2. MINOURA
  3. SM-2229-2 / SM-2835-2 (Two (2) M5 thread holes)

MINOURA SM-2229-2 / SM-2835-2 (Two (2) M5 thread holes), SM-2229-2 / SM-2835-2 (Two (2) M5 thread holes) Instructions Manual

  • MINOURA Space-Mount SM-2229とSM-2835の取扱説明書の内容を読み終えました。このドキュメントでは、クイックリリース式アルミ製クランプの取り付け方法、使用方法、安全上の注意事項などが記載されています。このデバイスに関するご質問がありましたら、お気軽にお尋ねください。
  • レバーを閉じたときに適切な抵抗がない、またはきつすぎる場合はどうすればよいですか？
    側面のボルトがクランプ本体に完全に引き込まれていない場合はどうなりますか？
    このクランプはどのようなパイプ径に対応していますか？
Universal & adjustable quick-release type
light alloy clamping device (2-hole version)
MINOURA JAPAN
Made in Japan
1 2
Prior to clamping, roughly adjust
the jaws opening to the target
diameter by turning the side screw.
Wind the supplied plastic sheet
around the tube, close the jaw, then
hook the metal ring.
M5 thread hole (2 holes)
M5
Space-Mount SM-2229 2
instructions manual
3
4
Close the lever.
If you hear clicking sound and
you feel appropriate resistance
when closing the lever, it's OK.
If it's too tight or too loose, the
clamp jaws may be broken or an
serious accident may occur.
Release the clamp and adjust
the opening by turning the side
screw, then try clamping again.
When closing the lever, if
retracted into the clamp body,
clamping must be loose and
it will cause serious trouble
screw is completely retracted.
X
MINOURA CO.,LTD.
1197-1 Godo, Anpachi, Gifu
503-2305 Japan
[email protected]
MINOURA JAPAN
Made in Japan
1 2
Prior to clamping, roughly adjust
the jaws opening to the target
diameter by turning the side screw.
Wind the supplied plastic sheet
around the tube, close the jaw,
then hook the metal ring.
Space-Mount SM-2835 2
instructions manual
Universal & adjustable quick-release type
light alloy clamping device (2-hole version)
M5 thread hole (2 holes)
M5
3
4
Close the lever.
If you hear clicking sound and
you feel appropriate resistance
when closing the lever, it's OK.
If it's too tight or too loose, the
clamp jaws may be broken or an
serious accident may occur.
Release the clamp and adjust
the opening by turning the side
screw, then try clamping again.
When closing the lever, if
retracted into the clamp body,
clamping must be loose and
it will cause serious trouble
screw is completely retracted.
X
MINOURA CO.,LTD.
1197-1 Godo, Anpachi, Gifu
503-2305 Japan
[email protected]
/