- 1 -
………………………………………………………………… ENGLISH ……………………………………………………………………
Thank you for choosing Delta DVP-SE. DVP-SE features both 12-point (8DI + 4DO) and
26-point (14DI + 12DO) in-built PLC MPUs, offering various instructions and with 16k steps
program memory, able to connect to all DVP Slim type series extension modules and
high-speed extension modules, including digital I/O (max. 480 I/O points) and analog modules
(for A/D, D/A conversion and temperature measurement). 2 points of 100 kHz and 2 points of 10
kHz high-speed pulse output satisfy all kinds of applications. DVP-SE is small in size, and can
be installed easily. Users do not have to install any batteries in DVP-SE series PLCs. The PLC
programs and the latched data are stored in the high-speed flash memories.
EN DVP-SE is an OPEN-TYPE device. It should be installed in a control cabinet free of
airborne dust, humidity, electric shock and vibration. To prevent non-maintenance staff
from operating DVP-SE, or to prevent an accident from damaging DVP-SE, the control
cabinet in which DVP-SE is installed should be equipped with a safeguard. For example,
the control cabinet in which DVP-SE is installed can be unlocked with a special tool or
key.
EN DO NOT connect AC power to any of I/O terminals, otherwise serious damage may occur.
Please check all wiring again before DVP-SE is powered up. After DVP-SE is
disconnected, Do NOT touch any terminals in a minute. Make sure that the ground
terminal on DVP-SE is correctly grounded in order to prevent electromagnetic
interference.
FR DVP-SE est un module OUVERT. Il doit être installé que dans une enceinte protectrice
(boitier, armoire, etc.) saine, dépourvue de poussière, d’humidité, de vibrations et hors
d’atteinte des chocs électriques. La protection doit éviter que les personnes non
habilitées à la maintenance puissent accéder à l’appareil (par exemple, une clé ou un
outil doivent être nécessaire pour ouvrir a protection).
FR Ne pas appliquer la tension secteur sur les bornes d’entrées/Sorties, ou l’appareil
DVP-SE pourra être endommagé. Merci de vérifier encore une fois le câblage avant la
mise sous tension du DVP-SE. Lors de la déconnection de l’appareil, ne pas toucher les
connecteurs dans la minute suivante. Vérifier que la terre est bien reliée au connecteur
de terre afin d’éviter toute interférence électromagnétique.
Product Profiles
12SE
13
14
15
[Figure 1a]
D VP-12SE
ss
-
1
2
34
5
6
7
9
8
8
10
11
12
3
12
16 37.4
90
60
3
Unit: mm
1. POWER, RUN, ERROR, COM1 indicator 9. Nameplate
2. RUN/STOP switch 10. Right-side extension port
3. COM1 port (Mini USB) 11. DIN rail mounting slot (35mm)
4. I/O terminals and COM3 comm. port (RS-485) 12. Extension unit clip
5. I/O point and COM2, COM3 indicator 13. COM2 communication port
(RS-485)
6. Ethernet communication port 14. Mounting rail for extension module
7. DIN rail clip 15. DC power input
8. Mounting hole for extension module 16. Left-side module connection port