TN0020A

Denso TN0020A ユーザーマニュアル

  • このチャットアシスタントは、TN0020Aカーオーディオの操作マニュアルの内容を理解しています。Bluetooth接続、ラジオ操作、音量調整など、デバイスに関するご質問にお答えします。マニュアルには、FCC規制に関する情報なども含まれていますので、お気軽にご質問ください。
  • 音量を上げるにはどうすれば良いですか?
    ラジオの選局方法は?
    Bluetooth機器を接続するにはどうすれば良いですか?
    DABラジオの受信範囲は?
Index                   
1-Rating
2-Button Function Spec
3-Radio operation procedure
4-Operating manual (Bluetooth/Handsfree)
5-FCC Operating manual Requirement 6P
Model name
Model No
Car Audio
TN0020A
Page
2P
3P
4P
5P
TN0020A
Operation Manual
DAB TUNING RANGE
174.928 - 239.200 MHz
1-Rating
FM TUNING RANGE
12.0V (10.5~16.0V) - ground
2.1mA or less
4.0A or less
(Vcc=13.2V, 0.5W output)
531 - 1602 kHz (9kHz step)
87.5 - 108 MHz (50kHz step)
AM TUNING RANGE
RATED VOLTAGE
LOAD IMPEDANCE
BACK UP CURRENT
RATED CURRENT
BACK Transition to previous screen
VOL DOWN Short Push: Decrease Volume Down 1 step
Long Push: Decrease Volume Down continuously
HOME Short Push: Transition to home screen
Long Push: AA/CP voice recognition
2-Button Function Spec
Button No. Button Name Operation
VOL UP Short Push: Increase Volume Up 1 step
Long Push: Increase Volume Up continuously
3
4
1
2
(ACC-ON)
3-Radio operation procedure
Press anywhere in
this area
Push this button
Push this button
(ACC-ON)
4-Operating manual (Bluetooth/Handsfree)
Push this button
Push this button
Push this button
Push this button
Push this button
CAUTION: Radio Frequency Radiation Exposure
This equipment complies with FCC radiation exposure limits set forth for uncontrolled
equipment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment has
very low levels of RF energy that is deemed to comply without maximum permissive exposure
evaluation (MPE). But it is desirable that it should be installed and operated with at least 20cm
and more between the radiator and person's body in normal use position.
Co-location: This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
5-FCC Operating manual Requirement
/