Roland Fantom-G8 取扱説明書

タイプ
取扱説明書

このマニュアルも適しています

*5100006667 - 01*
* Staccato, Fall, and Doit cannot be used simultaneously.
The last specified one will take priority.
Press [ ]=Fall
Press [ ]=Staccato
[ ] [ ]
FOR FANTOM-G SERIES USERS
You need to know this to make your brass parts sound realistic!!
Control Assign 1 Settings
Operation Example
Complete Phrase
When you use the ARX-03 with the Fantom-G series, the following settings are made on the factory preset patches.
* This is based on the Fantom-G Series and the factory settings of the Single Mode’s [S1], [S2] switch, and the D BEAM
controller.
* In the Control Assign 1 screen, you can also adjust these settings for each patch.
Parameter Value
Staccato Controller Assign CC:01 (S1 Switch)
Fall Controller Assign CC:65 (S2 Switch)
Doit Controller Assign CC:02 (D BEAM ASSIGNABLE)
Unison/Stack Controller Assign CC:04 (FOOT PEDAL CTRL-2)
Normal
D BEAM controller=Doit
D BEAM controller
Copyright © 2009 ROLAND CORPORATION
All rights reserved. No part of this publication may be reproduced in any form without the written permission of
ROLAND CORPORATION.
*5100006667 - 01*
Articulation Guide
When you use the Fantom-G series with the ARX-03, you can play the ARX-03 patches by following the procedure below.
1. Turn on the power of the Fantom-G.
2. Press the [SINGLE] button to select the Single mode.
3. Press the [EXP 1] button to select the expansion board
(If the ARX-03 is installed to the EXP 1 slot).
How to Play the ARX-03 Patches
When you use the ARX-03 in the Live mode
1. Select the ARX-03 patch number from the Patch Number/Name of Fantom-G's part settings (1-1*).
2. Set the KBD Switch of the EXP1 part (1-1*) to "ON" (If the ARX-03 is installed to the EXP 1 slot).
You can play the sounds by following the procedures above.
* For details, refer to “Using the Live Play (Layer/Split) Screen” (p.61) in the Owner’s Manual.
  • Page 1 1
  • Page 2 2

Roland Fantom-G8 取扱説明書

タイプ
取扱説明書
このマニュアルも適しています

他の言語で