型号名
称以查找打印机。
本文信息如有更改，恕不另行通知。
潜在问题 解决方案
打印机 Wi-Fi 设置模式超时（无线指示灯未
闪烁）
如果“无线”指示灯未呈蓝色闪烁，则说明打印机
可能未进入 Wi-Fi 设置模式。重新启动设置模式：
1. 如果控制面板未点亮，请按下 退出
睡眠模式。
2. 按住 5 秒钟，然后在所有控制面板按钮亮
起后释放。
3. 同时按下 和 一次，然后释放这两个按
钮。等待一分钟，直至无线指示灯闪烁。
4. 关闭并重新打开 HP Smart，然后尝试重新连
接。
计算机或移动设备离打印机过远 将计算机或移动设备靠近打印机。设备可能已超出
打印机的 Wi-Fi 信号范围。
计算机已连接至虚拟专用网络 (VPN)
或远程工作网络
请先断开 VPN，然后再安装 HP Smart 软件。与 VPN
连接时，无法通过 Microsoft Store 安装应用。完成打
印机设置后再连接 VPN。
注意：在断开 VPN 连接之前，请考虑您的位置和
Wi-Fi 网络的安全性。
计算机上的 Wi-Fi 已关闭
（计算机通过以太网连接）
如果计算机通过以太网连接，请在设置打印机时开
启计算机的 Wi-Fi。暂时断开以太网电缆，以便通过
Wi-Fi 完成设置。
计算机或移动设备上的蓝牙
已关闭。
移动设备上的定位功能已关闭。
开启正在使用的设备的蓝牙，以完成设置。对于移
动设备，还应开启定位服务。蓝牙和定位功能有助
于软件找到您的网络和打印机。
注意：我们不会确定您的位置，设置过程中，也不
会将位置信息发送到 HP。
简体中文
3
For more information on lights and errors,
visit hp.com/support
1 Wireless model only
Printer features
1Control Panel 5Toner gauge
2Scanner lid 6Rell toner indicator
3Toner access door / Output tray 7Paper tray
4 Output tray extender 8 Tray cover
(some models only)
Button and lights
6
57
8
1234
Display icons
Wi-Fi button/light1
Press to turn on/o Wi-Fi. The Wi-Fi light
indicates the status.
Wi-Fi light1
Blinks when connecting. Lit when connected.
Attention light
Open Scanner Lid light
Open lid and turn over ID card to copy
second side.
Copy Options button/light
Start Copy button/light
ID Card Copy button/light
Information button/light
Press to print a summary of printer
settings and status.
Resume button/light
Press when lit to continue a job.
Cancel button/light
Power button/light
Blinks when starting or processing a job.
Wireless alert1
Wi-Fi is disconnected. Restart setup mode.
Ethernet connection status
Wi-Fi Direct status1
Paper problem
Load paper/check for jams.
Character display
Number of copies, error code, contrast
levels. See the online user guide.
Number of Copies indicator
Lighter/Darker (contrast) icon
English
4
English
Toner can be added only when
the port indicator shows an
unlock icon . For more
information, see the User Guide
at hp.com/support
The printer is pre-lled with toner at purchase. HP toner rell kits (TRK) are available in 2 options: Standard and High
capacity. The value of bars on the toner gauge are estimated toner levels and may vary slightly from the actual toner level.
Check the toner gauge indicator to determine when to add toner. Purchase original HP toner packs from
hp.com/buy/supplies or your local HP reseller.
Check toner level
A
X
High Capacity TRKStandard TRK
Toner level indicator states
Arrow blinks
amber when
the toner level
is very low.
Toner is
almost full
Toner is partly
depleted
Toner level is low,
but printing can
continue.
Toner level is very low.
Unable to print.
No more
toner must
be added
1 Standard TRK
can be added
1 High Capacity TRK
or 2 Standard TRK
can be added.
1 High Capacity TRK
or 2 Standard TRK
must be added.
View toner
level
Add toner
reload kit
(TRK)
1
2
5
Help and tips for Wi-Fi and connectivity
If the software is unable to nd your printer during setup, check the following conditions to resolve the issue.
Potential Issue Solution
Printer Wi-Fi setup mode timed out (Wireless
light not blinking)
If the Wireless light is not blinking blue, the printer might
not be in Wi-Fi setup mode. Restart setup mode:
1. If the control panel is not lit, press to exit sleep
mode.
2. Press and hold for 5 seconds, then release
onceall the control panel buttons light up.
3. Press and at the same time once and then
release the buttons. Wait for one minute until the
Wireless light blinks blue.
4. Close and reopen HPSmart and try connecting
again.
Computer or mobile device too far
from printer
Move your computer or mobile device closer to the
printer. Your device might be out of range of the
printer’s Wi-Fi signal.
Computer connected to a Virtual Private Network
(VPN) or remote work network
Disconnect from a VPN before installing HP Smart
software. You can’t install apps from the Microsoft Store
when connected to a VPN. Connect to the VPN again after
nishing printer setup.
Note: Consider your location and the security ofthe Wi-Fi
network before disconnecting froma VPN.
Wi-Fi turned o on computer
(computer connected by Ethernet)
If your computer is connected by Ethernet, turn on the
computer’s Wi-Fi while setting up the printer. Disconnect
the Ethernet cable temporarily to complete setup over
Wi-Fi.
Bluetooth is turned o on your computer
or mobile device
Location is turned o on your mobile device
Turn on Bluetooth for the device being used to complete
setup. For mobile devices, turn on Location services
also. Bluetooth and Location help the software nd your
network and printer.
Note: Your location is not being determined and no
location information is being sent to HP as part of the
setup process.
hp.com/support
Help and Support
For printer troubleshooting and videos, visit the
HPsupport site. Enter your model name to nd
the printer.
The information herein is subject to change without notice.
6
English
*381U5-90010*
*381U5-90010*
381U5-90010
© Copyright 2022 HP Development Company, L.P.
Microsoft and Windows are either registered trademarks or trademarks of Microsoft Corporation in the United States and/
or other countries. Mac, OS X, macOS, and AirPrint are trademarks of Apple Inc., registered in the U.S. and other countries.
Android is a trademarks of Google LLC. iOS is a trademark or registered trademark of Cisco in the U.S. and other countries
and is used under license.
Printed in Vietnam
越南印刷
EN
ZHCN
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
