(Type A)
Index
1-Rating
2-Button Function Spec
3-Radio operation procedure
4-Operating manual (Bluetooth/Handsfree)
5-FCC Operating manual Requirement
6P
Model name
Model No
Car Audio
TN0035B
Page
2P
3P
4P
5P
TN0035B
Operation Manual
(1/6)
(Type A)
DAB TUNING RANGE
174.928 - 229.072 MHz
1-Rating
FM TUNING RANGE
12.0V (10.5～16.0V) - ground
4Ω
2.1mA or less
4.0Ａ or less
(Vcc=13.2V, 0.5W output)
531 - 1602 kHz (9kHz step)
87.5 - 108 MHz (100kHz step)
AM TUNING RANGE
RATED VOLTAGE
LOAD IMPEDANCE
BACK UP CURRENT
RATED CURRENT
(2/6)
(Type A)
■AUDIO controls
⑤
VOL UP
Short Push: Increase Volume Up 1 step
Long Push: Increase Volume Up continuously
④
VOL DOWN
Short Push: Decrease Volume Down 1 step
Long Push: Decrease Volume Down continuously
2-Button Function Spec
Button No.
Button Name
①
POWER
Audio ON/OFF
Operation
②
BACK
Transition to previous screen
③
HOME/TALK
Short Push: Transition to home screen
Long Push: AA/CP voice recognition
5
4
3
2
1
(3/6)
(Type A)
【操作手順】[Operation procedure]
①起動 (ACC-ON)
ACC-ON後、TOYOTA画面が表示された事を確認。
After the ACC-ON, confirm that Toyota screen is displayed.
②数秒後に"CAUTION"画面に遷移します。
The screen is changed to "CAUTION" screen after a few seconds.
*初回のACC-ON時はやや時間を要します。
Note: It takes a little longer for the first time of ACC-ON.
③数秒後に”Continue”ボタンを押して、MENU画面に遷移させます。
Press the "Continue" button on the face panel after a few seconds
to move MENU screen.
Menu Screen Display
④POWERボタンを押す。
画面内のラジオモードウィンドウを押すと、"FM1 "画面に遷移します。
Press the POWER button.
When the Radio Mode Window on the screen is pressed,"FM1" screen is displayed.
⑤下記画面に遷移したら、”<”釦 若しくは、”>”釦を押下してください。
これで、SEEKが始まります。
Confirm that the screen is changed as below,
Please push down the ”<”button or ”>”button.
This will start to SEEK.
※AM/DABモードも同様の手順です。
※Same as AM/DAB mode.
3-Radio operation procedure
Press anywhere in
this area
Push this button
Push this button
(4/6)
(Type A)
【操作手順】[Operation procedure]
①起動 (ACC-ON) ⑥画面の”Add Device”釦を押下してください。
ACC-ON後、TOYOTA画が表示された事を確認。 Please press the ”Add Device” button of the screen
After the ACC-ON, confirm that Toyota screen is displayed.
②数秒後に"CAUTION"画面に遷移します。
The screen is changed to "CAUTION" screen after a few seconds. ⑦画面の”Search Device”釦を押下してください。
*初回のACC-ON時はやや時間を要します。 Please press the ”Search Device” button of the screen
Note: It takes a little longer for the first time of ACC-ON.
③数秒後に”Continue”ボタンを押して、MENU画面に遷移させます。 ⑧下記画面に遷移したらBluetooth端末（iPhone、 iPodなど)をペアリング
Press the "Continue" button on the face panel after a few seconds
モードに設定してください｡
to move MENU screen.
Confirm if screen is changed as below,
Please set iPhone or iPod in pairing mode.
Menu Screen Display
④”Setting”ボタンを押して、SETTINGS画面に遷移させます。
Please press the "Setting" button on the face panel to move to Settings screen
※Displays when you have more than one pairing equipment
※複数のペアリング機器がある場合の表示
⑨接続したiPhone又はiPodを選択します。
Select the iPhone or iPod to connect.
⑤”Settings”画面に遷移することを確認し、画面上の"Bluetooth"釦を選択。
Confirm if ”Settings” screen is displayed, select the ”Bluetooth” button on the display.
※ 電話機の表示にしたがって操作してください
※ Operate the phone after the message on the screen
⑩完了すれば"Connection Completed"の画面になります｡
”Connection Completed” is displayed if completed.
4-Operating manual (Bluetooth/Handsfree)
Push this button
Push this button
Push this button
Push this button
Push this button
(5/6)
(Type A)
CAUTION: Radio Frequency Radiation Exposure
This equipment complies with FCC radiation exposure limits set forth for uncontrolled
equipment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment has
very low levels of RF energy that is deemed to comply without maximum permissive exposure
evaluation (MPE). But it is desirable that it should be installed and operated with at least 20cm
and more between the radiator and person's body in normal use position.
Co-location: This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
5-FCC Operating manual Requirement
(6/6)
-
1
-
2
-
3
-
4
-
5
-
6
