70mm
158mm
黑鲨潘通色 2420C
Kaiser FCC 日本版说明书
158*70mm 105G 无光铜
Tina
1.0
33050289A
文字单黑印刷，logo + 指示线条 专绿 2420C
封面
封底
33050289A_V1.0
Volume button Power button
Fingerprint lock
SIM card tray
3.5mm
earphones port
Gaming trigger
On/Off for
gaming trigger
Gaming trigger
On/Off for
gaming trigger
USB Type-C port
Thank you for choosing Black Shark 4 Pro
Press and hold the Power button to turn on the device.
Follow the on-screen instructions to configure the device.
Installation of SIM card
The Black Shark phone supports Dual SIM Dual Standby single-call. You can select
the default mobile data card or calling card as needed in Settings.
The SIM card in slot 1 or slot 2 supports 5G NR/TD LTE/FDD LTE/WCDMA/EVDO/
CDMA/GSM. If your phone has two SIM cards, only the mobile data card can
support CDMA service.
Note: Network support depends on the situations of carrier's network and related
services deployment.
Model Name: SHARK KSR-H0
Brand: BLACK SHARK
Adapter Model: MDY-13-EG-1
Dual SIM card management
1. Power off your device before installing the SIM card.
2. Insert the SIM ejector into the small hole on the SIM card tray. Press the ejector
firmly into the hole to push the SIM card tray out.
3. Place the SIM card correctly according to the label on the card tray, and use the
standard Nano SIM card in card slots 1 or 2. Non-standard cards may not be
recognized and could damage the card tray (slot).
4. Install the SIM card tray back into your device.
• Be careful not to scratch your device or hurt yourself when using the ejector.
• Store the SIM ejector out of the reach of children to prevent accidental
swallowing or injury.
• The SIM card cannot be bent, scratched, electrified, or wetted.
Ensure the used power adapters meet the requirements of Clause 2.5 in IEC 60950-1/ EN
60950-1 and has been tested and approved according to national or local standards.
E-label
This device has an electronic label for authentication information.
To view the label, choose Settings > About Phone > Certification, or enter
"Certification" in the search bar.
*Depends on the actual national or local requirements.
Important safety information
Operation and safety
Please read all the safety information below carefully before using your device.
Avoid hearing damage. Using the earphones at a high volume for a long time
may cause permanent hearing loss. To reduce this risk, keep the volume at a
safe and comfortable level.
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF
USED BATTERIES ACCORDING TO INSTRUCTIONS.
Use this device within the temperature range of 0°C ~ 35°C, and store this device and
its accessories within the temperature range of -20°C ~ 45°C. The device may be
damaged beyond the temperature range.
Keep your device dry.
Use only authorized accessories that are compatible with your device.
Charge this device only with the included or authorized cable and power adapter.
Using unauthorized cables, power adapters, or batteries can cause fire, explosions,
or other risks.
When charging the phone, place it in a room with normal temperature and good
ventilation.
Aer charging is complete, disconnect the adapter from both the device and the
power outlet. Do not charge the device for more than 12 hours.
Install the adapter near the device in an easily accessible position.
If your device is provided with a built-in battery, do not attempt to replace the
battery by yourself to avoid damaging the battery or the device.
Dispose of this device, the battery and accessories according to local regulations.
They should not be disposed of in normal household waste.
Do not disassemble, hit, crush, or burn the battery. In case of deformations, stop
using the battery immediately.
- Do not disassemble, hit, or crush the battery to avoid battery leaks, overheating, or
explosions.
- Do not short circuit the battery to avoid overheating, burns, or other personal
injuries.
- Do not place the battery in the high-temperature environments.
- Overheating may cause an explosion.
- Do not burn the battery to avoid fire or explosion.
- In case of deformation, stop using the battery immediately.
Do not try to repair the device by yourself. If any part of the device works improperly,
contact BLACK SHARK customer support or bring your device to our authorized
maintenance center.
Connect other devices according to their guide manuals. Do not connect
incompatible devices to this device.
Update your phone’s operating system using the built-in soware update feature, or
visit our authorized service outlets. Updating soware through other means may
damage the device or result in data loss, security issues, and other risks.
•
•
•
•
•
•
•
•
•
•
•
•
•
Safety precautions
Observe any laws and rules that restrict the use of mobile phones in specific cases and
environments.
Do not use your phone in petrol stations and potentially explosive including fueling areas,
boat deck bottom, fuel or chemical transfer or storage facilities, and areas where the air
contains chemicals or particles, such as grain, dust, or metal powders.
Obey all posted signs to turn off wireless devices such as your phone or other radio
equipment. Turn off your mobile phone or wireless device in a blasting area or in areas where
two-way radio equipment or electronic devices are required to be turned off to avoid
interference with blasting operations.
Do not use your phone in the hospital operating rooms, emergency rooms, or intensive care
units. Comply with the current rules and regulations of hospitals and health centers. Please
consult your doctor and the device manufacturer to determine if operation of your phone
may interfere with the operation of your medical device. To avoid potential interference with
the pacemaker. Keep the minimum spacing of 15cm between the mobile phone and the
pacemaker. To achieve this, use the phone on the opposite side to your pacemaker and do
not carry it in a breast pocket.
Do not use your phone near hearing aids, cochlear implants, etc. to avoid interference with
medical equipment.
Respect aircra safety regulations and use your device according to the instructions provided
aer you get on the aircra.
When driving a vehicle, use your phone in accordance with the relevant traffic laws and
regulations.
To avoid lightning strike, do not use your phone outdoors during thunderstorms.
Do not use your phone to make calls while it is charging.
Do not use your phones in places with high humidity, such as bathrooms. Otherwise, electric
shock, injury, fire, and charger damage may be caused.
•
•
•
•
•
•
•
•
•
•
For more information
Join us in the Black Shark community at https://global.blackshark.com.
Like us on Facebook at https://www.facebook.com/BlackSharkGlobal.
Follow us on Twitter at https://twitter.com/blckshrk_global.
Subscribe to us on YouTube at https://www.youtube.com/c/BlackSharkGlobal.
YouTube is a trademark of Google LLC.
For more information about warranty, visit https://global.blackshark.com.
Copyright © 2022 Blackshark Technologies (Nanchang) Co., Ltd. All Rights Reserved.
All illustrations in this guide are for your reference only. The actual device may
vary. If there is any inconsistency between this guide and the description on the
official website, please refer to the description on the official website. BLACK
SHARK may update this guide without prior notice. Changes will be incorporated
into new editions of this guide.
For DTS patents, see http://patents.dts.com. Manufactured under license from DTS Licensing
Limited. DTS, the Symbol, & DTS and the Symbol together, DTS:X, the DTS:X logo, and DTS:X
Ultra are registered trademarks or trademarks of DTS, Inc. in the United States and/or other
countries. © DTS, Inc. All Rights Reserved.
RF Exposure Information (SAR)
Black Shark Phone, Power Adapter, USB Type-C Cable, Logo Sticker,
Protective Case, SIM Ejector, Quick Start Guide
Contents
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FCC Regulatory Conformance
FCC Statement
The device is restricted to indoor use when operated in 5150MHz~5350MHz to
reduce the potential for interference.
5G WIFI statement
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device
types 5G Digital Mobile Phone (FCC ID: 2A2ZHKSR-H0) has also been tested against
this SAR limit. The highest SAR value reported under this standard during product
certification for use at the ear is 0.854 W/kg and when properly worn on the body is
0.269 W/kg. This device complies with RF specifications when used near your ear or
at a distance of 1.5cm from your body. Keep the device away from your body to
meet the distance requirement. Ensure that the use of belt clips, holsters and
similar accessories should not contain metallic components. The use of
accessories that do not satisfy these requirements may not comply with FCC RF
exposure requirements, and should be avoided.
FCC认证市场/日本市场共用说明书
